Question about Nissan Altima

Open Question

2008 altima altenator tool

Remove alternator 2008 nissan altima

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
fcsr
  • 43 Answers

SOURCE: remove driver's side door panel on 2002 nissan altima

Removal instructions are available with images and step by step directions, www.carstereohelp.com/strnissan.htm

Posted on Nov 13, 2008

Ad
  • 1 Answer

SOURCE: 2003 Nissan altima alternator

how do yow remuve alternaotor on a 2003 nissan altima

Posted on Jan 05, 2009

  • 1 Answer

SOURCE: nissan altima 2005 noise from engine

i had the same issue had the alternator replaced and their is no longer a noise.

Posted on Jan 22, 2009

  • 112 Answers

SOURCE: 2002 Nissan Altima Exterior Door Handle

Look at the inside of the door directly behind the door handle. There should be a hole about 15 mm wide.
Just enough to get a small socket through.
Make sure the window is up.

Posted on Feb 03, 2009

ZJLimited
  • 17970 Answers

SOURCE: How do you remove a 1999 Nissan Altima starter?

Nissan Car Altima & Sentra 1999-06 StarterRemoval & Installation

  1. Remove or disconnect the following:
    Negative battery cable Air duct Harness protector from the harness Starter wiring at the starter Starter-to-engine bolts Starter from the vehicle


  2. b53bb6c.jpg
    Fig. Starter location and mounting detail-3.0L Maxima with a manual transaxle


    b2eb267.jpg
    Fig. Starter location and mounting detail-3.5L Maxima

To install:
  1. Install or connect the following:
    Starter and torque the long bolt to 57-72 ft. lbs. (77-98 Nm) on Altima and Maxima and 41 ft. lbs. (55 Nm) on 350 Z. torque the short bolt to 22-30 ft. lbs. (30-41 Nm) Starter wiring Harness protector Air duct Negative battery cable
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter

To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

1.6L & 2.0L Engines
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negaative battery cable

1.6L, 1.8L & 2.0L Engines
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negative battery cable

1.8L & 2.0L Engines
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negative battery cable

2.4L & 2.5L Engines
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

2.4L Engine
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

2.5L Engine
  1. Remove or disconnect the following:
    Negative battery cable Air cleaner cover and duct Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

3.5L Engines
  1. Remove or disconnect the following:
    Negative battery cable Air cleaner case (upper) and air cleaner to electric throttle control actuator tube. Harness protector from the harness Starter wiring at the starter Starter-to-engine bolts Starter from the vehicle

    42c548c.jpg
    Fig. Starter location and mounting detail-3.5L engine

continue...

Posted on Apr 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change alternator on 2008 nissian altima


For a V6 altima easiest way is to remove the radiator. Altenator is on the front of the engine at the bottom. With the radiator out of the way can fit it out. Ususal atuff for the altenator. Disconnect the battery. Loosen the belt to remove it. The unplug connector and the 12mm bolt for the output. Then unbolt altenator to remove. Will not be able to fit it out without removing radiator

Mar 04, 2017 | Cars & Trucks

2 Answers

I own a 2008 Nissan Altima. However, the radio stopped working after the alternator was replaced. How do I fix the radio? Thanks


if the battery was disconnected to replace the alternator you will need a code to put back into the radio to get the antitheft block removed

Nov 14, 2016 | Nissan Cars & Trucks

1 Answer

How do you get the bolts loose from the alternator for a 2003 Nissan altima 3.5


Kathy, R&R info./instructions in links below. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
2003 nissan altima 3 5l v6 alternator part 1
how to replace the alternator on 2003 nissan altima 3 5L alternatoe...
2003 nissan altima 3 5l v6 alternator install 1
2002 Altima Alternator How Do Replace the Alternator on My 2002


Jun 16, 2016 | 2003 Nissan Altima

1 Answer

Removing tensioner assembly


images for 2008 Nissan Versa Removing tensioner

    how do you remove tension off surpentine belt tensioner - Nissan Forum

    www.nissanforums.com/.../151350-how-do-you-remove-tension-off.htm...

    Feb 20, 2009 - 4 posts - ‎2 authors
    2008+ Nissan Rogue ... QR25 2.5L Engine Engine Discussion: 2002+ Sentra SE-R and SpecV ... how do you remove tension off surpentine belt tensioner ... changed these before, but which way do you turn the tensioner, how ... Replacing the Water Pump on a '04-'08 Maxima *DIY*
    1 post
    Aug 31, 2011
    Belt noise: replace idler pulley? - GA16DE
    8 posts
    Sep 16, 2008
    Step by step instructions -Upper Timing Chain Tensioner
    15 posts
    Dec 8, 2007
    Idler Pulley Bearing Replacement Info
    5 posts
    May 16, 2003
    More results from www.nissanforums.com

    Nissan Versa Tensioner Pulley Issue (1/1) - EricTheCarGuy ...

    www.ericthecarguy.com/.../50669-nissan-versa-tensioner-pulley-issue
    Nissan Versa Tensioner Pulley Issue 1 year 7 months ago #94552 ... for a 50 Torx to be used to remove the entire tensioner pulley assembly but all of my 50Trx

    How to Replace serpentine belt 2008 Nissan Altima ...

    ? 11:29
    https://www.youtube.com/watch?v=5NchA85pnAE
    Jul 2, 2014 - Uploaded by nivekoch
    How to Replace serpentine belt 2008 Nissan Altima In this video i'll be going ... 2005 Nissan Altima 2.5L serpentine belt tensionerreplacement ...

Dec 16, 2015 | 2008 Nissan Versa

1 Answer

How do I remove the dash board cover from a 2008 Nissan Altima?


big big job, needs to be done in shop. if I understand what you mean by cover.

Mar 07, 2015 | 2008 Nissan Altima

1 Answer

Remove alternator


Remove radiator and fan assemblies for easier access. Disconnect battery, disconnect wiring from alternator, remove belt and two bolts ,upper and lower that hold alternator. Wiggle and pry alternator free. Be careful not to bump into a/c condenser.

Jan 01, 2014 | 2006 Nissan Altima

1 Answer

Windshield washer fluid does not come out of 2008 Nissan altima


Pump is connected to reservoir at bottom,must remove tank to get to.

Apr 13, 2013 | 2008 Nissan Altima

1 Answer

How to replace knock sensor in 1995 nissan altima


remove the intake manifold ,remove radiator ,remove radiator intake and outake housing, remove fan ,remove all belts: power steering, alternator and if you have a/c, remove harmonic balancer ,remove timing belt covers, remove timing belt remove intake housinng once you have remove all the above, your freaken engine will look naked, you can see the location of the knock sensor is locate in the engine valley

Jan 20, 2010 | 1995 Nissan Altima

1 Answer

How to change an alternator on a 2005 nissan altima


YOU NEED A HAYNES REPAIR MANUAL.BECAUSE ALTIMA HAD A 2.5 AND 3.5 ENGINE.YOU NEED MANUAL BECAUSE IT WILL TELL YOU WHAT COMPONENTS YOU WILL HAVE TO REMOVE TO GET THE ALTERNATOR OFF.

Jan 09, 2010 | 2005 Nissan Altima

3 Answers

2003 Nissan altima alternator


The alternator is right on top of the 2.5L motor and held on by 2 14mm bolts. To remove the lower bolt (hard to reach), you must remove the coolant bottle and the IPDM fuse board and its metal box/bracket. A breaker bar really helped give enough torque to loosen the bolts. Approach the drive belt from under the front passenger tire. There is a tension adjuster (hard to reach) bolt that loosens the belt and allows you to remove it from the alternator.

Aug 21, 2008 | 2003 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...