Question about Cars & Trucks

Open Question

My 1990 r3m nissan terrano speedo and rev gauges arnt working. hav cheked wiring and fuses. but wiring leads to slanoid fuses but dont know which one to check?

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: Where is the ECU located on the Nissan 94 Terrano

dont know for sure but all nissans ive worked on are behind the passengers side kick panel ( passengers left foot )

Posted on Aug 26, 2009

  • 713 Answers

SOURCE: Nissan Terrano II 2000 Speedo not working

you can remove the speedo from the dash flip it over to where you can see the gears in side and the contacts try cleaning them out real good with spray air for computer keyboards, the spray a little lubricant on them put back in and see if this helps it move a little better.

Posted on Aug 29, 2009

  • 1 Answer

SOURCE: speedometer, gas gauge, odometer, rpm gauge not working

My gas guage, speed odometer and tempiture does not work
The speed odometre is reading 9999999 what should i do

Posted on Oct 21, 2009

  • 1 Answer

SOURCE: peugeot speedo mileage counter and speedo dont

Had this problem on mine & the main dealer were stumped. Eventually found it myself after a lot of pocking about.Have a look at the wiring loom in the engine compartment. Looking under the bonnet look closely on the right hand side of the engine above the gearbox where the wiring loom passes from the rear of the engine over a metal bracket/support to the front. The loom has a tendancy to rub against the bracket and eventually damage the cables within. You will have to remove the air filter canistor & a few air hoses to get to the bracket. Good luck!

Posted on Jan 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan Terrano 1997 R50 ,gauges on instrument cluster not working


Greetings

"Great choice of service Repair and Manuals"Large pictures deals or discounts is there.You buy in less amount so please use it

May 25, 2016 | Cars & Trucks

2 Answers

No power supply with new battery? Eg. No lights showing on dash board when battery is connecred to terminals? Help plz. Will the cause be the fuses? Nissan terrano 1998


If your car has no electrical power, no headlights or lights of any kind probably has a dead car battery. A car battery supplies all electrical power to a car. If it is a new battery, you have to check the wiring connection.

Sep 10, 2013 | 1999 Nissan Terrano

1 Answer

Have a 91 nissan terrano r3m, is this model dont have a mass air flow sensor?


Correct, it does not. Purely mechanical. And long may it last...and it usually does.....

Jan 02, 2013 | Nissan Terrano Cars & Trucks

1 Answer

Hi have a 92 nissan pulsar n14 gli and the odomiter works and then stops everything else in the das works spedo temp fuel, any ideas it's not the cogs, and where is the relay for these ? checked all...


a comon problem with nissans is speedo &rev counter pointer needles warp and get stuck on the instrument face.if this is happening with yours u need 2 remove the clear plastic face heat the needle with a hair dryer and very gently bend the needle tip out from the speedo face hold it out till needle cools ps.dont over do the heat it wont need much

Sep 11, 2011 | 1990 Nissan Pulsar

1 Answer

Nissan terrano accelerator button, whats it do??


this is the kick down for the auto trans it kicks back a gear on acceleration

Apr 13, 2009 | 1993 Nissan Pathfinder

1 Answer

Rev counter not working


Suggest that you look for the ground wire of the tachometer gauge. It maybe disconnected. Or else the gauge itself is destroyed.

Sep 26, 2008 | 1990 Nissan Pulsar

1 Answer

Fuel gauge out and speedo


start at the fuse box.usually with the gas guage its going to be a short in the wire between the tank and the front of the car

Aug 10, 2008 | 1990 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...