Question about 2005 Mazda Tribute

1 Answer

Removing rear interior panals - 2005 Mazda Tribute

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Mazda Master
  • 575 Answers

Remove one Phillips screw from leading edge of door panel (near latch). Remove small cap behind the door handle, inside another Phillips screw - remove screw and then the cup behind the handle. Look down in arm rest and there is another Phillips screw. Last screw is behind the approximately 1 1/2 inch plug on front upper corner of panel. At this point, gently pry around lower edge and sides - there are either five or six clips pressed into the door frame. Once all are disengaged, gently swing the bottom of the panel out and lift off the top edge of door next to window opening. Once panel is off door, gently remove the control plug from the door lock/window control on the rear of panel. Install in reverse order
hope this helps

Posted on May 06, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 pacifica ac/heat works sometimes, back vents blow always but not heated or cooled air


take it to a shop i could fix it but its not for a dyi person unles your comfterbl removing interior panals

Feb 06, 2014 | 2004 Chrysler Pacifica

2 Answers

How to remove ford taurus window switch


Door Panels

Print


REMOVAL & INSTALLATION

See Figures 1 through 8
This procedure applies to both the front and rear door panels.


0900c152802604e4.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 1: Remove the cover from behind the inside door handle by gently pulling it out to release the retaining tabs


0900c152802604e5.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 2: Remove the pull cup retaining screw cover and...


0900c152802604e6.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 3: ... remove the retaining screw from the cup and lift the cup straight up out of the door panel


0900c152802604e7.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 4: Remove the two sail panel/speaker grille retaining screws and...


0900c1528026022f.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 5: ... remove the panel/grille from the door


0900c152802604e8.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 6: The door panel is retained to the door by 11 retaining clips


0900c152802604e9.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 7: Carefully lift the door panel off of the door and...


0900c152802604ea.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 8: ... detach the electrical connectors from the switches and remove the panel from the vehicle

  1. Remove the cover behind the inside door handle.
  2. Remove the screw from the bottom of the pull cup retaining the front door trim panel to the front door.
  3. Remove the two screws retaining the sail panel/speaker grille assembly and remove the panel/grille from the door.
  4. Remove the three screws retaining the front door trim panel to the front door.

Do not attempt to remove more than one pushpin at a time.
  1. Use a suitable tool to remove the pushpins from the door.
  2. Carefully lift the door panel away from the door.
  3. Detach the electrical connectors as necessary and remove the panel from the door.

To install:
  1. Installation is the reverse of removal.

Aug 15, 2012 | 1998 Ford Taurus

1 Answer

1999 Chevrolet Silverado power windows, How do you remove drivers side door panel


not really sure on that one but on most first you will need to remove screw around handle that opens the door that needs to be removed. also should be screws underneth handle that pulls door shut that you will have to remove and in some cases . check around edge of door panal for more screws and if found remove them also. once all screws are removed you will need to pry on door panal slightly because there are clips behind panal holding it on. in alot of cases the clips break when removing panal but dont worry the can be bought at your local auto parts store and are very easy to replace. I usually use something flat like a small stiff putty knife to help pry door panal lose. this helps insure that you dont break of crack the panal. after all clips are off simply unplug wire connections and door handle linkage and your done. .....hope this helps and good luck

Aug 13, 2012 | 1999 Chevrolet Silverado 1500

1 Answer

How repair the_driver's_side_exterior_door_handle_on_a_1998_Toyota_Tercel


You need to remove the interior trim panal from the door . Then you can get at it from the inside it might be rivited but likely there will be two nuts that hold it on the door skin you just need to disconnect the mechisum that will pop off and mabey that is your problem . Then i would go to a junk yard if its broken there like 5 dollars or so

Apr 03, 2011 | Toyota Tercel Cars & Trucks

1 Answer

How to replace a window on a 2002 saturn sl2 with power windows. i cant get the door handle assembly off


As per the Haynes manual for your vehicle.
DOOR WINDOW GLASS-REMOVAL AND INSTALLATION:
1. Remove the door outer panal.
2. Lower the window glass.
3. remove the two nuts and one screw securing the glass.
4. Remove the glass by lifting it up carefully and rotating it inward.
5. Installation is reversal of removal.

DOOR OUTER PANAL-REMOVAL AND INSTALLATION:
1. Remove door trim panal.
2. Remove the outside mirror. Remove the foam block from the mirror opening.
3. Remove the outside door handle.
4. Open the door and pry thhe outer sealing strip out of the window glass opening.
5. remove the door panal screws.
6. Detach the front and rear of the outer panel, then lift it toward the rear to remove it.
7. Installation is the reverse of the removal procedure. Apply thread locking compound to the panel retaining screws.

OUTSIDE DOOR HANDLE-REMOVAL:
1. Pull handle out and puch the centers of the retaining pins through the pins, then remove them and detach handle. (These pins are located underneath the handle.

Hope this helps, let me know if you need any other help.

Feb 06, 2010 | 2002 Saturn L-Series

1 Answer

2000 2wd Dakota Quad cab, right rear door latch


Sounds like either a linkage rod came off or the interior handle is broken. either way you have to take the interrior door panal off to see which it is.

Oct 09, 2009 | 1991 Dodge Dakota

1 Answer

How to remove rear door panal for 03 cts


If you have power windows start by disconnecting your negative battery cable. Then you need to locate and remove the screws that hold your interior door handles in place (they may be hidden by snap in, or snap on clips). Once you remove the screws that hold the door handles, remove any wire connectors to the handles, if they're not power you will need a small hook (kinda like a knitting needle) to remove the window crank. A manual window crank is held in place by a clip on the base. Slide the hook behind the base and remove the clip. The door panel itself, is held on by snap in clips, and you will need a small pry bar to pull them from the door (try to get as close to, or directly under the clips to prevent them from tearing out of the door panel). Once the clips are removed from the door, pull the panel upward to remove it from the door.

Install in reverse.

I hope this helps you, and I wish you luck on your repair.

May 10, 2009 | Cadillac CTS Cars & Trucks

1 Answer

2005 Lincoln Aviator. Replace busted speaker third row seat??


the sub panal doesnt come off seperate you will break it if you try and you will need to remove the whole side panal its e-z afer the panals removed good luck and remember dont force or pull to hard

Mar 19, 2009 | 2004 Lincoln Aviator

Not finding what you are looking for?
2005 Mazda Tribute Logo

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7689 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...