Question about 2001 Lincoln LS V8
Ford, Lincoln, and Mercury vehicles are known to have faulty a/c and unfortunately the only fix that will last more than a couple months is replacing the whole a/c system and don't have it done at a ford dealer. To be honest I would recommend either getting used to no a/c or buying a different car.
Posted on May 03, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: diagram for a 2000 lincoln ls V8
Your best ,to cut the old belt,to remove.
You can use a long handle 1/2" drive ratchet, on the belt tensioner.
The only pic is in the shop manual.
Wear long sleeves and arm protector sleeves on top. the fan housing is sharp and a tight fit. You will be there a couple hours.
Draw a picture before you start, and you won't need a diagram
Posted on May 17, 2010
The lincoln better idea engineers put the low side freon port in a peculiar place.. You will find the low pressure port near the compressor under the car on the driver's side. You will need to put your car on a lift to get to it. Once you raise your vehicle, take the plastic shields off and you will find the compressor...yup...it's a tight spot.
Hope i was able to answer your question...be safe.
Posted on May 13, 2009
First- to drain ,you can reach the drain valve,from the pass side,if you lay on the ground and reach up to the radiator. You do not even have to raise the vehicle up
Second- mix Yellow GO5 Coolant about 50/50 or 60/40. Do not use Green in a Ford or Orange GM
To Fill- Remove the front two plastic screw type buttons,from the engine cover
-Remove the cover
The radiator cap is on the front of engine,on top,it is plastic
Remove cap and that is your fill point
Run engine to warm and get thermostat open,as you would with any vehicle
Top off coolant,replace cap
VERY IMPORTANT-next to the Power Brake Booster,and just under it,is a BLEEDER HOSE;to let air out of system. Turn screw slot ,only a little,DO NOT REMOVE SCREW. When coolant runs out close.
Fill-Degas Bottle,to full line,with coolant.
Check the next couple days on resevoir level ( Degas Bottle)
Posted on May 06, 2010
Tips for a great answer:
Sep 25, 2016 | 2001 Lincoln LS
Jan 08, 2016 | Cars & Trucks
Mar 27, 2013 | 2001 Lincoln LS V8
Jul 12, 2012 | Cars & Trucks
Jul 13, 2011 | 2001 Lincoln LS
Sep 15, 2010 | 2003 Lincoln LS
119 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: