Question about Chevrolet Impala

Open Question

What lug wrench size 2005 chevy impala - Impala Chevrolet Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: radio unlock coed for chevy impala

• A module which communicates on the class 2 serial data circuit which supplies VIN information to the radio is replaced and not properly setup with the correct VIN information for that vehicle. The only way to unlock the radio is by using a scan tool.

Posted on May 15, 2009

dennymulford
  • 1055 Answers

SOURCE: allen wrench size to fit caliper mounting bolt

some are 7/16 and some are 3/8 amd some are torx

Posted on May 30, 2009

  • 118 Answers

SOURCE: How do i change the Blower motor resistor on a 2005 chevy impala?

The blower motor resistor is located behind the glovebox mounted in the fan housing box under the dash.

Posted on Jul 20, 2009

  • 708 Answers

SOURCE: transmission problems

I had a 01 impala that was **** too. switched to Ford and havent been to the shop since. If you look at the question breakdown for this website you will see 5 times as many posts for chevys than fords. However, you could have gotten a bad rebuild too. I had a rebuild done once and they boke most of the bolts that held the transmission in and didnt replace them.

Posted on Sep 30, 2009

  • 4793 Answers

SOURCE: What wrench is needed to remove the 2002 GTI lug nuts?

they are the locking wheel nuts(lugs)and you will need a key(not a hex allen key)to remove them.if you look close you will see that the sides are not equal.
I use a nut spilitter or an old socket hammered onto the nut to remove it,means replacements but next time you buy a car check to make sure you have the radio code and the wheel nut key.

Posted on May 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Chevy impala brake pedal pulsation with brand new rotors installed


Is your ABS working properly? Under heavy braking the ABS should engage and 'pulse' the brakes on/off. It is normal to feel the brake petal flutter or pulse under your foot.

Under light braking there should be no pulsing as the ABS does not engage and you have changed the rotors and pads.

Nov 19, 2013 | 2005 Chevrolet Impala

1 Answer

I need to buy a lug wrench set


You should be able to get parts from the Chevy dealer's spares department, otherwise go to an auto wrecker's yard.

Feb 11, 2013 | 2005 Chevrolet Colorado

1 Answer

What to torque the hub bolts too on 2007 chevy impala ls


THE LUG NUT TORQUE SPEC - 100FT/LBS\ per Owner's Manual....Not 140 as listed above.

Apr 26, 2012 | 2005 Chevrolet Impala

1 Answer

Cannot get the rear flat tire off of 1995 chevy cavalier. Do I need a special tool for this?


You should only need a standard lug nut wrench to remove the wheel, unless you have a lock nut (usually one nut is different) and it requires a 'key' to remove that one nut-if they are all the same, however, you just need a lug wrench with the correct size to remove them.

May 23, 2011 | Chevrolet Cavalier Cars & Trucks

1 Answer

I can not get my tire off of my 2007 chevy impala and my back tire is flat


If the lug nuts are off the wheel may be rusted to the hub. With a light wieght hammer (1 or 2 lbs.) start tapping gently around the perimeter of the wheel. This will eventually loosen the wheel from the hub.If the lug nuts are frozen spray them with some WD-40 the use a pipe as an extension to your lug wrench. This gives you more leverage.

Jan 16, 2011 | Chevrolet Impala Cars & Trucks

1 Answer

Replace rear brake pads 2006 Chevy Impala


Hello, to replace the rear brake pads follow the following steps:

1. Lift the Chevy Impala with the jack and place it on jack stands.
2. Remove the wheels with a lug-nut wrench and set them aside. The lug-nut wrench can be found in the trunk of your Chevy Impala.
3. Remove the caliper with a ratchet and use a bungee cord to hang the caliper. Do not let the caliper hang from the brake hose, as the hose might break and cause fluid to leak.

4. Remove the brake caliper bracket from the steering knuckle with a ratchet. Set it aside.

5. Remove the break rotor from the hub. The rotor might require force to be removed; if it does, use a hammer to hit the rotor in the center, where the lug studs are located. Take care not to hit the studs.

6. Remove the new rotor from its packaging and use brake cleaner to remove the grease from the rotor. Grease is applied on the rotor in the factory to inhibit rust during storage.

7. Install the new rotor onto the hub.

8. Install the caliper bracket with new brake pads onto the rotor and fasten it to the steering knuckle. Use a ratchet to tighten the bolts.
9. Open the master cylinder reservoir so you don't break a seal while compressing the brake caliper.

10. Compress the brake caliper with a C-clamp, so that the caliper can fit over the new brake pads. Install the caliper by securing it to the brake caliper bracket with a ratchet.

Thanks


























Jul 19, 2010 | 2006 Chevrolet Impala

1 Answer

HOW DO YOU ACCESS THE JACK AND LUG WRENCH IN A 2005 CHEVY SILVERADO X-TEND CAB?


fold the bottom of the rear seat up. the jack is there in the open, the lug wrench is under the jack in the vinyl bag.

Jun 13, 2010 | 2005 Chevrolet Silverado 1500 2WD

1 Answer

Need to buy a new lug wrench. What size do I need


It is best to buy a four way ( cross type ) easier to used. the four way will also have the all four sizes on it.Hope this was very helpful.

May 14, 2010 | 2005 Chrysler Town & Country

1 Answer

Lug Size


call your local Chevy dealer parts department.

Dec 15, 2009 | 2005 Chevrolet Malibu

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...