Question about 2001 Dodge Neon

Open Question

Why ebl switch fuse blows

Fuse blows when the ignition switch is turned on

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 6982 Answers

SOURCE: ignition switch fuse terminal is blowing red 40 amp fuse when i try to replace it

A fuse that is consistently blowing is telling you that there is a short in that system. Don't attempt to bridge it or use a larger amp fuse or you will have a major problem. You will need to start tracing wiring to destinations to find the short. If while moving harnesses around problem ceases to exist, look at nearby items where you are working and try to locate what was grounding. Sometimes people will stop if short disappears, leaving open the possibility of it happening again.
If you are not comfortable working with wiring, then leave it to professionals who do this every day. It's not really difficult but requires patience and a good bit of knowledge to do this right!

Posted on Apr 18, 2009

Ad
motor1258
  • 6674 Answers

SOURCE: windshield wiper fuse blows everytime I turn the ignition on

Try removing the harness connector to the motor, and see if it still blows the fuse, then you've isolated the problem.

Posted on Jun 05, 2009

redds55
  • 2620 Answers

SOURCE: dodge caravan keeps blowing fuse

Check for a short in the ignition system.There is a hot wire that is grounding out in the ignition.

Posted on Aug 18, 2012

Testimonial: "That was the prob..wire had rubbed till it shorted on frame..THANKS....."

skychief2001
  • 21873 Answers

SOURCE: 30 amp Starter/Ignition fuse keeps blowing when i turn the ignition key. The instrumentpanel lights are dim and then the fuse blows.

I am assuming you are talking about the circuit that powers the key switch. I'm showing a fuseable link to the starter relay instead of a fuse.
If it is the circuit that powers the switch, I would disconnect the switch and see if the fuse blows as each circuit is powered one at a time using a jumper wire. You can get 30amp circuit breakers that plug into the fuse slot to use while you are testing circuits.
You may need a repair book or shop manual to find out what is powered by that fuse since it is most everything on the car.

Posted on Mar 01, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2009 Toyota Corolla. Recently the wiper fuse started blowing. The Fuse keeps blowing as soon as the ignition is turned on.


could be anything and without a look myself i couldnt tell you try disconnecting the wiper switch and see what happens is about the best i can come up with was thinking of the self park but with motor disconnected and it still blows ?? thats that out the equation .

Jan 08, 2017 | Toyota Corolla Cars & Trucks

1 Answer

Ignition fuse switch keeps blowing


you have a short in that circuit chck your harness for wiring that might be exposed to ground or pinched

Apr 13, 2014 | 2006 Kia Sedona

1 Answer

92 olds 88 blows wiper fuse with switch off and ignition is turned on . Switch is new.


It is getting power from somewhere. Obviously the correct wires havent all been disconnected. Sometimes they are mislabeled.

Mar 14, 2014 | Cars & Trucks

1 Answer

30 amp Starter/Ignition fuse keeps blowing when i turn the ignition key. The instrumentpanel lights are dim and then the fuse blows.


I am assuming you are talking about the circuit that powers the key switch. I'm showing a fuseable link to the starter relay instead of a fuse.
If it is the circuit that powers the switch, I would disconnect the switch and see if the fuse blows as each circuit is powered one at a time using a jumper wire. You can get 30amp circuit breakers that plug into the fuse slot to use while you are testing circuits.
You may need a repair book or shop manual to find out what is powered by that fuse since it is most everything on the car.

Mar 01, 2013 | 1997 Dodge Avenger

1 Answer

What does EBL mean


Electronic Back Light = EBL

About this device,
the EBL relay is located in the lower left corner of the junction block and immediately above the fuse bank.

Hope this helps (remember to rating this free answer).

Oct 14, 2011 | 1996 Chrysler Town & Country

2 Answers

I have a 2004 dodge stratus that has power to lights but does not turn over when i try to crank even after jumping it off.


Hi.

Check ignition switch fuse. This is a 20 Amps. see that it has not blown. In 2004 Fuse should be nr 8 in the power box under the hood (newer models #24).

Once you are sure that battery, fuse and wires are OK, check starter and ignition switch. Check if there is 12V to starter while cranking. If there is power and the starter motor does not turn, then the motor is gone.
If there is no power to starter motor when you crank, then the ignition switch located inside the steering column may need replacement. Before repairing, try reading error codes with a code scanner.

Apr 15, 2011 | 2004 Dodge Stratus

1 Answer

I have a 1993 ford explorer, every time i turn the ke to the run position, it blows the ignition 60amp maxi fuse under the hood. The first time this happened, I replaced the fuse and the SUV ran fine for a...


I'm no expert but when you turn key to run position, this turns the fuel pump on if the pump is faulty i would think it would blow the fuse also. Or its your theory a short in the ignition system wiring.

Mar 20, 2011 | 1993 Ford Explorer Limited

1 Answer

20 AMP FUSE BLOWS WHEN IGNITION IS SWITCHED ON IGNITION SWITCH TESTED AND OK


something connected too ignition sdwitch has short to ground. remove all fuses except 20amp that blows turn on ignition see if blows. if not replace one by one till it does to isolate circuit. which fuse is blowing and where is it located.

woodysmechan kiesha76@hotmail.com

Mar 10, 2011 | 1999 Suzuki Vitara

1 Answer

Need to know what EBL stands for?


stands for electric back light....its the rear window defogger and the heated power mirrors...they all run off of the 50amp #4 fuse

Nov 15, 2008 | 2000 Dodge Durango

Not finding what you are looking for?
2001 Dodge Neon Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...