Question about 2005 Dodge Magnum

Open Question

Air blend door actuator

Driver side blows semi cold air while passenger side blows warm/hot air it is not a dual air control unit could the air blend door actuator be the issue

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

alicantecoli
  • 22095 Answers

SOURCE: passenger side blows hot air when front control set to Air

you cant adjust it ,this requires the dealers computer to re set it,or a phyiscal control has packed up like a vacumn pipe has split where it pushes onto the valve that controls the flap in the heater unit.

Posted on Apr 26, 2009

Molson02536
  • 3854 Answers

SOURCE: 2004 Dodge Ram 2500 air conditioning

It sounds like your electronic vent actuator has gone bad, it's common to go bad and may need to be replaced. There are tinny gears that wear out and the vent actuator stops working. You can try this, turn the radio off first so you don't have to enter the reset code to activate your radio. Disconnect the battery for 30 seconds and reconnect it, if the actuator has lost it's base line and stuck in the open heat position, this will reset it, just make sure the setting is to cold and off before disconnecting and reconnecting the battery. If this does not work, then it's a bad actuator and Auto Zone should have the part you need and will have the step by step instructions for you to the job you self, I believe the dealer is a $415,00 repair cost for this. Good luck and keep me posted. 

Posted on Jun 22, 2009

  • 217 Answers

SOURCE: 2002 Dodge Ram pickup heater and defroster blows

sounds like it could be a mode door actuator problem which directs the flow of air in the heater case,

Posted on Mar 21, 2010

  • 20 Answers

SOURCE: air conditioning blows cold on drivers side but

dodge has dual blend door actuators on the air box. you have to pull the dash board assembly out to access the passenger side door actuator. it calls for 5.8 hours to do this job. you also have to evacuate and recharge the ac system.

Posted on Jul 19, 2010

johnjohn2
  • 5763 Answers

SOURCE: I think I have a blend door problem just not sure

this unit is eclectric, it uses actuator motors to control the blend doors and selector doors, you are correct its a blend door problem, if you look under the dash on the passengerside there will be a motor mid way, thats the blend door actuator and theres another on the driverside. you what pass/side. move your controls to pin point the right one,hope this helps.

Posted on Sep 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Air conditioning system, when you turn on the air conditioner the drivers side blows cold air and the passengers side blows hot air? What causes this problem?


The most common cause of this is that you have a stuck air temperature control blend door, this can be a motor actuator issue or a jammed door or both (common). To replace both parts you will need to completely remove the dash from the car to access the blend door.

Jul 02, 2016 | 2010 Ford Flex Limited

2 Answers

Location of blend door actuator on 2001 Buick Regal


driver side actuator for blend door is electric servo controlled. It could be jammed or computer sending it in wrong direction. Unit is located on driver side of heater case.

Jun 03, 2014 | 2001 Buick Regal

1 Answer

My passenger side is blowing warm air


Sound like you have a blend door actuator that had stopped working. You have cold AC on the drivers side but not the passenger side? Your car has dual zone climate control where you can adjust either side independently. If you have cold air when you ask for it and hot air when you ask for it then the overall system is working properly, it is just that one side is not moving the blend door between the heater core and the evaporator core. Either you have something inside of the hater box that is keeping the door from moving or that hte motor that is suppose to move the door has quit.

Apr 21, 2013 | 2004 Lincoln LS

1 Answer

2003 chevy trailblazer blows cold air on passenger side and hot air on driver side


Sounds like a blend door actuator failure,11_24_2012_3_52_06_am.jpgMight as well replace both sides

Nov 24, 2012 | Cars & Trucks

2 Answers

The heater blows out cold air on pass. side. Warm air on drivers side


Your car is equipped with "Dual Climate Control". Make sure that the temperature control for the passenger side is turned to the "Hot" position. If it is already at the hot position and still blowing cold air, then you most likely have a failed passenger blend-air door motor or a broken passenger blend-air door.

The motor can be replaced with very little labor (a little over 2 hours) but if the door is broken, you are talking about major surgery...total dash removal....about 8 hours of labor.

Dec 18, 2010 | 1996 Buick Park Avenue

1 Answer

Dual control a/c problems


you are having a problem with the blend door actuator on drivers side it is stuck. try placing both in cold position and unhooking battery for a few minutes then hook back up and crank truck up this will trigger the actuators to relaern and sometimes can cause actuator to start working afain

Jun 02, 2010 | 2003 Chevrolet Suburban 1500

4 Answers

The heater in my 2003 Dodge Ram 4x4 will not heat up or gets only luke warm & only on the passenger side....any suggestions?


Cold on drivers side and heat on passengers side, actuators working properly and blend doors are moving. Heatertreater is for piece of plastic on actuator motor. I moved blend door by hand after disconnecting actuator and works fine, both sides freezing when moved in opposite direction.

Dec 04, 2009 | 2004 Dodge Ram 1500

1 Answer

Passenger side only blowing cold air.


You need to replace the "blend" door actuator motor on the pass side. I recommend getting that from your nearest gm dealer to ensure proper fit. When you adjust the air from cold to warm to hot, the blend door moves to direct the right amount of cold, or warm, or hot air your desire on that side of the vehicle

Dec 04, 2009 | 2000 Buick Regal

2 Answers

2004 chevy avalanche with dual control system problem


this problem is caused in almost all cases by a failed actuator that moves the door insiode the heating/ac duct to change the outlet temperature, it is called the Air Temperature Control Blend Door actuator.

Oct 05, 2009 | 2004 GMC Envoy

1 Answer

Climate control panel


These problems are usually caused by a faulty blend door actuator which controls the position of the air mixing door, and in vehicles with more than one air zone (passenger/driver, front/rear, etc.) there will be a door/actuator for each. These electric blend door actuators are self-calibrating - there is a feedback circuit (wiper type potentiometer) that tells your HVAC control the position of the door. It is not unusual for this potentiometer to wear causing loss of signal at various positions, which then will cause erratic movements of the door (if the circuit fails to open circuit or shorting, the door will default to fully open or closed - i.e. hot or cold air only).

Mar 28, 2017 | 2004 Chevrolet Suburban

Not finding what you are looking for?
2005 Dodge Magnum Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...