Question about Cars & Trucks

2 Answers

Riddle solver What has wings, But can not fly. Is enclosed, But can outside also lie. Can open itself up, Or close itself away. Is the place of kings and queens, And doggerel of every means. What is it upon which I stand? Which can lead us to different lands.

Posted by Anonymous on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,961 Answers

A theatre stage !

Posted on Jul 23, 2015


  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Equinox tailgate seems to be locked and will not open


May have been packed too tight, or something shifted as door was closing and became lodged in either the locking mechanism or the side supporting latched to the left and right lower edges of the door. Try applying some pressure to the outside of the door while turning the key. If you are trying to use the Key fob to open, the stuck position will not allow lock to disengage at all. If that does not work, have someone crawl inside and push while someone outside turns the key.
Silly question but, I need to ask, what is the temp. outside? There is also the very real possibility that, the door seal itself has been frozen to the painted mating surface along the jamb of the door. You would need to park in above freezing temp (full sun will work sometimes) if this does work, get some silicone sprayed on a rag (fairly wet) and wipe down the painted mating surface where the seal meets the jamb. Good luck

Dec 22, 2014 | 2008 Chevrolet Equinox LS

1 Answer

Whose the singer to these words


i believe dionne warwick but its very close lyrics to "we are the world " multiple artists

Sep 28, 2014 | Cars & Trucks

1 Answer

Trunk on my 07 legacy sedan will not close.


better to adjust the trunk lock mechanism by trained person.

Nov 24, 2013 | 2007 Subaru Legacy 2.5i SE Sedan

1 Answer

Rear passenger door won't stay closed


Door latch on door itself is in closed position if it will not close at all. In this case, open door and pull outside handle hard to pop open door latch. If you have door opening at random, door latch needs replacing or door catch on body is loose.

Jul 29, 2012 | 2003 Chevrolet TrailBlazer

1 Answer

How to replace rear view mirror


Instructions
1


Disconnect your negative battery cable, if your Ford Focus has power side mirrors. If it has manual side mirrors, disconnecting the battery is unnecessary.

2


Pry off the wing mirror's inside sail panel (shaped like a triangle). Insert a trim panel tool between the door skin and the plastic panel to pry it off.





3


Carefully pull the sail panel away, minding the wiring if the mirror is power-operated. Unplug the electrical harness and set the panel aside.

4


Open the door and hold the outside part of the wing mirror steady. Remove the mounting bolt with a socket wrench, and then remove the mirror screw with a Phillips screwdriver (the mirror bolt and screw is visible with the panel removed).

5


Pull the wing mirror assembly from its mount (from the outside). Insert the replacement mirror assembly in place; tighten the bolt and the screw.

6


Attach the wiring connection to the replacement mirror. Position the sail panel in place and push it against the door to snap it back on.

Apr 18, 2012 | 2005 Ford Focus ZX3

2 Answers

Have no users manual and i'm not sure how you would replace the light bulb on the brake light


Change the Rear Brake Lights
  • Open the trunk and twist the retaining wing nuts off the studs holding the carpeted trim cover in place on the back side of the tail lamps.
  • Pull the carpeted trim cover out of the way and pry the plastic caps out of the holes with the screwdriver tip.
  • Unbolt the nuts holding the tail-lamp assembly in place using the socket set.
  • Pull the tail lamp assembly away from the body of the Stratus. Grab the socket for the bulb in question and twist it counterclockwise to remove it. Pull the old bulb out by hand and insert the replacement bulb. Reinstall the socket in reverse of removal.
  • Push the tail lamp assembly back into position and tighten the nuts back down onto the retaining studs using the socket set. Pop the plastic caps back into the holes, pull the carpeted trim cover back into position and reinstall the plastic wing nuts. Close the trunk.

Jul 21, 2011 | 2006 Dodge Stratus

1 Answer

2002 ford taurus check engine lite code is po460, a mechanic replaced the fuel pump, still didn't pass inspection......please help!


