Question about Cars & Trucks

Open Question

Where is the oil pressure sensor on seat ibiza 1.4 56 plate

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: seat ibiza 1.4 16v 02 plate cutting out at idle

I have the same car and had the same problem, it turned out to be a hole in the vaccume pipe that leads to the engine.

If thats not the reason It may be the ignition coil, which is a common fault in seat ibiza's, this would cost around 75.00GBP to fix.

this site may help www.usedcarexpert.co.uk ,, the site gives good info about all cars and lists common faults and how to fix them.

Hope this helps

Posted on Mar 29, 2009

Ad
  • 510 Answers

SOURCE: How to reset service light on a 58 plate Seat

Dealer would simply reset using diagnostic and charge you for it
Here is manual reset
Switch ignition off
Press and hold trip button left off speedo
Switch ignition on
Service will appear in display
Release trip button
Turn trip button to right untill [-] appears
Release trip button
Switch ignition off

Posted on Feb 03, 2010

alicantecoli
  • 22246 Answers

SOURCE: where are the min. and

little knotches unless someone has change the dipstick for a universal one as the plastic on the end broke off with use ,about this time they changed to one with a yellow plastic end on and perhaps its swimming in the sump

Posted on Apr 06, 2011

emissionwiz
  • 76846 Answers

SOURCE: seat ibiza cylinder head torque settings

I am sorry we have info on all USA models and some common eurozone models like VW, Audi etc. This is not a common make and we have no info on it. Sorry

Posted on Feb 19, 2012

emissionwiz
  • 76846 Answers

SOURCE: where is crank sensor on 1.2 seat ibiza

It will be on the lower right side of the engine block, very close to the gearbox

Posted on Jul 09, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2010 seat ibiza 1.6 sport sort of growling noise sometimes stoes for like 2 sec,s then starts again and stops when clutch pressed in.


indications are a failing throw out bearing for the clutch or clutch plate getting worn out AS the clutch plate lining wears , the pressure plate fingers come back closer to the throw out bearing causing it to spin
if you can make an adjustment on the slave cylinder push rod or clutch cable to give the bearing a nit more clearance the noise may not be there as it will not be spinning from the pressure plate fingers

Dec 16, 2016 | Cars & Trucks

1 Answer

Why does the oil light keep flashing and beeping?


the oil pressure sending unit may be not working or low on oil

Jul 26, 2015 | 2006 Seat Ibiza 1.4

1 Answer

Oil light flashing acasionly


Your problem shows me that your oil pump is starting to go bad. Don't wait long to have oil pressure checked and problem fixed. You don't want to ruin your engine. GOOD LUCK FRIEND.

Nov 23, 2014 | 2000 Seat Ibiza

1 Answer

Why does the clutch pedal on seat ibiza 1.9 diesl sink to floor


Cause the clutch pressure plate is worn out.

Jul 09, 2014 | 2000 Seat Ibiza

1 Answer

Seat ibiza (02-09) code 17961 how to fix


Manifold Pressure sensor (MAP sensor, probably located on the intake manifold somewhere) has an Implausible signal i.e. going out of a plausible range. you could try removing the connector and reseating it. I've seen this a few times where just reseating the connector fixes the problem, if not it'll probably need replacing.

May 08, 2014 | 2006 Seat Ibiza 1.4

2 Answers

How to reset service light on a 58 plate Seat Ibiza. Car has had full service and was not prepared to pay Seat dealer double but what they tell me is its a two second job, but will not tell me how to do...


Dealer would simply reset using diagnostic and charge you for it
Here is manual reset
Switch ignition off
Press and hold trip button left off speedo
Switch ignition on
Service will appear in display
Release trip button
Turn trip button to right untill [-] appears
Release trip button
Switch ignition off

Feb 03, 2010 | 2008 Volkswagen Jetta

1 Answer

Locking problems seat ibiza 2000 1.4s


How I fixed the central locking seat ibiza 2001

Sep 01, 2009 | 2000 Volkswagen Golf

3 Answers

Ive got a seat ibiza tdi r reg,the problem is my clock have stopped working speedo,temp,oil,rev,ect,ect can anyone help all the fuses seem too be ok.


lost track of R reg on uk plates remember having a E plate and it was a 1967 ford zodiac but if this is one of the newer models then firstly check the connection socket in the back of the unit if it appears ok then its dealer only ,you could have faulty earth to the unit or another problem and as this vehicle if its a newer model then its using encrypted software which is dealer only type job

Jun 16, 2009 | Volkswagen Golf Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...