Question about Cars & Trucks

Open Question

John deere s1400

Starts and idles, stalls out when throttle is opened.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: engine idles and starts ok but stalls out whenn u give it throttle

If the fuel filter does not work, it may be the AIR CONTROL VALVE BOARD which is part of the electronic fuel ignition. I am going through this right now, and found that the "new" ones cost $600 and the used ones are $200, but when you get a used one, you take your chances, so ask for a money back guarantee from the mechanic, or their pledge to put in another one at no additional charge if the first one you get is a bad one the first time, because they are all 20 years old now...

Posted on Jun 06, 2009

Ad
Wood Chuck
  • 29 Answers

SOURCE: 1995 CHEVY VAN 20 305 WONT IDLE

Check your fuel pump presure. Pump is in the tank. Also try and loosen the fuel cap, the tank vent may be stopped up.

Posted on Sep 15, 2009

johnjohn2
  • 5763 Answers

SOURCE: 04 Jeep starts but stalls when put into gear.

make sure your idle air control motor is working, if you give and hold gas pedal a little will it stay running in drive.

Posted on Oct 03, 2009

redbeard00
  • 957 Answers

SOURCE: My 1965 turbocharged John Deere 3020 started last

Try looking to see if the fuel-shutoff is working, open only one fitting instead of two injectors. Check the glow-plugs or intake heater if applicable. You can put an in-line electric fuel-pump in place. This can help you find out if there is a hidden fuel-leak, system loosing its prime, or bad lift-pump. If this still doesn't help then you may want to dig deeper and see if the shaft broke on the injection pump. Remember to mark the pump so you put it back exactly where it was. Rule of thumb is to set the timing to TDC on cylinder #1. Mark the gears with ink or white-out. and the injection pump case too. Let me know how its going.

Posted on May 21, 2010

  • 1 Answer

SOURCE: My 1997 Mitsubishi Mirage (1.5L engine), has an

Could be your timing is off or the distributor itself.

Posted on Oct 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 2001 cavalier.... Starts fine now idles but when put into gear it stalls?


Possible torque converter clutch issue. Is the check engine light on? If so, have it scanned for transmission codes. If the torque converter clutch is locked up when it isn't supposed to be, the vehicle will stall. Another thing to check is for coking on the throttle plate. Remove the hose that goes from the air filter box to the throttle assembly and look inside the throttle bore to see if it is dirty/black. If so, use carb cleaner and a toothbrush to clean while holding throttle plate open and remove as much carbon deposits as possible. This can affect minimum idle airflow and also cause a stall

Jul 15, 2015 | Cars & Trucks

1 Answer

4.8 engine low thottle and stalls in gear


Two things,first good clean up throttle body.There is set screw to bring low idle up.Just a little 700 to 800 rpms.Not too much.

Mar 25, 2013 | 2003 Chevrolet Silverado 1500

1 Answer

94 jeep grand cherokee. starts,idle. throw warmup. as soon as I touch the excellerator let up the rpm drop & engine stalls.


Most low idle speed problems on these engines are due to a faulty idle air control valve but since you state the idle will go up and return to idle then i would say it is working properly i think you have a throttle body coking problem ( dirt and grit accumulates around the butterfly valve in the throttlebody ) to fix this simply remove the fresh air hose from the throttlebody and open the throttle all the way up use a clen rag and wipe clean you may use a solvent such as B12 on the rag but dont use too much 1_4_2013_4_54_06_am.jpg

Jan 04, 2013 | 1994 Jeep Grand Cherokee

1 Answer

94 trooper startsbut stalls immediatly-changed throttle position sensor,map sensor, and idle air control valve but problem continues


I can't remember exactly, but if there is an airflow meter, check the air intake hose for cracks or looseness. If there is any openings between the throttle body and the airflow meter, the computer will not see the air entering the engine so it will stall right after it starts.

Jun 26, 2011 | Isuzu Trooper Cars & Trucks

1 Answer

1989 Lincoln Town Car will start no problem, has good gas, but will not idle, so when I put it in reverse to back out of my driveway it stalls. Now there is no heat in car either (possibly heater core) but...


you may need too clean the throttle body .go to the part store buy some throttle body cleaner spray.then remove the big black hose from the throttle body on the top of the engine. with a soft tooth brush open the throttle full. spray the black gunk on the blade and in the barrel. then with the tooth brush scrub the black gunk. spray clean . reattach the hose.when you first start hold the throttle open full until it starts and runs smooth.or just above 2000 rpm .then let idle for two minuets. before you put in to gear.

Apr 17, 2011 | Lincoln Town Car Cars & Trucks

1 Answer

Starts/stalls won't run until pedal tapped, 2 miles in town, 6 miles highway, then1000-1500 idle. shut down 9 hours, start/stall tap pedal runs return 6 mi. highway,2miles town same high idle. checked code...


Check your IAC motor (Idle Air Control) It could be sticking open.
Ps. Might be called Idle Speed Control motor it depends on the make and i forget what chevy calls theres.

Mar 11, 2010 | 2000 Chevrolet Malibu

2 Answers

The car starts and immediately stalls unless I


Hey Jruthesq

The 850 is equipped with an Idle Air Control Valve (IACV) which supplies the engine with air when idleing (a necessity since the main throttle body valve is completely closed when no throttle is applied, thus the engine would lack air without the IACV when idleing). The IACV is suspended in a rubber mount on the front of the throttle body itself, and is easily removed and inspected/cleaned. If it's dead a good cleaning usually gets it going again. Also make sure that the air from the IACV is unhindered on its way from the IACV to the throttle body (it's actually common for the holes in the throttle body to be gunked up so bad by hardened carbon deposits that one sometimes needs a nail or even a drill to open it up again).

Just thought I'd mention this since you said that the gas needs to be feathered for the engine to start. When you press down on the gas the main valve in the throttle body opens up, closing the IACV and supplying the engine with enough air.

Oh and if your fuel pump relay is a green one marked 103 you should replace it with the new and improved red one. The relay is located under the fuse box cover under the hood. Remove the 4 torx srews holding the cover in place and you'll see the relays under there.

Good luck mate!

Jul 01, 2009 | 1997 Volvo 850

1 Answer

2002 Honda Accord - slow engine start and jerking


Most likely a dirty idle speed control system follow the guidelines below to clean it.

Throttle Body Cleaning on vehicles without electronic throttle control (most 2003 and down)

You can in most cases repair this slow speed stall or unstable idle by cleaning the engine throttle valve and the idle speed control valve using a product called CRC Spray Throttle valve cleaner. Spray the cleaner into the air intake of the engine with the hose removed from the throttle body, the engine will try to stall so hold up the idle speed manually. Once you have used up about 1/2 can of the cleaner stall the engine out while spraying and turn the key off, disconnect the negative battery cable for 5 minutes and then reconnect and drive the car for a about 25 miles of varied driving modes. If this doesn't cure the problem you may need the fuel injectors professionally cleaned by the dealer service dept.

Jul 11, 2017 | 2002 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...