Question about 1997 Toyota Tacoma

Open Question

Remove Dashboard The clock stays lit and the radio (after market Panasonic) remains on with out the keys in the ignition which has never happened for the 9 years that I've own it? How do I correct this? If I need to remove the dash surrounding the radio how do I do this?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: Removing the dash board

Hello, on most corolla's I have done,the black plastic shroud unscews from around the speedo/dash cluster and also includes the hazard/breakdown switch.The black plastic then comes out with stereo attached(usually)so be careful not the crack the plastic surround.In most cases you will not need to remove steering wheel but it will give more room to work with,if it is removed.Hope that helps.

Posted on Jul 28, 2008

  • 1861 Answers

SOURCE: 2007 Toyota Sequoia Dashboard Access to Radio console FM Antenna

Pull off the 3 knobs for the heat controls. You will see a screw under the center knob. Remove it. Look to see if there are any screws near the vent grilles, remove them, if they are there. The whole center fascia then pulls out towards you. Remove the 4 bolts, and the radio is out. Easy.

Posted on Feb 07, 2009

SooSooSubaru
  • 49 Answers

SOURCE: 2001 Corolla Clock does not work. How to remove?

The clock is most likely dead, but can be refurbished at a decent price by www.subaru-clock.com. If you email "Dr.Clock" (as he calls himself) he may be able to assist you with some removal tips. This "dead" clock condition is very common in the Camry, Corolla, Matrix lines.

Posted on Oct 24, 2009

michigan man
  • 3533 Answers

SOURCE: How do I remove the dashboard from a 2005 toyota

the best thing for you to do is stop by your local Toyota dealership in the parts department and they be able to print you off pictures and diagrams showing you how to remove it wish you the best of luck Michigan Man.

Posted on Dec 11, 2009

satitus
  • 273 Answers

SOURCE: need to replace clock

I have the instructions and repair solution at www.autoclockrepair.com

Posted on Jan 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My heater will not work plus my dash lights stay on even when the car is turned off


Reasons Your Car Won't Heat ' Heater Stopped Working ...

www.autobytel.com > MyGarage® > Car Ownership Tips
The only cure here is to replace the heater core. To prevent the problem from reoccurring, the cooling system should be flushed and refilled with a fresh 50/50 ...

Car Heater Not Working - Troubleshooting Repair Tips ...

? 4:05
https://www.youtube.com/watch?v=aCkVjiPZA4o
Oct 1, 2013 - Uploaded by WiseAutoTools
When a car heater doesn't work, the most common cause is low coolant. When troubleshooting to try and ...

How to Fix a Car with No Heat (Easy) - YouTube

? 10:56
https://www.youtube.com/watch?v=-XjXTVJhFLM
Nov 21, 2014 - Uploaded by ChrisFix
No heat in your car? Car not blowing hot air? This video will show you how to fix your car's heater whether ...
Dash Lights May Stay on Due to Malfunction in Ignition Switchrepairpal.com > Problems > Volvo > 850the dash lights stay on after I turn the car off, Volvo repair can't find probl ... We recently replaced the ignition switch (1996 Volvo 850) and the car starts ...Dashboard lights going berserk...even when car is off - Car ...community.cartalk.com/.../dashboard-lights-going-berserk-even-when-c...Feb 11, 2013 - Dashboard lights going berserk...even when car is off. di k .... electrical systems the power to the cluster is turned OFF with the ignition switch. ... However, the abs light is one of the lights that stays faintly lit with car on or off.Radio and dashlights remains ON when car is OFF - 2014 ...jeepcherokeeclub.com/.../16673-radio-dashlights-remains-when-car-off....Jan 15, 2014 - 10 posts - ‎5 authorsRadio and dashlights shuts off properly when the car is OFF. .... door handle evenwithout key with me. just stay on for a m inute. notice it when i ...Dash lights won't turn off. - TDIClub Forumsforums.tdiclub.com > VW TDI Discussion Areas > TDI 101Jun 1, 2004 - I started the car, then noticed the dash lights were on before I turned on... I fiddled with the switch--even unplugging the standard NA light switch the dash lights .... If they stay the same, is it the normal brightness or dimmer?


Jan 10, 2016 | Cars & Trucks

1 Answer

Have 1998 rava 4 radio stays on with key removed can only turn off with button clock stays lit all the time also pulling fuse turns both off


Could be that the ignition switch is not turning off the trunk line that feeds the radio,etc. Needs replacement.

Sep 01, 2015 | Cars & Trucks

2 Answers

When turn key ignition off radio and clock stay on


Even when you remove the key from the lock?
Try to turn the key a little more to the left to be sure to move out of the Accessory position.
Hope this helps.

Feb 25, 2015 | 2004 Nissan Murano

1 Answer

Remotekey will not work. dashboard indication not lit.only powere steering light no clock or temperature lit. all fuses ok


A fuse can blow but physically look intact. How did you verify the fuses were ok? It could be that the 40A fuse 8 in the engine compartment fuse box has blown.
This supplies multiple circuits which are themselves individually fused in the consumer box inside the car.
The smaller 15A fuse 15 in the consumer box would normally blow under these circumstances but f the horn does not work as well and there are other things you have not listed that do not work like brake lights or headlights, it is definitely the under bonnet fusebox where the problem lies.
Good luck.

Jul 28, 2014 | 2007 Suzuki Swift 1.3

1 Answer

Remove ignition switch


Hi. Some cars do leave the display for the clock and odo on. Perhaps you only just noticed. If not then check if the radio switches off when removing the key. If it does, then all is normal. If not then you have a problem wiyh the key insertion switch in the ignition switch.

Feb 04, 2014 | Volkswagen Cars & Trucks

1 Answer

My radio and shift selector light stays on when I remove the key,


The ignition cylinder has a taper at the back that move the switch in whatever position. The key has to be turned back to off. It happened to me when I pulled the key out it was still half way on but then i just move it back in place. Its a sloppy cylinder from age.

Mar 13, 2009 | 2000 Chevrolet Malibu

2 Answers

Radio not working


If you have recently changed the battery or lost power for any reason your radio may require an anti theft code, check your manual to see if this even applies to your vehicle. You may be able to find code behind the glove box in some cases. Or look up your vehicle online to see if any codes are posted. If the clock is working you have power.

Jan 11, 2009 | 2002 Nissan Xterra

3 Answers

Focus remote key fob not working


this info would cost you £30.+ at ford Radio Frequency Programming Instructions:
  • Insert the ignition key and turn from position II (Ignition) to position 0 (All off) and back four times within three seconds.
  • Remove the ignition key. The locking control system is now in "learn mode" for the next 20 seconds and the red warning system LED (By the clock) stays on continuously to indicate this.
  • During the 20 seconds press one of the transmitter buttons. The remotes signal and code number is learned by the locking module and is indicated by flashing the warning system LED.
  • Wait until learn mode times out (20 seconds) or switch the ignition back to ON.nfrared Programming Instructions:
  • Put your key into the ignition and turn to position 1 (Radio). After approximately 10 seconds the red alarm control LED (next to the clock) should illuminate. As soon as it comes on remove the key from the ignition - the LED should remain lit.
  • Point the remote's "eye" at one of the front door sensors and press the rear button until the light on the transmitter illuminates (Keep the button pressed)
  • With the rear button held in press the front button 4 times then release both at the same time. The control lights in both clock and fob will flash 4 times to indicate programming complete.
  • Turn the ignition back on to exit programming mode

Nov 28, 2008 | 2000 Ford Focus

Not finding what you are looking for?
1997 Toyota Tacoma Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...