If my gas censer is stuck how can I get it unstuck

spray some wd40 up under the lower part. may loosen it up enough to get it off. otherwise buy a new one and destroy the old one getting it off

the good news its most likely a stuck Censer the bad news its in the fuel tank. may be a bad wire between tank and gauge but censers go out more often than not

It may be destroyed now...

Sounds like fuel injectors or injector are open. Take each one out and replace or clean them.

did you check the gas filter or fuel pump? That would be my first thing before all the other stuff you did. make sure it is getting fuel.

Do you have a warning light on? If so get the trouble codes read.

Idol control censer / throttle position censer You might need a new one

P1404 - Exhaust Gas Recirculation (EGR) Closed Position Performance The egr valve is stuck possibly due to carbon buildup. It may be possible to remove the egr valve and clean it with throttle body cleaner or induction cleaner.If the pintle can not be unstuck then the valve egr will probably need replaced.

If your transmission doesn’t shift out of first gear or shifts hard at too high a R.P.M. this doesn’t always mean you have a problem. This could be a stuck throttle valve caused by a small piece of trash. This sometimes happens after a rebuild. Sometimes the throttle valve can be unstuck without removing the valve body. Get up to about 20 to 30 M.P.H. and hit the gas pedal on and off hard with your foot. This might do the job. If that doesn’t work remove the throttle valve cable end from the throttle, with the motor at idle in park, pull the cable in and out very fast, this might work, if not the valve body must be removed by a transmission shop to be unstuck.

Also check the governor for a stuck valve, weights or governor drive gear damage.

Usually when they get stuck you can`t get them unstuck unless they are just twisted.seat belts are not repairable.Your best bet is to go to the salvage yard and get a used one and replace it.