Question about 2008 Subaru Outback

Open Question

How do you change the spark plugs on a 2008 subaru outback 6 ctlinderChanging Plugs

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
motor1258
  • 6674 Answers

SOURCE: after changing the spark plugs on my car the check engine light came on. Why?

.044 should be.

Posted on Apr 25, 2009

Ad
  • 41 Answers

SOURCE: 2002 Subaru outback was idling rough and sometimes

Could be the Idle Control Valve?

Posted on Jul 06, 2009

  • 119 Answers

SOURCE: How to chage spark plaugs - 05 Outback

the spark plugs are recessed in cylinder head,easyiest way to do remove air filter box on passanger side,remove spark plug wires give a twist then pull use 5/8 socket a3/8 swivel and a 12 inch externsion along with 3/8 rachet theses are tools of the trade, the extensions may not be avaible to you but these tools take the bending over and frustration out of the job, the plugs on the drivers side are easier nothing to remove but the wires good luck

Posted on Jul 16, 2009

goofduck
  • 490 Answers

SOURCE: Outback 2002 subaru - Rear view mirror foggy; stopped working

there is nothing the shop did the that caused this they do that because of the heat inside the car sitting out in the sun

Posted on Sep 26, 2009

SOURCE: how do i change the spark plugs on a 99 subaru forester?

Subaru Forester Spark plug removal: First, you must remove the air cleaner housing Move the tube from the air cleaner and the intake on top of the engine by loosening the hose clamps at each end. It is still attached to a hose underneath but can be put out of the way

Remove the top of the air cleaner and the filter.

Remove the two 12mm bolts at each side of the bottom.

The side of the bottom is rubber gasketed to the inside fender - just rotate slightly each way to loosen and pull off and put off to the side - there is still a wire attached.

Now pull off the spark plug caps on the side of the engine. This is a boxer engine which means the plugs are in a horizontal position on the sides. It is good to have a pair of spark plug pliers to do this as they are really difficult to remove. (spark plug pliers form a circle on the end when closed and are nice to grasp the caps with). Now you will need a 3/8 drive socket wrench, a 2" extension and a 5/8 deep socket Connect the extension and socket and feed it into the spark plug hole and over the spark plug. It is really deep inside. Now attach the wrench and remove the spark plug making sure you keep the tools level so as not to torque the plug side ways. Once the plug is real loose, unattach the wrench and hand loosen the plug with the extension because the wrench won't fit to remove the extension and socket attached. Remove the extension and socket and then spark plug. Put in the new plug reversing the steps.

Posted on Dec 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace spar plugs and wires for a 2002 subaru outback 4cyl. sedan


You will need a spark plug spanner.....might be better off getting a garage to do this and change the oil and filters as well!

Nov 08, 2014 | 2002 Subaru Outback

1 Answer

Hesitation on Startup. Battery & Alternator are good. Fuel related? Spark plugs?


If you are saying it takes a long time to start the engine, have you checked fuel pressure before and after cranking ?

Jul 17, 2013 | 2006 Subaru Outback

1 Answer

How do you replace the spark plug wires on 1997 Subaru outback/legacy?


Access from top is better but you must remove battery/washer reservoir driver's side and intake piping on passenger's side to get to the plugs. If you have bad back, access from underneath is fine but I'd have a ramp instead of jack for safety reasons.

Jul 18, 2017 | 1997 Subaru Legacy

1 Answer

Spark plug gap for 2000 subaru impreza outback 2.2


2000 Subaru Impreza Outback service manual calls for 1.0 mm to 1.1 mm or .039 in. to .044 in. Most spark plugs at any auto store should be pre-gapped, but double checking never hurt. Make sure to apply a very light coat to the spark plug threads and torque them to 15 ft-lbs +/- 2 ft-lbs. Good luck.

Apr 07, 2013 | Pontiac Fiero Cars & Trucks

1 Answer

Where is the fuel pump relay 98 subaru outback legacy


http://www.subaruoutback.org/forums/66-problems-maintenance/28047-98-obl-where-exactly-fuel-pump-relay.html

Feb 04, 2013 | 2001 Subaru Outback

1 Answer

What spark plugs should i use in my 2004 subaru outback?


I always run NGK Iridium spark plugs in my vehicles. The part number 5464 will fit the 2.5L engine and part number 6619 will fit the 3.0L engine.

Mar 22, 2011 | 2004 Subaru Outback

1 Answer

Subaru 2001 outback... oil under the rubber spark plug plugs,is this a problem?


Hi,
The oil in the spark pug hole is coming from a seal in the cam cover.
It will eventually fill up enough to short out the plug. Putting new seals in the cover should not be to expensive. Good Luck!!!!!!!

May 18, 2010 | 2001 Subaru Outback

1 Answer

I have 1997 subaru outback wagon that I bought used. It appears that the spark plugs and wires are still the oem wires and have never been changed. How do I get a broken plug cover off to remove the plug?


As you are going to replace the plug and wire anywhere, get a pair of needle-nose pliers and grab what's left of the broken plug wire and pull hard. Even if it snaps the spark plug off, you will still be able to use the spark plug socket to remove the plug.

Oct 06, 2009 | 1997 Subaru Outback

1 Answer

How to chage spark plaugs - 05 Outback


the spark plugs are recessed in cylinder head,easyiest way to do remove air filter box on passanger side,remove spark plug wires give a twist then pull use 5/8 socket a3/8 swivel and a 12 inch externsion along with 3/8 rachet theses are tools of the trade, the extensions may not be avaible to you but these tools take the bending over and frustration out of the job, the plugs on the drivers side are easier nothing to remove but the wires good luck

May 07, 2009 | 2005 Subaru Outback

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Brandon Johnson
Brandon Johnson

Level 2 Expert

251 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...