Question about Cars & Trucks

Open Question

My IR XHP 1170 425psi compressor keeps cutting out after every hour or so I have cleaned out the coolers n fuel system but still it continues to do so giving a fault code 29 which is unknown according to the book!!if anyone has had this same problem your assistance in this matter would be greatly appreciated regards Ryan

Posted by Anonymous on


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 30 Answers

SOURCE: Ford Focus Engine System Fault warning light

yes there is a know problem with the fuel system. fuel pump breaks down, empty your fuel filter into a bowl and check for metalic, if you have this in the filter your pump is F..... along with all the other common rail stuff. expensive job... error codes though, i find that hard to believe, fuel pressure faults will occur, i think you garage does not know what to do. or does not want to tell you the cost of the job and he will be in doubt himself of wether he is right..... was you engine coil light flashing at any point.!!!

Posted on Mar 30, 2009


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Fuel cut out

Did you check the oil? A low oil sensor will disable ignition if more than a quart low.

May 23, 2017 | Acura Integra Cars & Trucks

1 Answer

Surges in and out in overdrive. over50 miles an hour it shift but sometimes goes out

It sounds like your over-drive is going out. Have you serviced the transmission lately? I would highly recommend also having the gov. pressure solenoid screen cleaned and as with most all Dodges, I recommend installing a inline filter in the pressure line going to the cooler. It will prolong the life of your transmission.

It's not hard to do and most any parts store can order you 1, the small inline filter looks like a metal fuel filter, cut the metal line going to the cooler, add some rubber trans. hose and filter. but only AFTER having your transmission serviced! Whoever services your transmission have them inspect the pan well, if you have a lot of metal in the pan, you will more than likely be looking at replacing your transmission in the very near future. Hope this helps.

Dec 10, 2013 | 1997 Dodge Ram 2500 Club Cab

1 Answer

I have a 2002 Chevrolet caprice sedan made in Australia. i am having problem with my car AC. after running for about half an hour the ac performance lowers with very less air flowing through the vents....

It is possible that the pressure cut off switch is not working and so is making the compressor work continuously till the cooling pipes are frozen which eventually is reducing the cooling of the system.
hence have the cut off checked but as a trial run the car and manually cut off the ac when the cooling is good enough- use the highest blower fan speed within the cabin. If the compressor now works OK then this switch is not cutting off when there the pressure build up , the thermostat also is a suspect in this case.

Nov 26, 2010 | 2002 Chevrolet Impala

1 Answer

My 1993 Buick Century has trouble starting occasionally. After having it towed once when I wasn't able to get it started after about 30 minutes of trying, it started right up and continued to keep...


Oct 18, 2010 | 1993 Buick Century

1 Answer

Air compressor pulley was not engaging on 94 Nissan Quest. Started to add some R134a and after a few seconds the center of pulley engaged but will cut out after a couple of seconds. Continued to charge...

Touchy situation. Without a machine it's tough. If your system was EMPTY, then you need to add up to what your A/C sticker says.It should be located on radiator support. Fully charged system should read around 35 degrees. Too much freon will cause one to run high pressures also.

Aug 12, 2010 | 1994 Nissan Quest

2 Answers

My peugeot 206 diesel keeps cutting out, now it

In my opinion cut off problem occurs if engine is not getting sufficient fuel and/or air. Clean the air filter, turbo filter and fuel filter. Check the continuity of diesel flow from filter to hdi pump. If you haven't found any problem there then the possibily the hdi pump and injectors section needs to be checked. If the car has done more than 100000 miles then clean inlet and outlet manifolds including check of turbo and EGR valve. Do everything whatever possible before you take your car to garage. If there is no luck then let your car diagnosed and check any error code recorded by ecu.

Oct 13, 2009 | 2005 Peugeot 405

2 Answers

A/c compressor continues to cut off/on.Full of

so, basically the compressor still WORKS, but it cuts off and on? they cut off and on alot anyways, but i would say, if it works, you shouldnt have anything to worry about, unless its doing it at ridiculous which case you'll want to take it to an AC repair shop, and have the system checked for leaks, and possibly have the system evacuated and flushed.....there might be a valve that is stuck, which would cause the compressor to act erratic, otherwise your drier or evaperator could be clogged.

Sep 24, 2009 | 2003 Chevrolet Impala

3 Answers

Car cuts out when warmed up and when you try to accelrate

fuel pump is not delivery right amount of pressure. When pump is cold it delivery correct pressure after it gets hot it doesn't deliver the correct pressure. Check fuel pressure when cold in between 30 and 40 psi and when u run it for a while (100 miles ) measure if the pressure is below 30 psi your fuel pump is going bad, hope this helps

Jul 24, 2009 | 2001 Ford Focus

3 Answers

Trying to add freon to my 99 gmc sierra, as i add freon i hear the compressor start to come on but turns off after a few seconds,still dosnt get cold

The compressor cutting and out is a good sign that the system is trying to work. Usually when the compressor cuts in and out after a few seconds, it means that the system is not fully charged and more refrigerant is needed. It's a good idea to purchase a gauge that measures the amount of charge in the system. The gauge looks like an air gauge, and they are not very expensive. That way you will know how much more of a charge the system needs. The gauge hooks up to the low pressure valve, just as the charge hose does.

Jul 02, 2009 | 1999 Chevrolet Silverado 1500

2 Answers

1994 S420 mercedes benz cooling fans will not come on or the a/c''

when you turn on ac system the front of the compressor should start turning if it does not turn check fuses to ac system if ok its probaly to low on charge to turn the system on.

Jun 22, 2009 | 1994 Mercedes-Benz S-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides