Question about 2002 Kia Pregio

Open Question

Door chime turns on every time i drive downhill, made sudden stop and pass through humps. i check on all doors are locked.

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

tripletauto
  • 1450 Answers

SOURCE: power door locks

Seems you have a power lock switch see if there is one you can barely touch and make locks go off if so this will be your defective one

Posted on Aug 26, 2008

renselff
  • 75 Answers

SOURCE: I have just purchased a 2005 kia sedona from a mechanic. It's a nice car, but every time I'm driving down a road and step on the brake, the door locks unlock all the doors. The automatic door

it sounds like you may have a door switch going bad or in need to adjustment, the car thinks the door is ajar and then cycles the locks. the hard part may be to figure out which switch is making it act up.

Posted on Feb 25, 2012

airjer995
  • 5332 Answers

SOURCE: how do you stop door chimes from going off on a 2005 kia sorentor

Scan the body module to see what door is "open". Then check or replace that door switch.

Posted on Aug 07, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 ford escape chimes when driving


First be sure the turn signal is off, sometimes if you drive for some time with it on it will chime. Does the chime also continue from the time the car starts, even when it's not moving? If so, start the car in park, open a door at a time and press the switch on the door jam, if chime stops, the switch should be adjusted or replaced, if not continue with each door, one at a time being sure all the other doors are closed.

Jul 17, 2014 | Ford Escape Cars & Trucks

1 Answer

Reset passlock code


Is your Impala a 2000, 2001, or 2002? This seems to be a common problem in those model years...much like its predecessor the GM VATS (Vehicle Anti-Theft System). While the VATS had a permanent (albeit unapproved) solution, no suck workaround appears to be available for the Passlock system. Some websites offer a correction "module" that looks to be a hit-or-miss solution. I did find the following procedure on a forum, and it seems to be reliable. Here goes:
If your car has been sitting while you were at work or home or in the store, and you are coming out to leave, follow steps 1-6.

If you just had the SECURITY SYSTEM lock you out of the ignition system, you will have to wait the 10 minutes for it to reset and allow the ignition control module to interact with the system. Once the 10 minutes have passed from the ACTIVE SECURITY STATUS, follow steps 1-6. Do not try to shortcut this as it wont work.

If it is raining, you can close your door, just not all the way. Close it all the way and open the door latch without pushing the door open. This will keep you dry.

+++++STEPS+++++ 1.) OPEN YOUR DRIVERS DOOR AND SIT DOWN. 2.) PLACE KEY IN IGNITION, WAIT FOR CHIME. (3 seconds is what I usually wait) 3.) TURN IGNITION 1 CLICK RIGHT (TO THE ACC POSITION) AND STOP! Do not continue to ON and START yet. WAIT ATLEAST 5 SECONDS 4.) AFTER 5 seconds has passed, TURN KEY TO ON and STOP, DO NOT CONTINUE TO START YET! 5.) WAIT AND WATCH. With your drivers door open, here is what you will see and hear = Your notification will signal DOOR ADJAR, then the BATTERY light, then the SECURITY light, during which you will hear the chime sound as if you just started the car. 6.) AFTER YOU SEE THE SECURITY light switch back to DOOR ADJAR or Battery, and after the CHIME has stopped, you can turn the key to start and voila!

It has worked every time for me and 5 of my friends. This whole process takes about 20-30 seconds, but it sure as hell beats 30 minutes, as GM refuses to compensate my time lost to their vehicle\'s design flaws.

RECAP: 1.) Open driver door, sit down 2.) Insert key in ignition, wait for chime 3.) Once chime starts wait 3 seconds 4.) Turn key to ACC position WAIT atleast 5 seconds 5.) After 5 seconds turn key to the ON postion and wait for the security light to switch back to Battery or DOOR adjar, and the chime to stop (Do not try to START if the chime is still sounding) 6.) Once chime stops and Security light has passed, You may now complete the turn to START and it will start.

Note: This is not a permanent workaround, but it will buy you some time, I can almost guarantee it will work for most if not all people, almost all the time.



Oct 11, 2013 | Chevrolet Impala Cars & Trucks

1 Answer

2008 GMC Sierra pickup. Driving and all of a sudden it shut off then turned back on; the doors unlocked then locked again. Now it won't do anything. Checked the oil and it was empty - no oil at


Running with no oil is death for the motor ( Seized). When the alternator stopped working because the engine stopped the door lock control opened the door locks as it said you were below the required speed to have them locked

Mar 31, 2013 | 2008 GMC Sierra 1500

1 Answer

Replaced the battery in my keyless entry fob and now it does not work. What do I do?


HAS TO BE REPROGRAMED
Perform the following steps:

Sit in the vehicle driver's seat. (actually it's much ezr from the front pass seat)
Remove the ignition key from the ignition lock cylinder.
Close all of the vehicle's doors.
Remove the MALL PGM fuse from the fuse panel. Refer to Electronic Diagnosis in Body and Chassis.
Turn the ignition lock cylinder to the ACC position.
Turn the ignition lock cylinder OFF, then back to ACC within 1 second.
Open and then close any vehicle door. You will hear a chime when the remote control door lock receiver enters the programming/diagnostic mode. If you do not hear a chime, start again at step 1.

