Question about 2001 Mitsubishi Galant

Open Question

Evap canister location, 2001 Mitsubichi Galant

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: where is the fuel filter located in the 2001 mitsubishi galant?

can you tell me where the fuel filter is located on a 01 mitsubishi galant?

Posted on Mar 27, 2009

  • 3 Answers

SOURCE: Leak in evap system, where and what is an evap system. 2001 mitsubishi Galant

I have the same failure that occurred when smogging my Ford Ranger. The EVAP test was just added a couple of years ago and it tests for leaks in the gas tank vapor recovery system. What this is a system of vapor recovery lines that connect from the gas tank and goes to a canister then returns to the intake and on the next engine start and gets used, instead of leaking into the air.

The only issue is these lines can develop a leak at any of the connection points or along the rubber portions and can be a pain to replace depending on your application. So until you fix the leak you will fail this test since they pressurize the system and if there is a leak it won't hold the pressure.

Posted on May 22, 2009

  • 249 Answers

SOURCE: oil pump 2001 mitsubishi galant 3.0l

oil pump should be inside the oil pan!!!!!!!!!!!!!

Posted on Jan 01, 2010

ZJLimited
  • 17970 Answers

SOURCE: Crank Shaft Position Censor for

This replacement part is around US$ 50.00; check the right part in THIS LINK

Hope helps.

Posted on Jan 03, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

PO442 code on my 2004 mit galant,LS V6 3.8 how to fix an evap problem small leak


the causes for the small leak are listed as
hose connections --intake leak--- EVAP canister--- EVAP canister purge valve
check hoses for small cracks ( old hoses) or replace the purge valve

Sep 19, 2016 | 2004 Mitsubishi Galant

1 Answer

What are the probable causes for DTCs P0440 P0441, and P0446?


code p 0440 refers to EVAP system--system malfunction==causes --hose connections --intake leak---EVAP canister purge valve
code p 0441 refers to EVAPO system --incorect flow detected ====causes --hose connections ---intake leak---EVAP canister purge valve
code p 0446 refers to EVAP system---vent control--circuit malfunction====causes wiring---EVAP canister purge valve ---ecm
replace the purge valve
as to where it is , the location will be in the workshop manual or have a shop point it out to you.

Aug 29, 2015 | 2001 Toyota Camry

1 Answer

Toyota echo won't start code 440 441 446


Error Code: P0440
Fault Location:
Evaporative Emission (EVAP) System - Malfunction
Possible Cause:
Malfunction Indicator Lamp (MIL) active.
Soution:
Check Evaporative Emission (EVAP) System Sealing.
Check Evaporative Emission (EVAP) Canister Purge Regulator Valve .
Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve .

Error Code: P0441
Fault Location:
Evaporative Emission (EVAP) System - Incorrect Flow Detected
Possible Solutions:
Check Evaporative Emission (EVAP) Canister Purge Regulator Valve .
Perform Output Test.
Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve .
Check Evaporative Emission (EVAP) Canister.
Perform Basic Setting.
Check Pipes between Tank Breathing and Throttle Body.

Error Code: P0446
Fault Location:
Evaporative Emission (EVAP) System, Vent Control - Circuit Malfunction
Possible Cause:
Wiring harness.
Evaporative emission (EVAP) canister purge valve.
Engine control module (ECM).

Feb 25, 2013 | 2002 Toyota ECHO

1 Answer

Where is the Vapor Canister on 2002 mitsubishi galant


its in the rear of the car near the fuel tank

Aug 12, 2012 | Cars & Trucks

1 Answer

I have a 2001 Mitsubishi Galant and my son received 4 codes off of the programmer. The recent one is P0300, then the next 3 are P0441, P0335, P0455. Can you tell me what the codes stand for


A code P0300 may mean that one or more of the following has happened:
  • Faulty spark plugs or wires
  • Faulty coil (pack)
  • Faulty oxygen sensor(s)
  • Faulty fuel injector(s)
  • Burned exhaust valve
  • Faulty catalytic converter(s)
  • Stuck/blocked EGR valve / passages
  • Faulty camshaft position sensor
  • A code P0441 could mean one or more of the following has happened:
    • Bad vacuum switch
    • Broken or damaged EVAP line or canister
    • Open in PCM purge command circuit
    • Open or short in Voltage feed circuit to Purge Solenoid
    • Faulty purge solenoid
    • Restriction in EVAP solenoid, line or canister
    • Corrosion or resistance in purge connector
    • Bad PCM
    Defective computer

Mar 13, 2011 | Mitsubishi Galant Cars & Trucks

1 Answer

2001 Rodeo smells like gas constantly and the gas mileage has went to ****, can't locate any leak what so ever? Just started a couple months ago and slowly noticed the gas mileage. Someone told me after...


CHECK EVAP SYSTEM CHECK EVAP CHARCOAL CANISTER COULD BE GAS SOAKED. OR THE PURGE CONTROL SOLENOID NOT WORKING.ITS NOT CONTROLING FUEL VAPORS FROM CANISTER TO INTAKE MANIFOLD.

Jan 24, 2011 | 2001 Isuzu Rodeo

1 Answer

2001 Escort vacuum canister location


The EVAP charcoal canister is located in the rear driver fender-well. You can see it from under the car, just follow the hoses.

Sep 04, 2010 | 2001 Ford Escort ZX2

1 Answer

Were is the evap located on 2001 Chevy s-10 blazer with v6


The EVAP service port is located in the EVAP purge pipe between the EVAP purge solenoid and the EVAP canister. The service port is identified by a green colored cap.

47e8f38.jpg

Fig. Showing location of (1) Evaporative Emissions (EVAP) Canister Purge Solenoid and (2) Exhaust Gas Recirculation (EGR) Valve


4d7b3e9.jpg

Fig. EVAP Purge valve solenoid (3) mounting bolt (2) and insulator (1) on 2000-2005 4.8L, 5.3L, 6.0L Engines

Hope this help (remember rated the post).

Mar 26, 2010 | 2001 Chevrolet Blazer

1 Answer

Coded code po442 small leak in evap. says book two days later code455 large leak in evap.system


Check your hoses, esp. where they go into the carbon canister. I have a 2001 fullsize 3.9 work series truck and had the same problem. On mine, I had to remove the canister before I could see the cracked hose. It was the hose that runs from the canister to the hard plastic line on the frame. On the fullsize, the canister is located under the pass side cab rear corner.

Oct 04, 2009 | 2000 Dodge Dakota Quad Cab

2 Answers

Need to find the evaporation emision valve


please explain in plain queens english as to what this valve is or what it does please ,never heard of this before,is it measuring the amount of evaporation of fuel in the inlet manifold?? the evaporation of the fuel in the tank ??

Mar 05, 2009 | 2001 Chevrolet Malibu

Not finding what you are looking for?
2001 Mitsubishi Galant Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...