I am going to paste a list of potential causes for a p0460. There is a cure for a dirty reader card and Ford recommends CHEVRON TECHRON fuel system cleaner. Run tank low, put in cleaner, use best gas you can find,avoid your frequent brand.

02-06-2006 06:19 PM #2 TXFO user-offline.png Not Special Enough txfo.gif?dateline=1249691143 Join Date Jul 2002 Location New Braunfels, TX Posts 13,976 icon1.png Re: Fuel level sensor circuit malfunction (P0460)? P0460 - Fuel Level Sensor Circuit Malfunction The PCM monitors the fuel level input (FLI) circuit for electrical failure. The test fails when the signal moves outside the minimum or maximum allowable calibrated parameters for a specified fuel fill percentage in the fuel tank. Empty fuel tank
Fuel pump (FP) module stuck open
Incorrectly installed fuel gauge
Damaged instrument cluster
CASE GND circuit open
FLI shorted to VPWR
Damaged PCM
Overfilled fuel tank
Fuel pump (FP) module stuck closed
Damaged fuel gauge
FLI circuit open
FLI circuit shorted to CASE GND or PWR GND
CSE GND shorted to VPWR
Monitor FLI PID and FLI V PID in key ON engine RUNNING. FLI PID at 25% fill (with non matching fuel gauge) and FLI V PID less than 0.90 volts [for FLI PID at 75% fill (with non matching fuel gauge) and FLI V PID greater than 2.45 volts] indicates a hard fault.

Jul 13, 2011 | Ford Taurus Cars & Trucks

1 Answer

Loose wing mirrow


Check this guide as reference for solve ypur problem; this is one DIY about replace Wing Mirror...
1.- Disconnect your negative battery cable, if your Ford Focus has power side mirrors. If it has manual side mirrors, disconnecting the battery is unnecessary.
2.- Pry off the wing mirror's inside sail panel (shaped like a triangle). Insert a trim panel tool between the door skin and the plastic panel to pry it off.
3.- Carefully pull the sail panel away, minding the wiring if the mirror is power-operated. Unplug the electrical harness and set the panel aside.
4.- Open the door and hold the outside part of the wing mirror steady. Remove the mounting bolt with a socket wrench, and then remove the mirror screw with a Phillips screwdriver (the mirror bolt and screw is visible with the panel removed).
5.- Pull the wing mirror assembly from its mount (from the outside). Insert the replacement mirror assembly in place; tighten the bolt and the screw.
6.- Attach the wiring connection to the replacement mirror. Position the sail panel in place and push it against the door to snap it back on.

Hope helps (remember comment and rated this). TY for using Fixya.

Jun 26, 2010 | 2000 Ford Focus

2 Answers

The electric wings will not drop when letting the top down.


I have the same problem with my car. I just bought a 2004 VW Beetle and have never owned a convetible before. So when I saw the wings I asked if this was normal. The mechanic at the dealer said that on the 04 those wings do not retract when the top is down, only when the top is closed. Now my car will beep when I start driving because the top is not down all the way, also the indicator light shows a blinking car in the temp display letting me know the top in not down all the way. I read a solution from someone else and it said to keep keep the button to open the top pressed or pulled.......whichever is the way to open it...until the motor stops, but that did not work. So I decided to do a little research online and saw pictures of 2004 convertible VW beetles with the top down....low and behold the wings were retracted when the top was down. So the mechanic at the dealer lied. If these people do not know what their cars do and don't do, they should not be working there. They are compltley neglagant and incompitent. If anyone has an ansewr for me, it would be appreciated.

Oct 03, 2009 | 2003 Volkswagen New Beetle Convertible

2 Answers

Our Chat


I dont know with who you chat with, but its very nice to hear that you had fun, its important!

Jun 15, 2008 | Volkswagen Beetle Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

222 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...