Question about 2006 Mini Cooper

1 Answer

P0715 Turbine speed sensor circuit A. Sets after clearing, data shows no glitches in signal and reads steady rpm value at idle and when off idle. No other codes. Circuit test seems waste of time seeing that data is correct. One thing I did notice was that engine rpm value is about 200 rpm lower than the turbine rpm value, idle reads about 750 on dash, turbine value reads same, engine rpm reads about 550. Not picking up any glitches while graphing the signal. When code sets shift hard into reverse and into drive.

Posted by on

  • David Lawhorn May 05, 2013

    codes sets at idle, not moving....and if this matters at all engine rpm is lower than turbine shaft measured rpm....I would think that if its slipping it would be the opposite.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Mini Master
  • 75,235 Answers

You may have a slipping torque converter clutch or worn bands. Contact a local transmission repair shop for further diagnoisis. The turbine speed sensors measure in and out speed of the main shaft, if a excess differance is seen then it will turn on the light and set the appropriate fault codes.

Posted on May 05, 2013

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3600 Answers

SOURCE: Service engine light

Your not going to here any knock from the engine the knock sensor detects detonation which is not detectable with the human ear. if you want to test the knock sensor you can tap the side of the block the engine should stumble for a couple of seconds if it does not change then the way the engine runs then the knock sensor is defective or hase buildup iside the engine and you will need to do a top engine clean. if you want instructions on how to do this just post another post to this reply This happens on engines that ave high mileage or acar that runs low grade like regular.

Posted on Apr 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have P0715 error code for my LS430. I have change the speed sensor but no luck. Same Error still apprear in diagnostic tool.


You changed input or output sensor ?
P0715 LEXUS - Input/Turbine Speed Sensor Circuit Malfunction

Read more: http://helpforcars.net/obd_codes/p0715_lexus.html#ixzz4Cg5vYyhg

You see it says Circuit Malfunction not sensor ! check the wiring

Jun 26, 2016 | Cars & Trucks

1 Answer

P0715


In the OB=2 codes system p0715 refers to the turbine shaft speed (TSS) sensor --circuit malfunction===causes --wiring --TSS--ECM/TCM (TCM is the transmission control module). It all refers to the turbine shaft in the torque converter

Jul 26, 2014 | 2000 Chrysler Concorde

1 Answer

Whats ford windstar error codes p0715 mean


I hope this helps and is what your looking for... good luck

http://www.fordobdcode.com/p0715-ford

Ford P0715 OBD-II Trouble Code Definition:
P0715 Input Shaft Speed Sensor Circuit Malfunction
P0715 Ford OBD-II Trouble CodeDescription:
OBD Trouble Code P0715 Input/Turbine Speed Sensor "A" Circuit What does the code mean? OBD-ii Code P0715 definition:
The input speed sensor detects the primary pulley revolution speed and sends a signal to the Transmission Control Module (TCM) and Engine Control Module (ECM). Symptoms Sumptoms of OBD code P0715
- Engine Light ON (or Service Engine Soon Warning Light) - Possible shifting problems Causes Causes of the OBD-II code P0715
- Transmission speed sensor circuit is open or shorted. - Poor transmission speed sensor circuit connection - Faulty transmission speed sensor The Error code is generally activated on detection of the following conditions: Diagnostic Trouble Code (DTC) P0715 is detected when TCM or ECM does not receive the proper signal from the sensor. Solutions

Jun 22, 2014 | 1999 Ford Windstar

1 Answer

How to fix P0715 and P0722 codes


Trouble codes are P0722 output speed sensor circuit no signal P0715 input turbine speed sensor A circuit

Apr 15, 2014 | 1998 Volkswagen Beetle

1 Answer

2000 galantwhat is codep0715


P0715 MITSUBISHI - Input/Turbine Speed Sensor Circuit Malfunctionpdf.gif? comments.gif ' Add Commentxicon.jpghttp://engine-codes.com/p0715_mitsubishi.htmlForum CodePossible causes - Transmission speed sensor circuit is open or shorted
- Transmission speed sensor circuit poor electrical connection
- Faulty transmission speed sensor
help.png Help with thisWhen is the code detected?Diagnostic Trouble Code (DTC) P0715 is detected when TCM or ECM does not receive the proper signal from the sensor.Symptoms- Engine Light ON (or Service Engine Soon Warning Light)
- Possible shifting problemsP0715 MITSUBISHI Description The input speed sensor detects the primary pulley revolution speed and sends a signal to the Transmission Control Module (TCM) and Engine Control Module (ECM).
Need more help?Do you need more help with the P0715 MITSUBISHI code? ask a question to our users or search the top hand picked automotive forums for more information

Read more: http://engine-codes.com/p0715_mitsubishi.html#ixzz2QYRb9Yyu
Follow us: EngineCodes on Facebook

Apr 14, 2013 | 2006 Honda Accord

1 Answer

Problem codes po0700 and po0715 on a dodge neon 2004, what needs to be fixed


Here's the cause for P0700 code.Here's the cause for code P0715,
  1. p0715 code (Input/Turbine speed sensor A Circuit malfunction).

Mar 21, 2013 | Cars & Trucks

2 Answers

P0715 turbine input shaft speed sensor circuit what that mean


P0715 MAZDA - Input Turbine Speed Sensor Circuit Malfunction.


xicon.jpghttp://engine-codes.com/p0715_mazda.htmlForum CodePossible causes- Transmission speed sensor circuit is open or shorted.
- Poor transmission speed sensor circuit connection
- Faulty transmission speed sensor When is the code detected?Diagnostic Trouble Code (DTC) P0715 is detected when TCM or ECM does not receive the proper signal from the sensor.

Jul 04, 2012 | 2001 Mazda Tribute

2 Answers

I have 2 falt numbers po715 and po420


P0420 - Catalyst System Efficiency Below Threshold (Bank 1)
P0715 - Input/Turbine Speed Sensor Circuit Malfunction

Dec 24, 2010 | 2000 Chevrolet Tracker

2 Answers

I HAVE A 2006 FORD FIVE HUNDRED AND A CODE P715 COME UP WHAT DOES THAT CODE MEAN


The P0715 tells you TCM detected a loss of TSS signal during operation. Insufficient input from the turbine shaft speed sensor.

Sep 22, 2010 | Ford Five Hundred Cars & Trucks

1 Answer

No acceleration code p0715 and p0720


P0715 Input/Turbine Speed Sensor Circuit Malfunction
P0720 Output Speed Sensor Circuit Malfunction

These codes are indicative of bad speed sensors.

Aug 04, 2009 | Kia Optima Cars & Trucks

Not finding what you are looking for?
2006 Mini Cooper Logo

265 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mini Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Mini Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...