Question about 2011 Land Rover Rover Range

1 Answer

Reset low tire

I put new tires on and I don't know how to reset the low tire pressure.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 42 Answers

Must be something new. I have never reset low tire pressure. The recommended tire pressure for the vehicle with the correct size tires that came on the vehicle should be in the car manual and posted on the vehicle inside the door jams usually.

Posted on Nov 05, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

(....) A sign like what i have shown always pops up on my Toyota Runx, what could be the problem?


i kinda looks like the low tire pressure light reset the tire pressure some models need a reset but i don't know what your working on

Aug 20, 2012 | Cars & Trucks

1 Answer

After putting the correct preasure on the tire and resetting the tire preasure light it's still on


Don't spend money taking it to a mechanic or dealer. Lower the spare a correct the pressure in it. Then reset the pressure light. All these Lexus tire sensors are little transmitters sending a signal to your car's receiver. Had the same problem and solved it this way.

Jan 05, 2012 | 2007 Lexus RX 350 FWD

1 Answer

Low tire pressure comes on the computer with exp 18 raight after it,what does this mean and how do i fix it


Don't know what "exp 18" means - please clarify.
Tire pressure on the Aurora is done via the wheel speed sensors. Regardless of whether you have proper tire pressure, you must reset the monitor by going to the DIC-->gage-->Tire Pressure and press and hold the reset button.
You should use and ODB-II scanner to check ABS codes to see if any of the wheel speed sensors are reporting errors. Often times the connectors right at the sensor get corroded and cause issues.

Nov 26, 2011 | 2001 Oldsmobile Aurora

1 Answer

How do i reset low tire indicator on rav 4 2010, i just changed tire


The TPMS lamp should go out when the proper air pressure in all tires is detected. Too much pressure will cause it to light also. The low threshold is somewhere in the 24-27lb range, dunno what the upper limit is, but one member at R4W had 44lbs, IIRC, and the lamp wouldn't go out until he dropped it back down. Some members run 38lbs and get away with it, but I run the recommended 32lbs and don't have any problems. Out of spec tire pressure does not cause the maintenance required lamp or the MIL to light up, see page 161 of the owner's manual. The maintenance required lamp will light up every 5000 miles as a reminder to change the engine oil, see page 136 of the manual for reset instructions.

Sep 10, 2011 | 2009 Toyota RAV4

2 Answers

Took 2009 fusion sel for 4 new tires at local goodyear, when returned the front end shakes, take back still shakes, take back third time and the front doesnt shake, but the turn indicators don't work,...


sounds like you had the "new kid" working on your car. its hard to find good help these days. the service adviser should have had his better technicians look at it after the first numb skull laid hands on it. as far as the lighting problems i would say it sounds like a blown fuse or an unplugged light connector. you should have your ford dealer check it out and see if it looks like something has been tampered with. good luck. and try firestone complete autocare next time. usually better managed. usually.

Jun 10, 2011 | 2007 Ford Fusion I4 SEL Sedan

3 Answers

2007 tiburon exclamation point with a horse shoe around it


The little horse shoe-looking looking thing is actually supposed to be a cross-section of a tire. That would be your Tire Pressure Monitoring System (TPMS) trying to tell you to check the pressure in your tires because it has determined that one or more of them are low.

This is covered in the Owner's Manual.
If you don't have an Owner's Manual for your Hyundai, you can get one HERE

May 11, 2011 | 2007 Hyundai Tiburon

3 Answers

My low tire light came on so I went and had air and all the tires checked but now I don't know how to turn the light off. I have had the car since 2000 and it has 50,000 miles on it but could never figure...


Hello Mattingly.

Here is some information for you regarding your problem.

The Tire Inflation Monitor (TIM) system alerts the driver when the pressure changes in one of the tires. The system only detects a low pressure condition while the vehicle is being driven. Once a low tire pressure condition is detected, the system informs the driver that a low tire pressure condition exist's, whenever the ignition is ON.
The LOW TIRE message appears on the Instrument panel if the tire pressure in one tire becomes at least 82 kPa (12 psi) lower or higher than the other three tires. The message does not appear if more than one tire is low or high, or if the system is not calibrated properly. The system does not inform the driver which tire is low. To clear this message, set the tire pressures in all four tires to the proper pressures and perform the system reset procedure. Refer to Tire Inflation Monitor Reset Procedure for service procedure.
The Tire Inflation Monitor software requires approximately one half hour of straight line driving to complete the TIM autolearn. There are several speed ranges that the EBCM needs to learn the tire inflation configuration in order to have the full capability of detecting a low tire condition. The speed detection ranges are the following:

  • 24-64 km/h (15-40 mph)
  • 64-113 km/h (40-70 mph)
  • 113-145 km/h (70-90 mph)
Each speed range has 2 modes of low tire detection.

  • Monitor Mode 1
  • Monitor Mode 2 The EBCM learns the tire inflation configuration for each speed range independently. In Monitor Mode 1, the EBCM has only partially learned the tire inflation configuration for the speed range and has limited detection capability for a low tire condition. In Monitor Mode 2, the EBCM has fully learned the tire inflation configuration for the speed range and has full detection capability for a low tire condition. If the EBCM is not in Monitor Mode 1 or Monitor Mode 2, a low tire condition cannot be detected because the EBCM has not learned the tire inflation configuration of the vehicle.

To reset (calibrate) the system:
Turn the ignition switch to RUN. Then press and hold the RESET button for about five seconds. The red RESET button is located inside the instrument panel fuse block on the right side of the dash.. The LOW TIRE light will come on and flash three times and then it will turn off.
The system completes the calibration process during driving.
The system normally takes 15 to 20 minutes of driving in each of three speed ranges to "learn" tire pressures. The speed rages are 15 to 40 mph (25 to 65 km/h), 40 to 65 mph (65 to 105 km/h) and above 65 mph (105 km/h).

There you are, this should fix you up.
Keep in mind this system uses wheel speed sensors to calculate. If one of your sensors isn't working your low tire light will remain on.

Thank you for using FixYa.

KL

Jan 20, 2011 | 2000 Buick Century

1 Answer

Low tire pressure indicator is on. I have put the


if u have the right tire pressure in the tires the light will go out . but sometimes you have to put 5 to 10 miles on the car to reset

Nov 16, 2009 | 2007 Volkswagen EOS Convertible

3 Answers

Low tire pressure light won't stay off after proper reset.


Some newer Toyota vehicles have a sensor in the spare tire. Tires loose air over time naturally. I would check out the spare.
When did this TPS light start coming on?
Have you had new tires put on, or had a flat repair done before the light?

Apr 28, 2009 | 2008 Toyota Highlander

1 Answer

Tire Pressure


if there fine it it feels and drives fine dont worry about it the computer may just need to be reset but i dont know how to reset it sorry

Apr 15, 2009 | 2008 Volkswagen Touareg

Not finding what you are looking for?
2011 Land Rover Rover Range Logo

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...