2008 Kia Picanto 1.1 Logo

Related Topics:

Anonymous Posted on May 02, 2013

2008 kia picanto over revving problem

Engine just starts over revving erratically at unexpected times?

5 Related Answers

Anonymous

  • 12 Answers
  • Posted on Jan 02, 2009

SOURCE: 2004 Kia Sedona wont start but i can hear starter.

if the starter is revving very slowly it is the battery, charge battery. if not, It can be three things happing. 1 no spark 2 no fuel 3 no crank signal or the car computer is bad- you will need to unplug one of the spark wires and remove the spark plug and put the spark plug in the spark plug wire boot, and touch the spark plug on any metal on the car and have some start the car. donot touch the spark plug itself and see if there is a spark. if spark is bright, then it is not spark plug and wires but if no or spark is not bright, check the spark plug wires by applying a little bit of water on the spark plug wire and take a 12v test light, connect the clap to ground and and have some one to crank the vehicle, touch allover the spark plug wires with the tip of the test light, if you see spark, replace the wires and change the plugs.. they are not good. if spark is present, check for fuel by removing any one of the spark plugs and see if it is wet. if wet fuel pump is ok but if not go look for the fuel pump fuse and relay. is fuse blown, replace, check the relay resistor with a volt meter. it should be around 40 to 80 ohm. if everything is good from this point check the fuel pump itself by disconnecting the connector to the pump and apply 12v and ground using jumper wires or some wires to the fuel pump if you donot hear the pump,replace pump. if you, the crank signal or computer may be the problem

Ad

Anonymous

  • 64 Answers
  • Posted on Jan 21, 2010

SOURCE: 2007 kia picanto hard to start in the morning.got

Hi, this might be because of a voltage drop on the cables or the battery needing replacement. The colder the weather the more current your starter will braw. You can check for a voltage accross the bateery by connecting a volt meter to the battery and crank it if the voltage drop below 9.6V your battery might need replacement, if not you will need to see what the voltage drop is on the solenoid. You should have battery power on the terminal that activates the solenoid in order to get the solenoid to energise. If you do not have battery voltage on that terminal I suggest putting a relay between the ignition switch and the starter or replacing the wiring harness between the 2. Also check the connection on the ignition switch itself as you can get a bad connection there to.

Anonymous

  • 4793 Answers
  • Posted on Jan 29, 2011

SOURCE: How do you bypass the immobilizer on a Kia

YOU CANNOT BYPASS THE SYSTEM,You must have the remotes recoded by a dealer.if you have the book try and reset the alarm.if not ask another question on this site and we will get back.

Testimonial: "Thanks Goeffreyh"

Anonymous

  • 246 Answers
  • Posted on Feb 06, 2012

SOURCE: 2005 1.0 kia picanto cel flickering wont start

Try to scan it and retrieve code from check engine light it could cause so many things. You need to start from tehere to reveal code.

Anonymous

  • 444 Answers
  • Posted on Oct 30, 2012

SOURCE: fuel pump running but no fuel to injectors

Fuel pump regalator is at fault.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Kia Picanto 1.1 won't start.

You need an auto-electrician to connect a code reader or a pro grade scan tool computer that can scan data in real time. It will tell what is happening when the car starts to fail.
0helpful
1answer

My 2010 kia picanto wont open injectors new crank sensor and fuel pump but the wont start nor open the injectors

Search GOOGLE for:
"2010 kia picanto" injector troubleshooting
2010 kia picanto injector troubleshooting Google Search
See about 19,700 results!
SAME SEARCH as above,,, THEN click on "VIDEOS"!

THIS MAY help too!
2010 kia picanto injector troubleshooting YouTube

Anthony
0helpful
1answer

What are brake pad measurements for needing new pads front and rear and disc drums for a Kia picanto

max thickness of new pads is 16.5 mm
anything less than 6 mm needs new pads
wont make to the next 10,000 km service


Brake Pad Set disc brake for Kia Picanto


26243056-cozugveoduyoiwucuprdojwx-1-0.jpg
0helpful
1answer

How do I remove wing mirror cover drivers side from a 2005 Kia Picanto LX

kia-rio-side-mirror removal-04 - atomia.ir - YouTube

? 0:25
www.youtube.com/watch?v=GWIcTycQFYI
Feb 16, 2013 - Uploaded by Arash Soltani
rio-side-mirror removal-04 - atomia.ir. ... Drivers Side MirrorReplacement ' Kia Sedona ' Other Makes ...

Kia Picanto Forum [Archive] - Kia Forum - Kia-Forums.com

www.kia-forums.com > Kia Forum > KIA Models
[Archive] Life is more colourful with Picanto. ... Picanto 2007 auto transmission abrupt start problem · Driver side door lock problem (2005 picanto) · Picanto 1.0 lx ...
1helpful
2answers

Where is knocksensoer placed on kia picanto

Kia picanto knock sensor is located on the engine, above the alternator under the inlet .anifold
1helpful
1answer
0helpful
1answer

I can't start the engine. The battery is almost fully charged. I need to turn the key for about 3 or more times to start the engine.

If you turn key to START position, what is the sound, is it;
1. no sound at all means maybe starter problem.
2. only heard Tik sound means starter problem (you can add relay but it will still happen in future)
3. crank sound but not start means battery weak.

You can also try to move gearshift to N instead of at P position before turn key to START. if it work mean your car safety switch at gearbox not know which gear you're on.
9helpful
2answers

Where is camshaft sensor located on kia picanto 1.1

Remove Air filter and all related housings including right hand side next to battery. Sensor is underneath fitted horizontally into camshaft end housing and front facing. Electrical connection also faces front.. Remove electrical connector. Fixing bolt is underneath sensor. Warning - on removal some oil will escape.
Not finding what you are looking for?

216 views

Ask a Question

Usually answered in minutes!

Top Kia Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...