Question about Cars & Trucks

Open Question

How to reset low washer fluid message on pontiac g6

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: engine light 2006 pontiac g6(reset)

first be sure that its the engine light and not the "service" light. the service light will usually illuminate if its time for an oil change. if its the service light ur owners manual should tell u how to reset it. if its ur engine light then try disconnecting ur positive battery cable for 1 minute. that should reset ur ecm and get rid of the engine light. if the engine light comes back on then have a diagnostic scan done to determine whats causing it. LJ

Posted on Dec 29, 2008

Ad
emissionwiz
  • 77499 Answers

SOURCE: transmission fluid for 2007 pontiac G6 GT

This car does not have a auto trans dipstick, the level can only be checked by the dealer, this is a growing trend that started with most German cars, the filter is inside the trans pan and only needs changing every 60,000 miles.

Posted on Jan 06, 2009

Molson02536
  • 3854 Answers

SOURCE: I cannot get the Change Oil Soon message to reset

Chevrolet Malibu, Malibu Maxx 2004-06; 2006 HHR, Cobalt, Pontiac G6, Solstice
Turn ignition to run engine off. Display OIL LIFE RESET in the Driver Information Center (DIC). Press and hold the ENTER button for at least one second. An ACKNOWLEDGED’ display message will appear for three second or until the next button is pressed. This will tell you the system has been reset. Turn the key to OFF. If the “CHANGE ENGINE OIL” message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

Posted on Jul 17, 2009

355ttrex
  • 249 Answers

SOURCE: Transmission fluid

You can change the fluid by removing the pan and replacing the fluid with the correct exact amount through a fill cap on the top of the trans. The pcm will display a maintenance required light on the dash if the fluid level is low.
That's all there is to it.

Posted on Jul 29, 2010

  • 248 Answers

SOURCE: what size tubing do I

A 2009 Pontiac G6 uses the following windshield washer hose:

* 4 X 1mm (OEM Part #: N 20 301 1 5M)

Please see the attached link for additional information.
http://www.carpartsdiscount.com/auto/parts/2009/pontiac/g6/washer_hoses_filters/crp_windshield_washer_hose_4_x_1mm.html?3593=120863

Posted on Feb 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Going up a hill, traction and break lights comes on (service traction-break fluid) message on my screen, got to top of hill and slowed down, lights came off. 2008 pontiac g6


Make sure your brake fluid is at the correct level. Any issue with the brake system will cause the traction system to not work as traction control works by modulating the brake on the wheel (s) that are slipping. If fluid level is fine then the sensor for the fluid level may be bad.

Jul 27, 2016 | 2008 Pontiac G6

2 Answers

How to drain power steering fluid on 2007 pontiac g6


The 2007 Pontiac G6 does not have power steering fluid. It has electric power assisted steering. No power steering fluid to ever have to change.

May 02, 2015 | 2007 Pontiac G6

1 Answer

Window washer


this tells me the jets are blocking get a needle and clean the hole in the jets

Sep 02, 2012 | 2007 Pontiac G6 GT Convertible

1 Answer

2006 pontiac g6 gt low brake fluid light stays on it's full of fluid


did you check to make sure the E-brake is fully retracted?

Feb 07, 2012 | Pontiac G6 Cars & Trucks

2 Answers

What size tubing do I need for a 2009 pontiac g6 wind shield washer fluid tubing.


A 2009 Pontiac G6 uses the following windshield washer hose:

* 4 X 1mm (OEM Part #: N 20 301 1 5M)

Please see the attached link for additional information.
http://www.carpartsdiscount.com/auto/parts/2009/pontiac/g6/washer_hoses_filters/crp_windshield_washer_hose_4_x_1mm.html?3593=120863

Feb 22, 2011 | Pontiac G6 Cars & Trucks

1 Answer

How do you reset caliper piston on the rear of a Pontiac G6 2006 car?


YOU NEED LARGE C - CLAMP TO COMPRESS PISTON IN CALIPER BORE.REMOVE SMALL AMOUNT BRAKE FLUID FROM BRAKE MASTER CYLINDER RESERVOIR FIRST BEFORE YOU COMPRESS PISTON. AFTER REMOVING A LITTLE BRAKE FLUID.AND COMPRESSING CALIPER PISTON IN BORE.PLACE MASTER CYLINDER RESERVOIR COVER BACK ON.WHEN FINISHING REPLACING BRAKES.PUMP BRAKE PEDAL UNTIL BRAKES FEEL SOLID AND FIRM CHECK BRAKE FLUID LEVEL.DONT DRIVE VECHICLE IF BRAKES DONT FEEL FIRM OR SOLID.

Oct 10, 2010 | 2006 Pontiac G6

2 Answers

I cannot get the Change Oil Soon message to reset on a Pontiac G6


Chevrolet Malibu, Malibu Maxx 2004-06; 2006 HHR, Cobalt, Pontiac G6, Solstice
Turn ignition to run engine off. Display OIL LIFE RESET in the Driver Information Center (DIC). Press and hold the ENTER button for at least one second. An ACKNOWLEDGED’ display message will appear for three second or until the next button is pressed. This will tell you the system has been reset. Turn the key to OFF. If the “CHANGE ENGINE OIL” message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

Jul 17, 2009 | 2007 Pontiac G6 GT Convertible

1 Answer

Hi! the Driver Information Center/DIC/ Pontiac G6 GT 2005year a massage such as Power steering , where is problem? waldemar from Poland.


Sounds like your power steering fluid is low. You will find the pumps reservoir under the hood.

Jul 03, 2009 | 2009 Pontiac G6

1 Answer

The power steering to my Pontiac G6 2006 keeps locking up when I turn sharp corners or pull in and our of parking spaces. What could be causing this?


if you have hydraulic steering, might be damaged components or low fluid if you have the dreaded electric steering, also could be a failing component Either way, have it checked immediately (despite a 2 year response).

Jun 24, 2009 | 2006 Pontiac G6

2 Answers

I have a pontiac g6 and my change oil light has been on. i went and got a oil change and nothing happened and i cant see where to put the tRANSNISSION FLUID??


With the "CHANGE OIL SOON" message displayed, press any of the three DIC buttons to clear the "CHANGE OIL SOON" message. Display "OIL LIFE RESET" on the DIC. Press and hold the "ENTER" button for at least one second. An "ACKNOWLEDGED" display message will appear for three seconds or until the next button is pressed. This will tell you the system has been reset. Turn the ignition to "OFF". If the "CHANGE OIL SOON" message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure. on the 3.5 liter you have a dipstick near fire wall

Jun 13, 2009 | 2006 Pontiac G6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...