Question about Cars & Trucks

Open Question

Loosing plenty gearbox oil via gearbox breather .Why?

Bantam has Rocam engine.Also where is the filler and drain plug please.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 958 Answers

SOURCE: 98 mirage manual gearbox where is ,filler and drain plugs

raise your car. make sure you have jack stand and use them before you crawl underneath.

go under your transmission and look for a hexagonal nut or plug at the very bottom of the transmission or gear box.
that is the drain plug. it is very tight , i warn you.

then after you drain all the oil, replace it and tighten it too.

then look for almost the same size of bolt at the side of the transmission or gear box.

this is the fill hole and at the same time the full hole plug.
if the new oil that you are putting in is already over flowing out of the hole, put back the plug right away because that is the full level already.

you can use a hose that would fit just through the hole and insert it to your new gear oil. then let it pass trough gravity towards the gear box.

tnx 4 using fixya,

drcool

Posted on Oct 04, 2008

Ad
alicantecoli
  • 22219 Answers

SOURCE: kia rio gearbox oil filler location? 1.3 2004 manual

half way-level- on front or side of gearbox,think its on the fifth gear housing behind wheel arch on this model ,round plug with a square drive in centre

Posted on Nov 29, 2008

onyeredson
  • 404 Answers

SOURCE: Oil leak

Hello Pierre,
A little more detail may help me on this one, however this sounds like possibly your power steering pipe? both these use auto trans fluid it is reddy brown in colour and viscosity (Thickness) watery.
If this is the pipe, check the fluid reservoir it should have either a Yellow top with power steering or a steering wheel diagram on it.
If full then please give me more information as to location on engine where pipe comes from and goes too as nowadays engine oil is usually internally dispersed. Only oil cooler pipes possibly? will go to a finned type radiator usually near the front grille of the vehicle.
I hope this points you in the right direction as I'm thinking of giving this help up as very hard to remain on top slot when loads of questions responded to and no replies.
Good Luck,
Paul 'W'
Onyer~EDson(:0) {#><U.K.

Posted on Jan 18, 2009

pcastal
  • 90 Answers

SOURCE: RAV4 Gearbox oil drain plug?

in the front? They are in the most god awful tightest place to get to. its a 24mm drain plug and you cant fit anything in there, very difficult. I can show instruction, but I hope you have a lift.

Posted on Jan 25, 2009

citroenchris
  • 600 Answers

SOURCE: wheres the filler plug on the expert

put the van on full lock to the left, look under the L/H wheel arch in front of the wheel, just in front of the drive shaft you will see a tin cover held on by 13mm headed bolts, on the back row the tin is cut away a little way up is a bigger bolt head (maybe 16mm) that is the fill plug.

Posted on Feb 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where are the speed sensor situated on a Ford Bantam 1.6 rocam


It is plugged into the transmission where the speedo cable would go in older cars.

Jun 22, 2016 | 2008 Ford Bantam 1.6i

3 Answers

What type of GEARBOX OIL is recommended for my ford bantam 1.6 petrol rocam engine 2009 model? it has 200 000 kilos on


Castrol SMX-X would be a good oil for a gearbox with that amount of mileage and is a ford recommended oil

Jun 26, 2015 | Ford Cars & Trucks

1 Answer

Will a 1.6 Ford Bantam Rocam motor fit onto a 1.3 Ford Bantam Rocam gearbox, and is the engine mounting brackets the same


same engine, same year only difference is bore size so there is every chance that it will fit.

Jan 25, 2015 | Ford Cars & Trucks

1 Answer

2010 Peugeot 207 gearbox drain/filler/level bungs


The drain plug is situated on the final drive casing at the rear of the transmission (plug may need a square or hex drive wrench).

There is no level plug - the correct qty of oil must be measured and then poured in.
If Petrol 1.9 ltrs, diesel 2.0.

The oil is 75/80w.

Jan 19, 2014 | 2008 Peugeot 207 CC

1 Answer

Ford bantam rocam engine recommended oil


Any multipurpose engine oil should do. Just be careful with synthetic oil.

Apr 04, 2013 | 2007 Ford Bantam 1.3i

1 Answer

Is it just open drain plug and refill or is there aproblem of air pockets the tranny is 4x4 with transfer box in same housing


there is no need to blead air from the gearbox or transfer, or diff's
first the transfer and gearbox are together but use their own oils and are changed seperatly
remove the drain plug to drain, refit then refill through the filler flug, the correct level is thesame as the filler so when starts draining from the filler hole its full. car needs to be level/flat ground when doing this.
if its auto there will be a tube for checking the level, at the back of the engine under the bonnet. auto trans oil does need the engine running to check for correct level.
remove drain plug with the engine off, refill approx same amount of oil in to the dipstick tube, then start the engine, select each gear for a couple of secconds then back to neutral, check level with engine still running. adjust level if needed.

Mar 25, 2011 | Nissan NV2500 Cars & Trucks

1 Answer

WHERE IS THE FILLER PLUG ON THE GEARBOX ON A 1998 PASSAT TDI PLEASE


Hi,

Just checking.... it is a manual gearbox?

You may need a special tool for the drain plug and a 17mm allen key for the filler (some use the special drain tool for the filler as well)

The drain plug is located under the diff housing.

The filler plug is located on the left (nearside) off the gearbox (look to the left of the hole and you can see the 17mm hex filler bung).

Check you can undo the filler bung, then drain the gearbox oil.

Refit drain bung and fill gearbox through filler/level ********* until gearbox oil is up to the level of the filler bung.

Refit, test drive, check for leaks and retest level again when cold.

Cheers,

"If this has helped you in any way, please rate this solution" :-)

Jan 27, 2010 | 1998 Volkswagen Passat

1 Answer

What gearbox oil for 1992 K reg Mitsubishi colt


IT IS SEPERATE FROM ENGINE THERE IS A FILLER BOLT AT FRONT OF BOX DRAIN PLUG IS AT THE BOTTOM NEAR THE OUT UT SHAFTS DRAIN IT AND REFILL WITH A SYNTHETIC CASTROL AUTO TRANS FLUID THIS WILL IMPROVE YOU GEAR SHIFTS

Sep 10, 2009 | Mitsubishi Colt Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

187 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...