Question about 2004 Ford Freestar
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: rear axle leaking
Block the front tires. Break the rear lugs loose. Jack up the rear of the truck at the center if possible. remove the wheels & brake drums. Remove the brake shoes,return springs & all the other hardware. Remove the differential cover & drain oil. If you have a posi the next step sucks. You need to remove the threaded pin from the housing & remove the axle retaining clips. All the while,being carefull of the spring in the posi unit. If no posi,then same procedure,minus the "pucker factor". After the axle is out,take a large flat blade screw driver or pry bar & pop the seal out. Keep in mind the axle bearing is probably gone too , so that's another procedure. Keep it apart,you'll be glad you did.
Posted on Jun 23, 2009
I'm assuming all of the brake lights are on? If so there is a brake light switch located way up under the dash that hits on the arm for your brake pedal. If this is not "closed" when the pedal is up (not depressed), your brake lights will stay on. It is adjustable.
Posted on Jul 29, 2009
Open the petcock on the bottom of the radiator and allow the old coolant to drain.
Close the petcock.
To refill you will first fill the degas container to the cold fill range, leave the cap off the canister. Turn all of the heater controls to warm and turn fan to full. Idle the engine until the thermostat opens. Top off the coolant and put the cap back on. Idle at 3000 RPM for several seconds and then idle again for a minute or so. Check the level and then repeat this 4 times, or until heat is coming from the front and rear heat units.
If you want to flush the system you will have to remove the thermostat and hook up your flush system to the radiator hose at the thermostat housing. Follow the instructions on your flush system then put the thermostat back in. Follow the instructions above to refill.
Posted on Jan 09, 2010
Tips for a great answer:
May 21, 2014 | 2004 Ford Freestar
Nov 21, 2013 | 2004 Ford Freestar
Feb 15, 2012 | Ford Freestar Cars & Trucks
Jan 31, 2012 | 2004 Ford Freestar
Jan 03, 2012 | 2006 Ford Freestar
Apr 25, 2017 | 2004 Ford Freestar
Apr 06, 2010 | 2004 Ford Freestar
Aug 01, 2009 | 2004 Ford Freestar
Feb 18, 2009 | 2004 Ford Freestar
Jul 06, 2008 | 2004 Ford Freestar
97 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: