Question about 1992 Mitsubishi Mirage

Open Question

Transmission for 4g15 carburetor engine

What types of automatic transmissions will work on a 4g15 Carburetor engine?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Carburetor Tuning Mitsubish.

As far as i know, original stock carburetor for Lancer 1989-1992 engine 4G15 12 valve is Aisan Variable Venturi. It have 3 screws :
- air-fuel mixture screw
- main jet adjusting screw
- idle adjusting screw

and here's the document you may need :
http://www.mitsubishi-motors.kiev.ua/info.php?id=20
http://www.lilevo.com/mirage/

Good luck !
Winz

Posted on Sep 11, 2009

Ad
  • 1779 Answers

SOURCE: mechanic mistakenly put gear oil in tank, the pump is knocking

What the heck did he think he was putting in the tank? Gear oil is very thick and heavy, so the fuel pump may have a problem as it is meant to pump gas, which is not thick and heavy like gear oil. There was probably some gear oil in the tank while the pump was operating, and it pumped some gear oil for a short time, which damaged it. Insist that the 'mechanic' replace the fuel pump at no cost to you ,and find a new mechanic for future repairs. Good luck.

Posted on Nov 09, 2009

  • 2309 Answers

SOURCE: I have a 1990 mitsubishi magna sedan with

may be a problem with the accelerator pump, find a good carb man

Posted on Nov 24, 2009

  • 11 Answers

SOURCE: When my Mitsubishi galant 97 carburetor car moves

Best solution is to move the carburetor back onto the transmission and bolt it down tightly. The transmission shouldn't neutral up unless the car is brown or other neutral color. If you paint stripes on the car there wont be any more neutralling up and may even fix what's wrong with your brain.

Posted on Jul 02, 2010

alicantecoli
  • 22156 Answers

SOURCE: what is the right tuning

no tuning can be done as its all fixed jets apart from the idle which can be adjusted to a CO2 level less than 2% for the emmisions on the annual vehicle mechanical inspection

Posted on Aug 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1980 Classic. Do transmission and carburetor work together?


carburetor is a part of the engine only, except some trans have a connection to carb for passing gear

Oct 03, 2015 | Chevrolet Caprice Cars & Trucks

1 Answer

What size of water jacket is fitted to lancer 4G15 engine?


I'm unclear what you actually need to know. The 4G15 came with two radiator sizes, about 12" wide for cars without A/C, and about 22" wide for cars with A/C or automatic transmission.

The coolant capacity is 5 6 liters.

Feb 26, 2015 | Mitsubishi Cars & Trucks

1 Answer

Where dose the vaccum line come from that goes to the transmission


It depends on the vehicle if it is older and has a carburetor it will come off the carburetor or the intake the carburetor sits on.Best way is to trace the hose from the transmission to see exactly where it goes.

Oct 20, 2013 | Cars & Trucks

1 Answer

Diagram of connection of a G30 1986 van carburetor need vacumn hose connection diagram to reconnect carburetor with a 350 engine and quatro jet carburetor


I find this vacuum diagrams for 1986 Chevrolet Truck G30 1 ton Van 5.7L 4BL 8cyl (click over pic for zoom)...

zjlimited_515.jpg

Fig. 136: 1986 5.7L engine-Federal with automatic transmission (G10, 20 and 30 models)

zjlimited_516.jpg

Fig. 137: 1986 5.0L and 5.7L engines-California with automatic transmission (G10, 20 and 30 models)

zjlimited_517.jpg

Fig. 138: 1986 5.7L engine-Federal with manual transmission (G30 heavy duty models)

zjlimited_518.jpg

Fig. 139: 1986 5.7L engine-Federal with automatic transmission (G30 heavy duty models)

zjlimited_519.jpg

Fig. 140: 1986 5.7L engine-California with manual transmission (G30 heavy duty models)

zjlimited_520.jpg

Fig. 141: 1986 5.7L engine-California with automatic transmission G30 (heavy duty models)


Hope this helps; keep us updated.

Jan 20, 2011 | 1986 Chevrolet G20

1 Answer

I have a 1996 lance with a 4G15 engine that carries an Asian carburetor,i have tryed everything to stop it from running on after i turn of the ignition which it does sometimes ,i have even change the...


1) Warm up engine first(run 5-10 mins)

2)Shut off engine

3) Back out on the idle speed screw until it justt doesn\'t touch the throttle linkage. Then screw it in back about 11 turns

4) Screw in the A/F mixture screw until it stops(do not force tighten)

5) Screw out the A/F mixture screw 2 full turns

6) Start the car. It will run like its choking. As long as it\'s running it\'s ok.

7) Now turn in the A/F screw until engine dies. If this happens, turn
out the A.F screw half turn at a time to bring it back. (try to start
the car of coz)

8)Continue to turn out the A/F screw at half turns every 3 seconds.
Engine will pick up speed. Continue to screw out until the point engine
runs worse. When that happens screw back in half turn every 3 secs to
the point engine runs smoothest.(do this by ear or watch engine
vibration)

9) Now set the idle speed. Go on the air conditioner. Watch the
tachometer. Turn in the idle speed screw until rpm is around 900 to 1000
rpm.

10) Now it\'s ready to rumble..

Jan 08, 2011 | 1992 Mitsubishi Mirage

2 Answers

I can not find location of Transmission kickdown solenoid for 1999 GMC Seirra 5.3 liter,4/4


this sensor is integral to the transmission. it is not an external serviceable item.

Aug 02, 2010 | 1999 GMC Sierra

1 Answer

Will idle but when put in gear and moved will die


IDLE SPEED TO LOW.MANUAL TRANSMISSION IDLE SPEED IS 750 RPM AND AUTOMATIC TRANSMISSION IDLE SPEED IS 850 RPM.IF IDLE SPEED IS CORRECT YOUR PROBLEM COULD BE STOPPED UP FUEL FILTER OR FAULTY SPARK PLUGS AND WIRES.YOUR IGNITION TIMING IS OFF.YOU COULD HAVE INTAKE VACUUM LEAK AT INTAKE MANIFOLD OR EGR VALVE GASKET LEAKING OR BAD FUEL INJECTOR IF YOU HAVE FUEL INJECTION.FAULTY MECHANICAL FUEL PUMP IF CARBURETOR.ALSO CARBURETOR FLOAT BOWL TOO LOW.

Feb 15, 2010 | 1991 Toyota Pickup

2 Answers

I have a 1990 mitsubishi magna sedan with automatic transmission. It has a carburetor rather than the fuel injection and has traveled very low kilometers for its age. The problem I have is that when...


ya..accelerator pump is the prob....to see this problem..turn off your engine...open the air cleaner and see from above the carburetor and look inside...then pull the accelerator cable...if a healthy carb you can clearly see the carb squirting fuel..if you dont see any or poor squrting that is the problem...need replace or try carburetor cleaning to unblock the squirt hole...

Nov 23, 2009 | 1987 Mitsubishi Passenger

4 Answers

Carburetor Tuning Mitsubish.


As far as i know, original stock carburetor for Lancer 1989-1992 engine 4G15 12 valve is Aisan Variable Venturi. It have 3 screws :
- air-fuel mixture screw
- main jet adjusting screw
- idle adjusting screw

and here's the document you may need :
http://www.mitsubishi-motors.kiev.ua/info.php?id=20
http://www.lilevo.com/mirage/

Good luck !
Winz

Mar 23, 2009 | 1992 Mitsubishi Mirage

Not finding what you are looking for?
1992 Mitsubishi Mirage Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...