Question about Cars & Trucks

Open Question

How to remove a steering column in 97 buick lesabre

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

tonycdrive
  • 2 Answers

SOURCE: 1997 Buick Lesabre Water Pump problem

THE POWER STEERING PUMP PULLEY --- ARRGGH...Not a problem. The power steering pump is held by two bolts. Use a socket and remove the top bolt and loosen the bottom bolt. Be careful not to completely remove the bottom bolt. The PS pump will loosen up enough so that you can push it towards the firewall and you will JUST have enough room to remove the waterpump bolts. Its tight but it will squeeze out.

Posted on Dec 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to remove a steering column on a 95 Buick Lesabre and remove the steering column on a 92 Pontiac Bonneville to replace it with the on from the Lesabre


First remove bolt that attaches to the steering box it may have a rubber boot over it then undo shift linkage under the dash I can remember if there's 2 or four bolts take them off column drops down unhook electrical and pull out hope this helps

Jan 03, 2015 | Pontiac Cars & Trucks

1 Answer

Where is the ignition switch located on a 1996 Buick LeSabre custom


Removal & Installation

If the vehicle is not equipped with an air bag, skip Step 1 and simply disconnect the negative battery cable. Also, disregard all instructions below related to air bags.

  1. If equipped, disable the SIR system, as outlined in Section 6 of this manual.
  2. If not already done, disconnect the negative battery cable.
  3. Lower the steering column; be sure to properly support it.

c17hydro_11.gif

Exploded view of the steering column housing


  1. Position the switch in the OFF-UNLOCKED position. With the lock cylinder removed, the rod is in LOCK when it is in the next to the uppermost detent; OFF-UNLOCKED is 2 detents from the top.
  2. Remove both switch screws, then remove the switch assembly.

Nov 13, 2010 | 1996 Buick LeSabre

1 Answer

Have 1999 buick lesabre limited turn signals do not work . Have airbag and steering wheel removed but cant get past there help


if turn signal does not work, check the bulbs and the flasher. The flasher should be located under the dash near the steering column, but it's not necessary to take the steering wheel off unless the turn signal switch itself is bad.

Oct 29, 2010 | 1999 Buick LeSabre

1 Answer

1998 buick lesabre ignition wont turn back to shut car off need to pull the ignition from the steering column do i start with the steering wheel?


correct then remove screws for turn signal switch and compress the lock plate and remove that to access lock cylinder.

Apr 24, 2010 | 1998 Buick LeSabre

1 Answer

Can't find flasher on 1990 buick lesabre


A friend of mine restores cars and he said:

There are two different flashers.
1. The hazard lights should be found on the steering column.
2. The turn signal flashers should be found under the steering column to the left.

Hunnybunny11

Jan 23, 2010 | 1990 Buick LeSabre

1 Answer

Looking for a diagram of the steering column 1992 buick lesabre


64b989f.jpgHere's how Chilton has it wrote up,let me know if you need the drawing too.

Dec 18, 2009 | 1992 Buick LeSabre

1 Answer

Steering column is becoming loose on 1997 Buick Lesabre.


i dont think their is an adjustment under the sterring wheel. ive had mine apart to do a clockspring. the only nut under the air bag is to hold the steering wheel itself on the column, not to tighten the column itself. try looking under the dash for some studs and nuts holding the whole column itself. that should fix your problem. i dont recommend pulling the airbag and steering wheel for any reason. its very comlpicated under their and all the parts are expensive!

May 27, 2009 | 1997 Buick LeSabre

2 Answers

Ignition and key problems...


You have to use the lock cylinder and key from the original column, the keys have a small piece or resistive wire that the sensor in the column reads and if the wrong resistance value is read then the starter or fuel pump are locked out, your car came with a factory security system so don't know why another was added, but the reason above is the problem.

May 14, 2009 | 1997 Buick LeSabre

1 Answer

Steering column is becoming loose on 1988 Buick Lesabre


There are 3 bolts inside that have backed out, this is a tough job. You have to have special tools to complete this job. You have to pull the pins on the side after disassembling to access the bolts.

Feb 06, 2009 | 1988 Buick LeSabre

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...