Question about 2004 Mercury Mountaineer

1 Answer

Will not turn over

Just had timing fixed an now it will ot turn over just one click

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Contributor
  • 29 Answers

May need a new starter. Also try a air filter change.

Posted on May 06, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On 84 porsche 944 can the flywheel be spin around to ot without the camshaft spining since the camshaft is set to tdc.


crank shafts are set to tdc cam shafts are set for valve timing
if the crank shaft is turning but the cam shaft is not then the timing belt/chain has broken

May 01, 2016 | Porsche Cars & Trucks

2 Answers

My smart key will not turn in my ignition on my clk320 year 2000 battrey was flat but it as been charge up and tested


sounds like a bad key and needs to be replaced. you cannot take it out of park unitl the key is rotated.

Feb 28, 2015 | 2000 Mercedes-Benz CLK

1 Answer

2004 1.9 DCI MEGANE after replacing clutch she starts and runs but when i turn her off she wont start (turns over) makes no diff if its hot or cold engine go back later she starts any ideas please


wow hard to say maby you missed a minus cable or bad connection some times ot sensor this gives the impulse for spark timing start the car turn it off wont start?disconnect battery wait 10mins try again if it starts may be ot sensor ive also seen this problem with the onbord comp"

Nov 23, 2013 | 2004 Renault Megane 1.9

1 Answer

2002 ram 1500 periodically clicks a few times before starter engages, or spins over freely but won't fire. Fuel pump engaging & fuel present in rails. Wait a day or two & starts fine.


I suspect either the ignition module or crank sensor, find someone with a OBD2 sensor to read your codes, that will tell you, you may be able to rent one from oriely's ot Autozone. As for the clicking, check the battery and starter motor terminals to make sure they are clean and tight. good luck.

Oct 19, 2013 | Cars & Trucks

1 Answer

Can I replace my gas cap?


I think you may be overfilling your gas tank. If you do this, petrol can get down the vapour lines to the charcoal cannister under the hood causing it to become saturated. This in turn would set off the cannister purge sensor and cause the check engine light ot come on. Try filling your tank only to the first click-off.

Apr 20, 2010 | 2004 Honda Accord

1 Answer

I have a 1999 isuzu 4wd rodeo 6 cylinder and was wondering if Need to install a new boot kit or if I need to replace the entire front left cv axle shaft. I had a tear in my rubber boot and noted some...


Do not try to get the cv axle out ot the axle housing. It is a major operation. Remove boot and disconnect the inner cv joint and save about five hours of time. The choice is yours ,boot or reman cv axle. You will need to take the reman. axle apart to install it though and some new clamps. Not a simple operation.

Sep 28, 2009 | 1997 Isuzu Rodeo

2 Answers

Sometimes it starts, sometimes it needs to get hammered!


I think I'd replace the battery cables, starter solenoid, both inexpensive and dumb question... any chance starter has bad connection where it is bolted to block. If it's not getting a good clean connection it can lose continuity. Good luck.

Jul 01, 2009 | 1995 Ford F150 Styleside Regular Cab

1 Answer

Electrical


Ground wire problem under the dash board usually below the heater control unit - does not require removal of the dash.

Recommended tools:
- test light or "voltometer"
- FSM
- New clamps to ground the wire (possibly replacement wire)

time to fix problem:
- 2-3 hours (rough estimate)

Mar 16, 2009 | 1990 Nissan 300ZX

2 Answers

Coming home and engine stalled at stoplight. started back up drove home, it wanted to stall at every stoplight. When it almost stalls and you accelerate it sputters. it has 65k miles.


It sounds like the vacuum line has a hole if you stop at the light and you have to hold the gas down a little to keep it going that is one problem it could be.

Jul 28, 2008 | Acura CL Cars & Trucks

Not finding what you are looking for?
2004 Mercury Mountaineer Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

fordexpert

Level 3 Expert

5537 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...