Question about 1996 Toyota Camry

1 Answer

Ecm The check engine light is on and it sputers when I excelarate from a dead stop

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 3,961 Answers

OK,
next thing is to see what the ECM thinks is wrong. You can either connect a scan device to the scan plug, or connect terminals TE1 and E1 in the diagnostics terminal box in the engine bay.
Depending on where you are, some places (possibly Autozone in USA) will do this for free. Then look up the code to home in on the problem.
See here p166 and 296
http://www.turboninjas.com/camry/eg1.pdf

Posted on May 01, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Check engine light has P0685 code. Engine stalled while driving. What are the possible causes of this? Is this an expensive fix?


- Faulty Engine Control Module (ECM) power relay
- ECM power relay harness is open or shorted
- ECM power relay circuit poor electrical connection
- Faulty (ECM)

Apr 24, 2015 | Cars & Trucks

1 Answer

As I began driving, it had been raining,the engine started sputering but the emissions light on the the dash didn't light up until about 2 miles down the road.After a while the sputering stopped. Will this...


It could be, if the light came on it should have logged a diagnostic trouble code and can be read with a scan tool to give you an idea of what went wrong. Very well could just need a tune up (plugs and wires).

Dec 13, 2010 | 2005 Ford Escape

2 Answers

2009 Caliber: light on the dash that as two lines with a lighten...


I have a 2009 Caliber. Lately as I excelarate, this light on the dash that has two lines and looks like lightening bolt comes on and causes the car to not excelarate as it should. The car drives
less than 2 miles an hour when this happens. Even if I push the paddle to the floor, it still rides
very slow. What does this light mean? Please advise.

May 18, 2010 | 2009 Dodge Caliber

1 Answer

I have a 1996 lincoln mk Viii, i was driving and the car went completely dead, I got a jump, made it home, lights kept going dim, so i figured it was the altenator, I replaced the altenator with one from...


you replaced it with one from the junkyard. Who's to say the car in the junkyard didn't have the same issue before it died? Anyway, the check engine light and low idle may be attributed to the fact that the ECM lost all power to it, and when the vehicle is running and ECM loses power, it will throw a check engine light. Also now the ECM will need to relearn it's idle and various other parameters that take a lil time. (15 miles or so) I would have the check engine light checked to see which code you have. Also make sure the air suspension is not leaking. That is the number 1 killer of alternators on mark viii's.

Dec 24, 2009 | 1996 Lincoln Mark VIII

1 Answer

95 contour 220.000k 4cyl 5 spd temp gauge goes over half and check engine light goes on almost instant but i still drive and temp goes down for a bit and light goes out only when i turn engine off and...


Coolant sensor may be the problem. It is located near the thermostat housing. It may be sticking between modes & not operating properly.Also make sure coolant is circulating in system.

Sep 09, 2009 | 1995 Ford Contour

1 Answer

Engine shuts off somtimes when I'm driving.


could be your comp. is your check engine light ever on? or a crankshaft position sensor.

Apr 19, 2009 | 2001 Chevrolet Blazer

1 Answer

Transmission stuck in forth gear check engine light is on.


Your TCU (transmission Control Unit) is bad. it is located behind the passenger side kick panel. you can purchase it on ebay for about 79.00 with exchange.

Lugnut61

Feb 08, 2009 | 1992 Honda Accord

1 Answer

1991 suzuki samurai want start


Check ECM (engine computer) located under glove box. Injector circuit output probably dead. Replace ECM. Go to Searchparts.com for best price.

Jun 06, 2008 | 1991 Suzuki Samurai

Not finding what you are looking for?
1996 Toyota Camry Logo

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...