Question about Cars & Trucks

1 Answer

318i e46 2000

Hi every one. i have abig problem in my car.does not function ok the instrument panel.the turn signal work(only outside).the window key does not work.the air condition does not turn on and not turn of.when i make engine start the ac turn on himself but in the display of the key panel(air condition) is turned of.i try to remove the key panel of the air condition but no solution same problem again.all fuses are ok.the can some one help me please.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 28 Answers

Take it to a technician and let him check it out.

Posted on May 02, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 345 Answers

SOURCE: Passat 2000 turn signal problem

sound like you have a poor earth on the rear lights or indicator circuit

Posted on Oct 23, 2008

  • 2 Answers

SOURCE: 1998plymouth grand voyager- the front

You can check this out and see if it helps.
wmbeasley@gmail.com


http://www.davintosh.com/2007/09/15/fixin-the-dashboard/

Posted on Nov 08, 2008

  • 512 Answers

SOURCE: Instrument panel not working at all - all signals work o.k. , brakes, turn, etc.

check the igntion off draw fuse if it is blown or not fully seated in the fuse block it can cause this

Posted on Nov 16, 2008

lancer721
  • 229 Answers

SOURCE: car will turn over but not start.97 audi a4 1.8

It sounds like you don't have quite enough juice to start it. Sometimes vehicles will turn over but won't start when battery is low. Have someone jump you with jumper cables and I bet it will start then have your battery tested. If it won't start try giving it a shot of starter fluid as well as jump starting it and this will probably do the trick. If not you will have to have it diagnosed professionally. Good Luck

Posted on Nov 29, 2008

  • 11 Answers

SOURCE: ac compressor does not turn on when car has been sitting & it's hot outside. Works fine in the morning.

either the freon charge is about 1/3 low, or the expansion valve needs to be replaced. Freon is getting into the evaporator, but not in great enough volume to cool the air unless it is coming in cool to start with. check your ac charge, and if it is full, then have it emptied, change out the expansion valve, and recharge it

Posted on Sep 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My signal lights don't work. They don't light up on dashboard at all


Check fuses for instrument panel and turn signals owners manual will have description of which fuse controls what light, are turn lights working on outside of vehicle?

Jun 05, 2014 | 1995 Jeep Wrangler

1 Answer

Turn and emergency signals not working...Fuse good?


If the 7.5A TURN FUSE in the instrument panel junction box and the 15A HAZARD FUSE in engine room junction box 2 are OK, the problem is elsewhere. The combination switch is common to both functions.

Apr 22, 2013 | 2000 Toyota Camry

1 Answer

E46 instrument cluster not working


jjshock how did you fix this problem

Oct 17, 2012 | 2001 BMW 318i

1 Answer

03 chevy venture rt.front parking light&turn light don't work replace bulb&socket


The rapid flashing occurs because of the light problem. If the 20A PARK LP fuse in the underhood fuse block is OK, the front marker lamps and the park lights should turn on when you set the headlamp switch to PARK. If the 10A T/SIG fuse in the instrument panel fuse block is OK, and the ignition switch is on, moving the turn signal multi-function switch to signal a right or left turn should cause the turn signals to flash. If this doesn't happen, check for a missing ground connection to the socket you replaced and check to be sure the replacement lamp was not forced into the socket backwards (it happens).

Sep 17, 2012 | 2003 Chevrolet Venture Passanger

1 Answer

What are the instructions to remove and replace the combo turn signal switch, located in the steering column, for a 1999 bravada


Warning: 1995 and later models are equipped with an airbag. Always turn the steering wheel to the straight ahead position, place the ignition switch in Lock and remove key, then remove the airbag fuse and unplug the yellow Connector Position Assurance (CPA) connector at the base of the steering column before working in the vicinity of the impact sensors, steering column or instrument panel to avoid the possibility of accidental deployment of the airbag, which could cause personal injury. The yellow wires and connectors routed through the instrument panel are for this system. Do not use electrical test equipment on these yellow wires or tamper with them in any way while working under the instrument panel.
Caution: On models equipped with a Delco Loc II anti-theft audio system, be sure the lockout feature is turned off before performing any procedure which requires disconnecting the battery.

  • The turn signal switch function is incorporated into the multi-function switch, along with the wiper/washer and headlight dimming controls.
  • Disconnect the negative battery cable. Remove the steering column covers and the drivers knee bolster.
  • Remove the two Torx screws securing the multi-function switch to the top of the steering column.
  • Clip the wire-ties securing the multi-function switch harness to the other steering column wires.
  • At the bottom of the steering column, remove the bolt securing the large bulkhead electrical connector to the firewall.
  • Separate the two multi-function switch connectors from the large bulkhead connector.
  • The multi-function switch and its harness must be replaced as a unit.
  • Installation is the reverse of removal

Mar 16, 2011 | 1999 Oldsmobile Bravada

2 Answers

Instrument panel and turn signals were going out


check the multi function switch assembly (ie..turn signal stock) comes as a whole unit.

Dec 06, 2009 | 2001 Chrysler Town & Country

1 Answer

Ford explorer 2003 Issue the turn signal indicator lights in the dash went out one a week ago the other yesterday. turn signals are working fine just no indication off the instrument panel. all other...


It seems that the bulbs went out or the ribbon cable that runs behind the instrument panel burned out check on a junkyard for a replacement instrument panel and replace it, verify that the truck you pull out the instrument cluster is the same year and the same model.

Jul 08, 2009 | 2003 Ford Explorer

1 Answer

97 318i Instrument Cluster


these dashboards are a a pain! there are fuses in the fusebo under the bonnet, check them firt, also remove them and put them back to see if it resets it, if not then there is a test you can do,,,,,

press the mileage button on the dash, turn the ignition key to position one release the button and the das should perform a complete check, i.e gauges and mileage pixel.

Good luck Davelee, p.s, please rate me.

Mar 24, 2009 | 1996 BMW 318

1 Answer

Instrument panel not working at all - all signals work o.k. , brakes, turn, etc.


check the igntion off draw fuse if it is blown or not fully seated in the fuse block it can cause this

Oct 18, 2008 | 2001 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...