Important
After 7 seconds, you may hear a chime confirming successful synchronization. After approximately 14 seconds, you will hear a chime confirming successful programming.

Aug 05, 2011 | 2007 Pontiac Grand Prix GXP Sedan

1 Answer

Alreaddy did replace new batteries for key remote but the key remote is not working properly.. What cause is that?? do you know??


I know that this procedure work for Grand Prix and Monte Carlo, tesi it...

KEY FOB PROGRAMMING INSTRUCTIONS
Transmitter Programming
No Tools Required
In the event that a transmitter is lost, program the old and the new transmitters into the memory of the remote control door lock receiver. Up to 4 transmitters may be programmed.


Important
Once the keyless entry receiver enters the programming/diagnostic mode, the programming of the first transmitter erases all previous transmitter programming information. You must then program all of the transmitters.

Program only 1 vehicle remote control door lock receiver at a time. If you program multiple receivers simultaneously, the same transmitter could possibly be programmed to more than 1 remote control door lock receiver.


Perform the following steps:
Sit in the vehicle driver's seat. (actually it’s much ezr from the front pass seat)
Remove the ignition key from the ignition lock cylinder.
Close all of the vehicle's doors.
Remove the MALL PGM fuse from the fuse panel. Refer to Electronic Diagnosis in Body and Chassis.
Turn the ignition lock cylinder to the ACC position.
Turn the ignition lock cylinder OFF, then back to ACC within 1 second.
Open and then close any vehicle door. You will hear a chime when the remote control door lock receiver enters the programming/diagnostic mode. If you do not hear a chime, start again at step 1.

Important
After 7 seconds, you may hear a chime confirming successful synchronization. After approximately 14 seconds, you will hear a chime confirming successful programming.

Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds.
Repeat step 8 in order to program each additional transmitter.

Hope helps.

Jul 16, 2010 | 2001 Pontiac Grand Am SE

1 Answer

Location of door chimes module chimes wont stop and the aut door locks lock it back when i unlock it


one of the doors is not closed completely or...... the button is stuck in the depressed position. try each door one at a time, shut each firmly and check the result or................ look inside the door frame when the door is open to see if the button is popped out(there is a button that looks like a stem in the door jam towards the hinge end of the door). if you find one that is stuck (pushed in as if the door was closed) then pop it out with your finger or small screw driver and then lubricate it with a few drops of oil.

Feb 13, 2010 | 1998 Ford Taurus

1 Answer

1998 Taurus SE warning chime beeps as you get in the driver door


Hi John,

Had a similar problem with my Saturn. Door chime going all the time, the seat belts going up - down - up for no apparent reason.

Turned out to be the switch in the door jamb had become unseated. As it randomly made and broke contact, the cars computer thought the doors were opening and closing, then acted accordingly.

I remounted it with the help of a hot glue gun (plastic mount).

Hope this info helps with your problem.

Best regards
Mike

Aug 03, 2009 | 1996 Ford Taurus

1 Answer

Can't program keyless entry remote.


Try this, 
Transmitter Programming 
No Tools Required 
In the event that a transmitter is lost, program the old and the new transmitters into the memory of the remote control door lock receiver. Up to 4 transmitters may be programmed.

Important 
Once the keyless entry receiver enters the programming/diagnostic mode, the programming of the first transmitter erases all previous transmitter programming information. You must then program all of the transmitters.

Program only 1 vehicle remote control door lock receiver at a time. If you program multiple receivers simultaneously, the same transmitter could possibly be programmed to more than 1 remote control door lock receiver. 

Perform the following steps:
Sit in the vehicle driver's seat. (actually it’s much ezr from the front pass seat) 
Remove the ignition key from the ignition lock cylinder. 
Close all of the vehicle's doors. 
Remove the MALL PGM fuse from the fuse panel. Refer to Electronic Diagnosis in Body and Chassis. 
Turn the ignition lock cylinder to the ACC position. 
Turn the ignition lock cylinder OFF, then back to ACC within 1 second. 
Open and then close any vehicle door. You will hear a chime when the remote control door lock receiver enters the programming/diagnostic mode. If you do not hear a chime, start again at step 1.

Important 
After 7 seconds, you may hear a chime confirming successful synchronization. After approximately 14 seconds, you will hear a chime confirming successful programming. 

Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds. 
Repeat step 8 in order to program each additional transmitter. 
Remove the ignition key from the ignition lock cylinder. 
Install the MALL PGM fuse back into the fuse panel. Refer to Electrical Diagnosis in Body and Chassis. 
Validate that all the transmitters that were programmed operate properly.
Good luck and hope this helps. 

Jun 23, 2009 | 1995 Cadillac DeVille

1 Answer

When driving the vehicle the interior lights flash on and off the power locks flutter and the door ajar chimes.


Check the rear lift gate switch. Or it could be that one of the doors or the rear lift gate is out of adjustment and not closing tightly. Try closing all doors and lift gate then from the outside push in on the doors and see if they go in. If it is the doors , when you push on the one that is causing the problem the door ajar chime will stop .

Feb 19, 2009 | 1997 Plymouth Voyager

Not finding what you are looking for?
2002 Kia Pregio Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75005 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...