Question about Cars & Trucks

Open Question

2009 Ford F 150 King Ranch the driver side power seat does not go forward or backwards or up or down or Recline but the lumbar does work and the memory works on the me a rose the radio but not the seat can anyone helpI checked the fuses were fine I don't hear anything when you hit the button no clicking no sound at all I can see both motors burning out at the same time

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 208 Answers

SOURCE: My driver side power seat will not move forward or

hello dschlig, most common for these seats are the motors. I would recommend raising the seat as high as possible. While trying to activate the seat in the forward/back positions, see if you hear or feel a clicking in the motor under the seat. The motor can be recognized closest to the carpet, and has 2 rods going to each seat track. If the motor clicks, inspect the connector and make sure nothing dislodged it. If it is ok, you can use a small hammer and an extension and lightly tap the motor to see if it will maybe release. If you know how to use a volt-meter, you can also check for power to the motor connector when sliding the switch in either direction. The motor can be replaced seperately.

Posted on Apr 20, 2009

sscullys
  • 984 Answers

SOURCE: Rear power window, power pedals, driver power seat

Check for a bad splice in the driver's side door sill.
The SuperCrew the splice is generally a purple wire back by the C-pillar, and looks to be wrapped in a tape that looks like hockey tape. Should have signs of water damage.

84488a1.jpg

If you did not have the rear slider issue, I would have thought VSM ( Vehicle Security Module ) ground missing. The VSM is mounted behind the rear seat back ( need to remove the seat to get to it to check ).

Posted on Oct 15, 2010

merctechniqu
  • 229 Answers

SOURCE: Hi everyone I own a CLK200 Kompressor 2002

First try as fallow, get in to the seat, then keep tight your foot on floor and give a good press backward to the seat and operate the seat switch towards back, just release and do it again keep going that way it will start to move back words, if it start to move do it few time and do it every time you get in to the car at least two time per day continue it for one week, It will be OK otherwise need chassis no for more information,

Posted on Nov 12, 2010

ercupa190
  • 12223 Answers

SOURCE: driver side power seat does

you must look for loose wire, clean contac switch, and finally the switch will be faulty.

Posted on Dec 01, 2011

  • 1 Answer

SOURCE: 2009 impala driver side power seat won't move up/down, makes whirring sound when attempted. Moves forward backward. Passenger seat works properly.

Before you do any of the expensive things disconnect and reconnect the wiring to the seat I had the same exact problem with my 2009 Chevy Impala and was ready to take it to the dealer when I disconnected the power cables to it and reconnected them I found that one of the Harnesses was loose and the problem was solved

Posted on Oct 14, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford edge 2009 rear seat


Do the latches/handles move and nothing happens? Is that the problem?

Oct 16, 2013 | Cars & Trucks

1 Answer

2009 impala driver side power seat won't move up/down, makes whirring sound when attempted. Moves forward backward. Passenger seat works properly.


Before you do any of the expensive things disconnect and reconnect the wiring to the seat I had the same exact problem with my 2009 Chevy Impala and was ready to take it to the dealer when I disconnected the power cables to it and reconnected them I found that one of the Harnesses was loose and the problem was solved

Sep 12, 2012 | 2009 Chevrolet Impala

3 Answers

Front seat will not slide forward? The seat will move up and down, tilt, and the lumbar works? Even the heated/cooling seat works? What do I need to look for and how do I fix it:?


The power seat in the truck has 3 motors, one of them is not working, the most common cause of this is the power seat switch is defective, it is often the forward and reverse seat positioning switch that fails because it is the one that is most used. If the switch checks ok then you will need to replace the the power seat track assembly, Ford does not sell any parts for the track, it is only available as one complete unit, I know this because i retired form a Ford dealer. Please rate my help for Fixya. Thanks

Dec 29, 2011 | 2007 Ford Expedition Eddie Bauer EL

1 Answer

Driver side power seat does not move forward or backwards. it does move up and down, and the switch for lumbar works fine


you must look for loose wire, clean contac switch, and finally the switch will be faulty.

Sep 16, 2011 | 1994 Ford Mustang

1 Answer

2001 Durango front drivers power seat lost power and what move what is the problem?


If the seat has recline and forward, backward controls and you can do nothing at all. Then I would say you may have blown a fuse. I would check the fuse box. If you lost only recline or only forward & backward then it may be a bad motor. It can also be a motor if you lost both but both motors going bad at the same time is unlikely.

Feb 02, 2011 | 2001 Dodge Durango

1 Answer

Rear power window, power pedals, driver power seat and out side power mirrow not working. Checked the one fuse and it tested good 2005 Ford F150 King Ranch Super Crew


Check for a bad splice in the driver's side door sill.
The SuperCrew the splice is generally a purple wire back by the C-pillar, and looks to be wrapped in a tape that looks like hockey tape. Should have signs of water damage.

84488a1.jpg

If you did not have the rear slider issue, I would have thought VSM ( Vehicle Security Module ) ground missing. The VSM is mounted behind the rear seat back ( need to remove the seat to get to it to check ).

Oct 12, 2010 | 2005 Ford F-150

1 Answer

The side view mirrors will not move using the control


There are 2 fuses associated with the power mirrors, fuses F4 & F3.

The next thing to check ( if equiped ) do the power seats still work ?
The reason I ask, is if the power seats do not work, this ( usually ) is a broken splice in the driver's side door sill. The broken wire also has other items associated with it.

Start with checking the fuses, and if they are good check for power at the power mirror switch on the :
F3 - Orange w/ Light Green stripe wire.
F4 is for the power fold module ( in 06 a King Ranch option ).

Aug 03, 2010 | 2006 Ford F-150

1 Answer

1996 Ford Explorer - Eddie Bauer 4WD - Replace Power Seat Switch


the switch pops in or out just pull on it unless you see screws it should just pop right out theres no need to worry about the srs.

Nov 14, 2009 | Ford Explorer Cars & Trucks

2 Answers

The drivers seat is stuck. It won't move forward or backward but all other seat functions work fine. hi and please help..I have the same problem with the driver seat..it will go up and down and the back...


I'm assuming this is a power seat. If so, there are separate motors that control the various functions of the seat such as forward/backard, recline, lumbar support, etc. It could be that the motor or an electrical connection to the motor for the forward/backward motion is faulty. Normally all of the motors would be on the same power circuit, so if some of the functions are working then it is probably not a blown fuse.

Just one other personal observation, I have actually seen an instance where some loose pocket change had spilled under the seat and a quarter had become wedged in the track that the seat slides in and had jammed the tracks so tightly that the seat would not move.

One thing to note is whether or not you hear anything when you try to move the seat forward/backward. If you hear a click or a buzz when you press the button then that could mean that something is physically jamming the seat tracks. If you don't hear anything when you press the button, then that more than likely means a problem with the motor or the electrical connection to the motor.

Jan 10, 2009 | 2004 Infiniti I35

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...