Question about 2000 Chevrolet Impala
Back in 2000 the 3.1 - 3.8 - 3.4 engines take out from top the 3.5 engine had to raise vechicle on lift drop engine transmission from bottom need a drive train table to support engine and transmission when lift body up with lift.
Posted on May 04, 2013
Testimonial: "Thank you so much. That helps. Thanks again for you knowledge and time. "
Its better if its taken from the top
Posted on May 03, 2013
Testimonial: "I was told it comes from the bottom but after looking I feel better taking it from the top. Thank you for a second opinion. "
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Unscrew the bolt that holds the negative connection to the Impala's
battery. Set this bolt aside for later use.
Remove the engine cover to access the intake manifold and manifold
gasket. Disconnect the throttle body inlet duct from the engine.
Twist off the radiator cap to allow draining of the coolant to flow more
smoothly. Place an empty container beneath the radiator's drain plug, and
remove this plug. Allow all of the engine coolant to drain into the empty
container. Replace the drain plug once you are finished.
Tag all of the electrical wiring and hoses before removing so that
reconnection is precise to factory settings. Remove these parts, individually,
from the intake manifold.
Loosen the bolts that hold the intake manifold to the Impala's engine
block. Lift the intake manifold from the block once all bolts have been
Use the flat-head screwdriver to pry the old intake manifold gasket from
the engine block. Discard this part once you have removed it.
Clean the engine block thoroughly with the engine degreaser and linen
cloth. If necessary, use a gasket scraper to remove excess buildup and grime.
Place the old intake manifold on top of the newly-installed manifold
gasket until it aligns with all of the holes of the cylinder flanges and
Attach all of the bolts with your hand to the manifold. Once all bolts
have been positioned, use a torque wrench and apply 15 foot-pounds of pressure
to the bolts to secure the manifold into place.
Reconnect all of the necessary hoses and electrical wiring to the
intake. Pour the engine coolant back into the radiator.
Reattach the engine cover on top of the intake manifold and engine
block. Start the Impala's engine and check for any leaks around the new intake
Jul 08, 2012 | 1996 Chevrolet Impala SS
Mar 14, 2012 | 2000 Chevrolet Impala
May 23, 2011 | Chevrolet Impala Cars & Trucks
Jan 13, 2011 | 2000 Volkswagen Beetle
Dec 24, 2010 | 2000 Chevrolet Impala
Jun 09, 2010 | 2000 Chevrolet Impala
May 17, 2010 | 2000 Chevrolet Impala
Jan 22, 2010 | 2000 Chevrolet Impala
Dec 16, 2009 | 2000 Chevrolet Impala
Oct 06, 2009 | 2000 Chevrolet Impala
178 people viewed this question
Usually answered in minutes!