Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
i had used three bolts they have to be 6mm thik and like about 6 inches long then you install some flat washers by the head and use a regular crank pulley remover, you'll see three little holes inside the groevs at front side of pulley and there is where you install the bolts
Posted on Oct 19, 2008
SOURCE: BAD HARMONIC BALANCER
To remove the harmonic balancer on my 1992 Pathfinder, I needed to loosen the alternator and power steering belts, remove the cooling fan (4 10 mm nuts), remove the radiator (2 10 mm bolts hold it to the frame, remove top and bottom hose [The drain **** is covered by what appears to be a coolant line], as well as the overflow tube to the reservoir. With a 3/4" impact gun and a 27 mm socket, remove the bolt that retains the alt, ps shieves and the harmonic balancer to the crankshaft. With a large 3 jaw puller, remove the harmonic balancer with the pully sheives as an assembly. I do not recommend attempting the removal without the puller.
To put it back on, you will need a large torque wrench for the crankbolt and a small torque wrench for with a crowsfoot for the fan nuts.
Posted on Dec 01, 2008
You can try simply wiggling the balancer and see if you get lucky. A few taps with a rubber mallet may convince it to come free. Worst case get the kit. You should not need to remove the radiator. Do make sure that you have the engine blocked so you don't lose your timing mark placement.
Posted on Mar 12, 2009
Click on the link below and enter the engine size. You will be taken to another page. Under the part number, there will be a Routing Diagram link to give you your diagram. Best of luck.
Posted on Jun 19, 2009
There is a panel inside the wheel well that you can take off that gives you perfect access to the harmonic balancer. A special tool is required. i had my dad make one because he has access to whatever he needs at the factory. but you can get them at the dealer. i have no clue how much they cost. I can't see any way of doing it without the special tool. after you get the tool its pretty simple to get off. it takes alot of force to break the bolt loose though. i used the handle off my jack as a cheater bar. hope this helps...
Posted on Jun 29, 2009
Tips for a great answer:
Dec 20, 2014 | Cars & Trucks
Dec 20, 2014 | Cars & Trucks
Jul 23, 2013 | Cars & Trucks
May 01, 2012 | Hyundai Motor 2004 Sonata
Feb 28, 2010 | 1997 Cadillac Eldorado
Jan 24, 2010 | 1998 Cadillac Eldorado
Dec 01, 2009 | 1998 Mitsubishi Eclipse
Jun 28, 2009 | 1989 Oldsmobile Ninety Eight
59 people viewed this question
Usually answered in minutes!