Question about Subaru Cars & Trucks
The pinion shaft came out as I removed the drive axel, how do I replace it
The pinion shaft came out when removing axle? what is this, year,make model and which axle at the wheels or at the diff?
Posted on May 05, 2013
Testimonial: "I have an 02 Subaru outback and it came out of the diff"
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: ring and pinion adjustment
hello sir ...
RING AND PINION TOOTH CONTACT PATTERN.—The ring and pinion tooth contact pattern is used to double-check ring and pinion adjustment. To check the accuracy of your adjustments, coat the ring gear teeth with a thin coat of red lead, white grease, hydrated ferric oxide (yellow oxide or iron), or Prussian blue. Turn the ring gear one way and then the other to rub the teeth together, producing a contact pattern on the teeth. Carefully note the contact pattern that shows up on the teeth where the substance used has been wiped off. A good contact pattern is one located in the center of the gear teeth (fig. 5-21). Figure 5-21 shows several ring and pinion gear contact patterns. Study each and note the suggested correction for the faulty contact
Posted on Jul 06, 2008
you could try using a Quick boot, just cut the old one off with a trimming knife no stripping required,just wrap the quick boot around and use the weld adhesive fit new clips and the jobs done
Posted on Oct 28, 2008
SOURCE: 1995 jgc limited rear end noise
If you removed the pinion and only replaced one of the bearings that was a mistake. You need to replace both at the same time. Also since it is a Dana differential you should have replace the crush sleeve also as this set the correct preload on the pinion bearings.
Posted on Feb 07, 2009
TAKE TIRES OFF, REMOVE DIFF. COVER, ON 3rd MEMBER THERE A PIN ABOUT 11/2" DIA. THAT GOSE RIGHT THOUGH THE 3rd MEMBER CLOSE TO ONE OF THE ENDS OF THAT PIN OPOSIT OF RING GEAR THERES AN 8mm SMALL HEAD BOLT ( TURN RING GEAR TO CHECK OTHER END OF PIN ) REMOVE BOLT PUSH AXLE IN REMOVE HORSE SHOES CLIP IN 3rd MEMBER SLIDE AXLE OUT.
Posted on Nov 10, 2009
Tips for a great answer:
Jun 13, 2017 | Mitsubishi Cars & Trucks
Sep 06, 2014 | 2006 Jeep Liberty Renegade
May 18, 2011 | Ford Explorer Cars & Trucks
Mar 21, 2010 | 1998 Mercury Mountaineer
Mar 05, 2010 | Chevrolet Classic Cars & Trucks
Jan 30, 2010 | 1995 Jeep Grand Cherokee
Apr 10, 2009 | 2004 Ford GT
Feb 22, 2009 | 1999 Isuzu Rodeo
Feb 02, 2009 | 1995 Jeep Grand Cherokee
Jan 07, 2009 | 1987 Chevrolet Monte Carlo
98 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: