Question about 2005 Chrysler PT Cruiser

Open Question

PT CRUISER TRUNK LIGHT STAYS ON WHICH ALSO CAUSES MY DOME LIGHTS TO STAY ON

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
bunnydawg
  • 5158 Answers

SOURCE: Warning lights PT cruiser

that is likely the check engine light. if you live near an autozone they will scan it for codes (free) and that should tell you why the light came on

Posted on Mar 18, 2009

Ad
sandanrosie
  • 53 Answers

SOURCE: No tail lights on 2007 pt cruiser

check the bulbs the filiments could be broke, do you have a third brake lightand is it working this will help rule out a brake switch

Posted on Aug 28, 2009

johnjohn2
  • 5763 Answers

SOURCE: 2001 PT Cruiser radio quit working. had replaced

pull and check all connections if all is good then radio is bad again.

Posted on Nov 01, 2009

  • 740 Answers

SOURCE: The dome light in my 2007 PT Cruiser will not go

first check to make sure your dimmer swtch is not turned up all the way this is the small wheel that turns the dash lights brighter. if this is not the problem then you have a bad switch at one of the doors. unplug the the door switch at each door till the light goes out this is the one that is bad

Posted on May 17, 2010

  • 111 Answers

SOURCE: 2004 Chrysler PT Cruiser - chuggs at stop lights -

Hi there are many things that could cause these problems.
It could be a fuel or ignition fault ( most likely its an electrical fault, coil or one of the many sensors
which control the engine )
The best way forward is to get a dianostic check done ( code reader ) as this will pin point the
problem and save you money by replacing only whats needed.
I hope i have been of some help to you.
John ( South Wales UK )

Posted on Jun 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dome light stays on when hatch is closed on my 2005 pt cruiser.


often there is a switch on the dome light that turns the light on, off, or on when a door is open. locate the switch and move it to the position when door is open.

Oct 26, 2013 | Cars & Trucks

1 Answer

My dome light doesn't shut off, neither does the trunk light.pt cruiser 2005


I would guess its the timer that supposed to hold the lights on a minute or two after the door is closed.

Aug 03, 2012 | 2005 Chrysler PT Cruiser

1 Answer

Dash lights


On the Multi Function Control Lever (Turn signal Switch lever) there should be a center section that will rotate to control the dash panel light brightness, and dome light.

Jan 26, 2012 | 2004 Chrysler PT Cruiser

1 Answer

My interior lights in my 2007 pt cruiser wont go off. I had to pull the bulbs out of the dome and reading lights so the battery wouldnt go dead can you help me?


There is a short in the wiring of your interior lights. The wire has come loose and is now shorting against the metalic roof of your car. Remove the interior light from the roof enough so you can see the wires. Make sure the contacts are secure to the pins in the bulbs

Mar 18, 2011 | 2003 Chrysler PT Cruiser

1 Answer

The dome light in my 2007 PT Cruiser will not go off. There are no switches on the dome light itself and I can't get the lens off to take the bulb out??? HELP!


first check to make sure your dimmer swtch is not turned up all the way this is the small wheel that turns the dash lights brighter. if this is not the problem then you have a bad switch at one of the doors. unplug the the door switch at each door till the light goes out this is the one that is bad

May 17, 2010 | 2003 Chrysler PT Cruiser

2 Answers

Door light and Interior light comes on-01 PT Cruiser


Hey there, I'm the guy with the same type problem that posted above you. You can turn off the dome light by the switch on the turn signal stalk (lever). Just rotate it to the "off" position. The interior lights on the dash and console will be dim, but you will barely be able to see the speed etc. Thats what I do.
As for the dome light staying on. Sounds like your problem is in the switch itself. I would start at the one that was just adjusted. with the door open you can flip the ting switch (the latch that closes the door) with a screwdriver and it will simulate the door being closed so you can fool with it while open.
Sounds like it could use some adjustment as it's not closing completely. It's 3 torx screws. loosen them and move the switch around a bit (you can get a little play) as the front door switch is in the latch itself. Hope this helps! and of course, if somone else has ideas please feel free to send to me, as I can't find where my switch is grounding. I'm guessing the BCM but can't find where. It's sad too, because I'm starting to really hate this car. Overheating, transmission leaks, now this...

Jul 03, 2009 | 2001 Chrysler PT Cruiser

1 Answer

Fog lights came on; can't turn them off


1.At first take out the foglight's fuse before you battery is dead. (Fog lights stays "ON" even you leave the car).

2.You must replace the Multifunction control switch =(

Here is the photo of problem:
http://www.ptcruiser.fi/ptgalleria/albums/userpics/10010/normal_sumuvalokytkin.jpg

Fog lights are connected to pin 13,14.
Fog light switch is "B". Because the current is many Amps, contact surfaces are heating up.
After that the contact opening "C" is melting (made of plastic) so the fog light stays "ON".

May 11, 2009 | 2002 Chrysler PT Cruiser

1 Answer

2004 PT Cruiser dome light doesn't work


If there is a switch on the dome light, that may be your problem. You would need to remove the assembly and check for voltage coming into the switch using a voltmeter with the door open.

May 30, 2017 | 2004 Chrysler PT Cruiser

Not finding what you are looking for?
2005 Chrysler PT Cruiser Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8575 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...