Question about Jeep Cherokee
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I had all my analog instrument panel gauges stop working after they did the state emissions test. I found the proper fuse in the fuse block located under the hood. Simply unplugged the fuse, noticed it was still good, and plugged the same fuse (10A) back in and all the gauges started working again. Guess it needed a reset atfer they plugged in for the emissions.
Posted on Aug 14, 2009
Well, theres a sending unit/float in the tank that sends a signal thru
wires to your instrument cluster's fuel gauge. You should have an auto
electric repairperson determine where your problem lies. It's not often
the needle's just 'stuck' to where you could dislodge it. More often,
it's pegged overfull or underempty-signaling a shorted component
upstream of the gauge.
Similar problem and found the solution:
In the back of the gauge, where the 2 coils are located, there are very tiny copper wires which connect all the resistors/diodes. they each travel from within the coil and are soldered to 3 out of the 4 mounting pins. if any of these wires are shorting out or disconnected, the gauge will malfunction.
- take the gauge and flip upside down
- temp gauge has 1 resistor (blue) and 1 diode (copper)
- fuel gauge has 2 resistors, no diodes
- 1 wire should be attached to bottom mounting pin (letter E for EMPTY)
- 1 wire should be attached to pin holding both resistors (half tank)
- 1 wire should be attached to the stand-alone ground pin (no mounting bracket)
Hope that helps!
Posted on Oct 19, 2009
SOURCE: instrument cluster problems
my 1998 cadillac deville information display cluster goes on and off for days at a time. most times I do not know how fast I am going or miles.
Posted on Dec 27, 2009
SOURCE: Instrument cluster not working
if its not a fuse. try a relay. itll be under the hood in a little box. if thats not it than it could be a short in the wiring.check your running lights as well. most of the time they are ran on the same fuse so if one doesnt work the other one probably wont. also if you have recently replaced your stereo. check over the wiring on it because something could have got loose.
Posted on Feb 23, 2010
Tips for a great answer:
Aug 25, 2010 | 2005 Chevrolet Impala
Aug 07, 2010 | 2002 Chevrolet Silverado
Jul 15, 2010 | 2005 GMC Sierra
Dec 08, 2009 | 2004 Cadillac Escalade Esv
Nov 03, 2009 | 1998 Oldsmobile Intrigue
Jul 16, 2009 | 2000 Ford Windstar
Jun 14, 2009 | 2005 Chevrolet TrailBlazer
Apr 03, 2009 | 2004 Scion xB
Dec 30, 2008 | 2005 Chevrolet Cavalier
13 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: