Question about Cars & Trucks

Open Question

Club car intellitrac schematic

Front wheel drive. rear wheels do not engage. How to test?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: hummer h2 transfer case

Only way for this to happen on an H2 (AWD) is for something to break rearward of the lockup hub. Take a look at the splines between the intermediate shaft and centerdifferential or even the teeth on the forward sun gear and/or stepped pinion on the center diff.

As long as you have the t-case torn down for repair be sure to upgrade to the new aluminum mode fork (production upgrade to old plastic forks thru end of 2007 or so). You should also upgrade the rear half of the housing to the 2008 version which has a pressed-in rear prop bushing (better bushing and is also replaceable.

Posted on Sep 30, 2008

Ad
  • 10 Answers

SOURCE: 4 WHEEL DRIVE DONT WORK

first off your heater dial swithc is buggered. and as for the four wheel drive is it all electric diff locks or do you have to get out and lock hubs in etc?

Posted on Dec 23, 2008

  • 84 Answers

SOURCE: 95 Legacy Ls Wagon all-wheel drive does not work.

Check the awd fuse first, if this is ok then it is likely to be in the transmission the awd section is seperate to the rest of the trans, it has its own solonoid pack which can be a problem. Take to a trans specialist for an accurate diagnosis if the fuse is ok. If the fuse is missing come back to me for further info

Posted on Dec 24, 2008

  • 109 Answers

SOURCE: subaru legacy wagon

This problem is usually caused when the transfer solenoid/valve assembly goes bad, it's located in the transmission extension housing & needs to be replaced. it can be done without removing the transmission.

Posted on Jan 08, 2009

  • 1 Answer

SOURCE: my 4 wheel drive won't engage

Sportages uses a vacuum system to lock front hubs - turn the wheels all the way to one side, then look from behind the wheel on the side you are turning 'from" There should be a rubber hose from the vacuum fitting near the wheel opening from the engine compartment to the wheel itself. If these are damages or disconnected, the front axles will engage into 4wd but the hubs will not lock and the front wheels will not be driven by the axles.

Posted on Mar 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rear wheels not engaging what can I do to troubleshoot the awd?


awd drive cars have a differential action between front and rear wheels and there should be a switch that allows you to lock up that action for adverse conditions
if the rear wheels are not working , it is because there is no drive action to the front wheels ( front wheels spinning or broken drive shaft to the front)
all wheel drive means that in normal driving when there is traction on all 4 wheels that the power is transmitted evenly to all 4 wheels
It is not 4 wheel drive where power is applied to both axles or in the event of one axle loosing traction the other axle still drives

Dec 15, 2015 | 2007 Lincoln MKZ AWD

2 Answers

Jeep won't go into four wheel drive? 4wd light is coming on but is not engaging


no year car.
no model jeep stated.
now 4wd option stated (
command trac, Select track. quadra-trac/drive?,)
or if unknown what transfer case is there (tag on rear says)

the front axle have the vacuum valve on it.
does it work, the vacuum servo ( test it?)
if no vac. servo there, that is the newer jeeps.

is this your jeep?




25789533-zxkm0porkezcwmeeta050dfy-2-0.jpg

Jul 19, 2015 | Jeep Cars & Trucks

1 Answer

My rear differential is broken and i would like to engage my front wheels so i can just drive with them. the car is headed for the junk yard im just trying to get a few more weeks out of it. it has smart...


what you are describing can't be done-unless-no -the rear drive shaft will still drive the rear wheels-smart track ain't so smart. you could drop the rear drive shaft out but then you'd leak trany fluid all out the tailshaft-why not pick up rear end at the junkyard and install-cheers Denny

Oct 31, 2013 | 1999 Oldsmobile Bravada

1 Answer

Not a problem as much as an answer. Are both wheels rear wheels engaged at all times on my 4x4 87 ranger?


this is a rear wheel drive vehicle and as such the rear wheels are always engaged.when in 4 wheel drive the transfer case in gages and the front differential connects and is engaged.unless the 4 wheel drive is engaged the transfer case just free wheels.

Apr 27, 2011 | 1987 Ford Ranger

1 Answer

1987 dokota appears to go in four wheel drive but all wheels do not pull or move when stuck in snow or mud.


Technically you do not have 4 wheel drive, you have two wheel drive (possibly three-wheel drive). When you engage 4WD you direct power to the front and rear differentials. The front differential is an open style which means that only one wheel will drive, and the rear differential is likely the same type which means that you will only have two wheels driving the vehicle (one front, one rear). If the rear differential is a "posi-trac" or "limited-slip", then both axles should lock and drive the vehicle (hence, three-wheel drive), but this style differential is not as common as it once was.

Feb 07, 2011 | 1987 Dodge Dakota

1 Answer

FRONT WHEELS DONT ENGAGE IN 4X4


As this car IS a FRONT wheel drive, that is switchable to four wheel drive (it switches off at 21 mph)if when you switch to 4wd and your fronts have no drive,the drive automatically goes to the wheels with traction(rear)try putting the rears on wet grass and see if you move when you hit the gas........hard.

Sep 22, 2010 | 2000 Kia Sportage

1 Answer

Is the 1999 honda passport a front wheel or rear wheel drive vehicle when the 4WD is not engaged?


Rear. In Europe was on sales until 2003 (last line made) by OPEL as frontera. Equipped mostly with 2.2 Turbo diesel engines, rear wheeler, ability to engage 4WD, under motion up to 60MPH, having automatic front diff locks, and despite the bad critics about crash tests and behaviour, well sold. Still on the roads.

Aug 19, 2010 | 1999 Honda Passport

3 Answers

4x4 front end not engaging


my computer problem is hard disk system found warantty hard disk

Feb 24, 2010 | 2006 Ford F-150

1 Answer

When do I need to service my 4WD on my 2006 dakota


If its in 4WD thats normal. On hard, dry, pavement its binding up because the front wheels and the rear wheels are turning at different speeds.

Nov 25, 2009 | 2002 Dodge Dakota Club Cab

1 Answer

Front wheel will not engage for 4 wheel drive


very possible. Put your jeep on 4 jackstands and put in 4 wheel drive. if the front drive shaft turns pull the vacuum disconnect and check the shift fork. They usually break before the shift actuator.

Jun 28, 2008 | 1992 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

242 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...