Question about Chevrolet Camaro

1 Answer

The cigerette lighter and Power antenna dont work in my IROC Camaro 89'. What coukd be the problem

I have a 89' Camaro, IROc Z. Lately the rising power antenna wont rise in place and the cigerette lighter wont work. What could this be? a fuse? are they both on the same fuse?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 315 Answers

Check fuse #7 and/or 41. These are the fuses associated to ur radio. Good luck and send feedback.

Posted on Apr 30, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mohammed387
  • 1952 Answers

SOURCE: 86 IROC heater core

Removal & Installation
1.Disconnect negative battery cable. Drain cooling system. Disconnect heater hoses from heater core, and plug openings. Detach hood release cable. Remove both dash side panels. Remove left and right lower dash trim panels. Remove glove box. Remove 7 screws securing center accessory console. Disconnect wires on accessory console, and remove accessory console. Remove control cables at heater case.

2.Remove 4 bolts securing steering column to instrument panel. Lower steering column. Remove 2 bolts from instrument panel mounts at far left and right sides of instrument panel. Remove defroster duct trim on top of dash. Remove instrument cluster screws. Pull instrument cluster out slightly. Disconnect electrical connections and speedometer cable from instrument cluster. Remove instrument cluster.

3.Disconnect all electrical connectors from instrument panel. Remove parking brake console. Remove glove box. Remove bolts securing instrument panel support to floorpan. Remove all instrument panel mounting bolts. Remove instrument panel.

4.Separate heater case from blower. Remove 3 nuts and pull heater

Posted on Dec 06, 2008

  • 109 Answers

SOURCE: 89 iroc camaro starter wiring connections?

I'm assuming there are 2 wires. On most starters there are 2 threaded posts. One will be chassis ground the other one will be electrically isolated on an insulated standoff, this will be the positive (usually red) wire from the starter relay which is usually somewhere close to the battery. If there is only one wire then it will be the postiive and bolting the starter in is "connecting" the ground. Make sure the mounting area is clean.

Posted on Mar 29, 2009

  • 3600 Answers

SOURCE: 1985 camaro iroc z fuse box diagram

10 amp slow blow.

Posted on Jun 17, 2009

  • 1986 Answers

SOURCE: Starting problem with 1989 Camaro Iroc. Have

It could be your crank sensor is starting to act up

Posted on Aug 21, 2009

  • 484 Answers

SOURCE: do you have a spark plug wiring diagram for a 1988

Okay, #1 is marked on the distributor so in clockwise order: 1-8-4-3-6-5-7-2
8 7
6 5
4 3
2 1
(Front)

Hope this helps,
matt

Posted on Oct 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

How To Replace Ignition Coil 82-92 Chevy Camaro Iroc-Z Pontiac Trans Am Part 2...


How To Install Replace Ignition Coil 82-92 Chevy Camaro Iroc-Z Pontiac Trans Am Part 2 1AAuto.com<utube src="jMtq0HqGtk0">

on Jul 28, 2011 | Chevrolet Camaro Cars & Trucks

Tip

How To Replace Ignition Coil 82-92 Chevy Camaro Iroc-Z Pontiac Trans Am Part 1...


How To Install Replace Ignition Coil 82-92 Chevy Camaro Iroc-Z Pontiac Trans Am Part 1 1AAuto.com<br /><br /><utube src="hiczZ2JugAg"><br />

on Jul 28, 2011 | Chevrolet Camaro Cars & Trucks

1 Answer

How do i replace the rear axel bearings on a 1988 Chevrolet IROC Z28 Camaro


Put car in neutral, remove wheels, calipers and rotors, diff. cover. rotate carrier until you see wrist pin retaining bolt, remove bolt and slide out the wrist pin out of carrier. Next push axle inward to remove inner axle "C" retainer washer then slide axle out of tube. Then pry off axle seal and with slide hammer w/attachment remove axle bearing.

Feb 23, 2014 | 1988 Chevrolet Camaro

1 Answer

Camaro iroc 1989


I don't see a reference to your problem...the real 89 IROC is the 5.7 V-8...tuned port injection:)

May 24, 2013 | Cars & Trucks

1 Answer

1990 camaro Iroc z Clunking noise comeing from borg warner rear


Check your tranny mount sometimes the rubber part cracks and makes a clunking sound, also check your universal joints on the driveshaft if they are bad they will clunk, both are cheap fixes.

Apr 01, 2010 | 1990 Chevrolet Camaro

1 Answer

87 IROC WITH A ZZ4 OUT OF A 91 Z28... fitted a


Fuel pressure? Do you hear the fuel pump running? Read the codes to see if ECM is still alive. Do you have spark at the plugs? Remember all motors need 3 things to run air, fuel, and fire at the right time.

Mar 16, 2010 | 1987 Chevrolet Camaro

2 Answers

I'm buying a 88 Iroc-z Camaro.. It has 97000. mi


That ticking is usually a loose rocker arm. Use a mechanic stethoscope and you will find which one needs adjusting or replacing. A push rod may be partially clogged and caused excessive wear. Older vehicles which have been in storage often have oil leaks and related. This happens if the vehicle has not been started on a regular basis. Nonuse causes seals and gasgets to dry and shrink so be aware and look for leaks.

Dec 30, 2009 | 1988 Chevrolet Camaro

1 Answer

I am having problems keeping my 86 camaro iroc z idling


Check your idle air stabalizer or sometimes called the idle air control valve, it may be clogged with carbon buildup and not working properly,

Oct 20, 2009 | 1986 Chevrolet Camaro

1 Answer

Has anyone had any difficulty with the radio removal and replacement for an 88 camaro irocz28? I purchased this car, then discovered the antenna cables were 'stuffed' underneath the console on the drivers...


i have a 1990 iroc-z and i replaced the radio with an aftermarket radio. when i replaced the factory radio i had to do a little manuvering of the wires because of the alarm i had installed. the antenna wire is supposed to be ran under the PASSENGER side i dont understand why they are under the driver side.

Jul 09, 2009 | 1988 Chevrolet Camaro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...