Question about Cars & Trucks

Open Question

How do you check 2009 V6 Le camry transmission fluid level

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
LDonegan
  • 1 Answer

SOURCE: transmission fluid level

I have a 1998 Isuzu Rodeo however when I purchased the vehicle I managed to obtain a service manual on mine.
Mine is a V-6 3.2liter engine with automatic transmission and it took me a while to find out where I added transmission fluid at too.

It is located under the vehicle on the Passenger side of the vehicle and it is located on the transmission just before the transfer case. There is like a eye beam across one side to another then there is like a Indent the lower one is for drain and the upper one with a larger bolt like plug is the fill hole. I used a turkey baster with a large bulb like affair to **** the transmission fluid in to it from the bottle then I inserted the baster up and into the hole vacated by the plug. Then squeezed the fluid into the transmission and kept at it till the fluid dripped out on its own. I hurried and inserted the plug into the hole and screwed into it and tightened it up and lowered the vehicle down checked after the vehicle had been warmed up and re jacked the vehicle up and rechecked and all I needed was a small squirt into it and it was full and since then it has been running really well since.

Lucky W Donegan LDonegan@centurytel.net
Polson, MT.

Posted on Mar 23, 2009

Ad
  • 158 Answers

SOURCE: Transmission fluid type and level

This is complicated.... Ok, your right, no dip stick is there! This is how it works.
Underneath the car, there is a plug (11mm) on the transmission case on the passenger side. It is about 3" up from the pan edge and on the front side of the case. With the engine running in PARK, remove this plug. If trans fuild doesn't run out of the hole, the level is low. Pour it in the hole on top (where the red cap is) until the fluid runs out - all while the car is running. Once it is roughly dribbling out, the trans is considered full. replace plug. Your done!!
Easy ehh? Dexron III fluid

Posted on Apr 20, 2009

techbuster
  • 5081 Answers

SOURCE: local mechanic says they can't check fluid level

"Sealed" means there's no dip stick tube.
The Explorers and Lincoln LS have this also.
It is nothing new and you can still change/flush the fluid as usual.
A special procedure is used to check the fluid level.
Not having the dip stick tube is one less place for dirt to get into the transmission.

please rate my answer

Posted on Jul 07, 2009

cmcduncand
  • 714 Answers

SOURCE: how can i check to transmission fluid level in 2005 ford explorer

Does not have a dip stick.

Start the vehicle set park brake

In the side if the transmission oil pan a bigger bolt with a small bolt in the center.

Remove smaller center bolt trans fluid should drip out at a fairly constant rate if not its low.

Hope this tip helps.

r/
David

Posted on Feb 15, 2010

  • 708 Answers

SOURCE: How to check transmission fluid level

Unfortunately you can not. Chevy put sealed transmissions on most of their cars starting in 2006. It would be out of luck if you got one without a sealed transmission. If you did, look behind the engine on the passenger side for a dipstick similar to your oil dipstick. If you dont see one, you will have to go to the dealership to have it checked.

Posted on Feb 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

5 Answers

I have a 94 Camry LE 2.2. A few days ago while driving my camry, I noticed a couple different times it hesitated when I started to take off from a stop. The next day, I started the car and shifted it in...


sounds like your transmission is low of fluid if not then the transmission is in need of service depending on mileage.transmission has solenoids can can go bad and torque converter,have your transmission checked.

Dec 16, 2014 | 1994 Toyota Camry

1 Answer

A 94 toyota camry le 2 door v6 transmission drive gears not workin but park and reversole do


There are really only 2 possibilities which are within your reach

- low trans fluid level, check that with engine idling
- poorly adjusted shift linkage, see p69 here

http://www.turboninjas.com/camry/ax2.pdf

If anything else has failed, like a shift solenoid, it's really a job for a specialist.

Feb 17, 2012 | 1994 Toyota Camry

1 Answer

Check engine light is on, and when i go past 40 it stops running. doesnt turn off just stops running.


check transmission fluid level.if fluid level okay, transmission fluid and filter been changed. code scan for ecm faults.sound like problem in the transmission torque converter.leaking valve body gasket or faulty valve body and bad oil pump losing pressure not enough oil pressure to get transmission in drive or over drive.

Apr 17, 2011 | 1993 Toyota Camry V6

1 Answer

I drive a 1991 toyota v6 camry le and i can find out why it doesnt have any power (slow acceleration speeds) the RPMs go up to about 5k and still cant feel the acceleration in it.


1. If you have the check engine light on then the emission control could be doing this because of bad oxygen sensor(s).

2. Check the transmission fluid. If the level is low then the transfer case would not transfer all the power from the engine to the transmission.

Mar 13, 2011 | 1990 Toyota 4Runner

2 Answers

1989 Camry Le V6 sluggish in acceleration, I have installed new plugs and wires


YOUR FUEL FILTER COULD BE STOPPED UP OR TRANSMISSION IS SLIPPING DUE TO LOW FLUID OR DIRTY STOPPED UP TRANSMISSION FILTER OLD FLUID.YOU COULD HAVE WORN CYLINDERS AND RESTRICTED EXHAUST SYSTEM OR STOPPED UP CATALYTIC CONVERTER.

Feb 28, 2010 | 1989 Toyota Camry

3 Answers

Transmission Fluid Leak


Sounds like a bad seal .is it leaking where the transmition connects to the engine

Jul 02, 2009 | 1992 Toyota Camry V6

1 Answer

Type of power steering fluid for 2001 toyota camry


Power steering fluid - Dexron 2 or 3 automatic transmission fluid. Yes transmission fluid. And while you are at it check the fluid level in the transmission.
Since you got the hood up, check the brake fluid, wiper fluid, radiator fluid, battery fluid, oil level.

Apr 26, 2009 | 2001 Toyota Camry

1 Answer

Why is My Brake Lights Are On In My 92 Toyota Camry...


add fluid then recheck for the light, also when fluid level goes down it means the brakes are nearly worn out.

Apr 23, 2009 | 1992 Toyota Camry V6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...