Question about Cars & Trucks

1 Answer

2005 buick lesabre

Replaced frontstruts now alignment off was fine before

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 45,628 Answers

The top of the front struts is the adjustment for the wheel alignment. The bolts are off set so that if you lower the top block and turn the bolts around 1 set of holes you alter the alignment. Most cars have a bolt painted on the end with a corresponding dot painted on the guard. When the 2 are together that would be the original alignment.

Posted on May 04, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 106 Answers

SOURCE: 2000 buick lesabre - water pump replacement

first disconnect the battery then check how the serpentine belt is lined up so u can take it off and put back on. Then the pump should be on the side of the motor with 9or12 bolts there could be more! after taking out take razorblad and skrap the old gasket clean wipe of then put new gasket and pump back on dont over tighten the screws cuase the pump my be aluminum.

Posted on Mar 19, 2009

honeymokey
  • 3113 Answers

SOURCE: how do i replace the turn signal on the taillight

unscrew tailight from inside trunk. Pull out and replace bulb. Read owners manual.

Posted on Jun 14, 2009

emissionwiz
  • 76848 Answers

SOURCE: cost to replace 1991 Buick LeSabre fuel line

the fuel line must be made from scratch so about 2 hours labor, or $200

Posted on Jun 20, 2009

  • 205 Answers

SOURCE: where is the blower motor located on a 2005 buick

remove the glove box insert it's right behind it

Posted on Oct 16, 2009

  • 491 Answers

SOURCE: Just changed my oil on a 2005 Buick Lesabre. The

Most common reset is....... turn on the key (do not start) and depress gas pedal 3 times in 5 seconds.
Remove floor mat to do this.
It should be reset.
You may have to repeat this....it does always take on the first try.

2nd common......push mileage reset until oil life shows......once showing hold button down until 100% oil life shows.

You may have one or the other.

Posted on Nov 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Help


You have to get a new alignment after replacing suspension parts-that's normal.

May 04, 2013 | 2005 Buick LeSabre

1 Answer

How to install a ignition module buick lesabre V6 3800


1A Auto shows you how to remove, install, repair, or replace your broken misfiring or damaged ignition coil. This video is applicable to Buick LeSabre 2000-2005.

Nov 03, 2012 | 2001 Buick LeSabre

1 Answer

2005 Buick LeSabre tachometer not responding when engine is running. Tachometer stays on "0" when enige is running. Slight movement as acceleration increases; however needle barely moves as...


2005 BUICK LESABRE TACHOMETER DOES NOT REGISTER WHEN ENGINE IS RUNNING. SOMETIMES IT BARELY MOVES, THEN GOES BACK TO 0
SAME CAR HAD SPEEDOMETER QUIT, REPLACED WITH NEW SENSOR, DROVE ABOUT 1300 MILES AND IT QUIT AGAIN. CLEANED THE SENSOR, WORKS OK NOW.

Oct 30, 2010 | 2005 Buick LeSabre

2 Answers

Chassis lubrication points


There are no grease fittings on your Buick. Most manufactures started using sealed joints in the early to mid 90s. If a joint is making noise it will have to be replaced.

Jun 13, 2010 | 2005 Buick LeSabre

1 Answer

How do i replace the turn signal on the taillight of a 2005 buick lesabre


unscrew tailight from inside trunk. Pull out and replace bulb. Read owners manual.

Jun 14, 2009 | 2005 Buick LeSabre

1 Answer

Need instructions for replacing 94 Buick LeSabre window module.


2002 BUICK LESABRE REAR DRIVER SIDE DOOR POWER WINDOW UP CABLE IS OFF TRACK WINDOW WILL NOT STAY UP HOW CAN I REPAIR THAT

Dec 29, 2008 | 2005 Buick LeSabre

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...