Question about 2005 Acura RL
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: keyless remote
Entering the programming mode cancels all learned keyless remotes, so
none of the previously programmed remotes will work. You must reprogram
all of the keyless remotes once you are in the programming mode. You must complete each step within 4 seconds of the previous step to keep
the system from exiting the programming mode. You must program remotes
within 10 seconds of each other
1. Turn ignition switch to ON (II)
2. Within 4 seconds press the LOCK or UNOCK button on one of the remotes.
(An unprogrammed remote can be used for this step.)
3. Within 4 seconds turn ignition switch to LOCK (0) position
4. Within 4 seconds turn the ignition switch to ON (II)
5. Repeat steps 2, 3 and 4 two more times using the same keyless remote
used in step 2
6. Within 4 seconds press the LOCK or UNLOCK button on the same remote.
Make sure the power door locks cycle to confirm you are in programming
7. Within 10 seconds press the LOCK or UNLOCK button on same remote.
8. Within 10 seconds press the LOCK or UNLOCK button on all other
remotes you want to program. Make sure door locks cycle after you push
each remote button to confirm system has accepted the remote.
9. Turn the igniton switch to LOCK (0) to exit programming mode.
10. Test remote(s)
Posted on Dec 24, 2008
I have just purchased this car in the winter and found that the A/C was not blowing cold air. I am one month past warranty. I was told the same about the compressor not engaging. There is a charge as well and the Freon was drained and retested. Do yourself a favor....I have had the A/C clutch and Stator replaced, then the compressor, and now after $1000 (not including the charge of $1500 for compressor replace)I still have no A/C. It turns out that now the dealership has informed me that there is a blockage that cannot be blown free and the entire dashboard must be removed and a valve and the filter must be replaced. The blockage caused the clutch, stator, and the compressor to blow due to the Freon trying to be pushed through the blockage. The total cost to the job is $2,300 and the dealership ended up keeping my car for 1-1/2 weeks. Save yourself a lot of time and hopefully money and bring this to the attention of your repairman. Most of the time took them trying to isolate the problem. This sounds like a common occurance in the 2005 RL. I hope you have better luck than I did and hopefully save you some money.
Posted on Jun 13, 2009
SOURCE: 2005 Acura RL fob code reset?
turn key to on,but do not start,press and hold the lock button for one second,turn key to off position,turn the key on and off three times ending the cycle with the key in the on position,press the lock button,you will hear the door lock cycle,press lock again to set code.
Posted on Jun 20, 2010
Tips for a great answer:
Jul 28, 2015 | 2005 Acura TL
May 08, 2014 | 1997 Acura RL
Jan 04, 2014 | 2005 Acura RL
Jan 28, 2011 | 2005 Acura RL
Jan 06, 2011 | 2005 Acura RL
Jun 20, 2010 | 2005 Acura RL
Jan 30, 2010 | 1997 Acura RL
Mar 26, 2009 | 1998 Acura TL
261 people viewed this question
Usually answered in minutes!