Question about Cars & Trucks

1 Answer

2005 Chevy cobalt won't shift gears after removing

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 14,036 Answers

Could have something in the wrong place.

Posted on May 06, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
BelgianAlien
  • 50 Answers

SOURCE: my 2005 chevy cobalt factory radio is locked

There are only 2 things you can try to fix this yourself: turn off the engine and open the driver side door (to turn the radio off). Wait 5 minutes, start your car.
If that does not solve it, turn off your engine, disconnect the car battery, wait about 5 minutes. Reconnect the battery (negative pole first - black connector) and try your radio again.

If neither one of these two fix your problem, I am afraid only a GM service center or dealership can fix the problem. The Cobalt is notorious for all kinds of electrical issues.

Thanks for using the fixya forums!

Posted on Mar 28, 2009

soc21610k
  • 215 Answers

SOURCE: what and where is a fan relay on a 2005 chevy

The fan relay is something like a big fuse. You can find it in the fuse box under the hood. They usually cost about 20 bucks.

Posted on Jun 12, 2009

texastbone
  • 63 Answers

SOURCE: 2005 chevy cobalt, car wont start ... check

disconecting the battery should reset the pcm. but you will need to find out what caused the problems.

Posted on Jan 06, 2010

  • 478 Answers

SOURCE: 2005 Chevy Cobalt Power Steering manual

rack is bad

Posted on Feb 11, 2010

  • 115 Answers

SOURCE: rear brake drums wont come off 2005 chevrolet

make sure your parking brake is off first then if you take a hammer and hit the side of the drum while you tug on opposite side and do this all around it pulling evenly it will come off. hope this helps.

Posted on Sep 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is location of shift solenoid a located on 05 cobalt?


The shift solenoid valves are two identical, electronic exhaust valves that control upshifts and downshifts in all forward gear ranges. These valves are normally open. These shift solenoid valves work together in a combination of ON and OFF sequences in order to control the positions of the 1-2, 2-3, and 3-4 shift valve trains. The TCM monitors numerous inputs to determine the appropriate solenoid state combination and transmission gear for the vehicle operating conditions.
Remove the transmission side cover. Refer to Control Valve Body Cover Replacement . Remove the 1-2 shift solenoid retainer clip (304), the 1-2 shift solenoid (305) with O-ring (303), the 1-2 shift valve (302), and the 1-2 shift valve spring (301).
Remove the PNP switch. Refer to Park/Neutral Position Switch Replacement . Remove the transmission upper side cover bolts. Install the engine support fixture. Refer to Engine Support Fixture in Engine Mechanical. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information. Remove the left front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels. Remove the left inner fender liner. Refer to Front Fender Liner Replacement in Body Front End. Remove the wheel drive shaft from the transmission. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts. Remove the power steering gear mounting bolts. Refer to Steering Gear Replacement in Power Steering. Remove the frame. Refer to Frame Replacement in Frame and Underbody.
This is a tough repair an needs special tools to do it . your best bet is take it to AAMCO

Dec 04, 2015 | 2005 Chevrolet Cobalt

1 Answer

Chevy cobalt traction control light


Take it to a shop. Don't fool with it. It has to do with the traction control.

Oct 28, 2013 | 2005 Chevrolet Cobalt

1 Answer

Install a ELECTRIC POWER ASSIST SYSTEM on a 2007 chevy cobalt


Electric power assist is a recall on the cobalt. Take it to a Chevy dealership and they will replace it free of cost

Jan 23, 2013 | 2005 Chevrolet Cobalt

1 Answer

2005 chevy cobolt remote won't unlock car


open the remote and clean the contacts on the circuit board and the back side of the buttons also look at the tin tab that holds the battery they come apart from the board

Aug 27, 2012 | 2005 Chevrolet Cobalt

2 Answers

Was the ignition switch ever recalled on the 2009 chevy cobolt


No,
Recalls for
  1. STEERING:ELECTRIC POWER ASSIST SYSTEM. GENERAL MOTORS IS RECALLING CERTAIN MODEL YEAR 2005-2010 CHEVROLET COBALT AND MODEL YEAR 2007-2010 PONTIAC G5 VEHICLES EQUIPPED WITH ELECTRIC POWER STEERING. THE DRIVER MAY EXPERIENCE A SUDDEN LOSS OF POWER STEERING ASSIST THAT COULD OCCUR AT ANY TIME WHILE DRIVING.
  2. POWER TRAIN:AUTOMATIC TRANSMISSION:LEVER AND LINKAGE:COLUMN SHIFT. GENERAL MOTORS IS RECALLING 276,729 MY 2009 BUICK ENCLAVE, CHEVROLET COBALT, HHR, MALIBU, TRAVERSE, GMC ACADIA, PONTIAC G5, G6 AND SATURN AURA AND OUTLOOK PASSENGER VEHICLES. THESE VEHICLES FAIL TO COMPLY WITH FEDERAL MOTOR VEHICLES SAFETY STANDARD 102, "TRANSMISSION SHIFT POSITION SEQUENCE, STARTER INTERLOCK, AND TRANSMISSION BRAKING EFFECT", AND FMVSS 114, "THEFT PROTECTION AND ROLLAWAY PREVENTION". ON SOME OF THESE VEHICLES, THE TRANSMISSION SHIFT CABLE ADJUSTMENT CLIP MAY NOT BE FULLY ENGAGED. IF THE CLIP IS NOT FULLY ENGAGED, THE SHIFT LEVER AND THE ACTUAL POSITION OF THE TRANSMISSION GEAR MAY NOT MATCH. WITH THIS CONDITION, THE DRIVE COULD MOVE THE SHIFTER TO "PARK" AND REMOVE THE IGNITION KEY, BUT THE TRANSMISSION GEAR MAY NOT BE IN "PARK".
If you are having a problem with your ignition switch, repost question with full details.
j
Thanks for using FixYa!! I provide my answer for free as a public service - a 4 THUMBS rating and POSITIVE Comment is really appreciated for the FREE answering of your question.

Mar 11, 2011 | 2009 Chevrolet Cobalt

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

189 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...