Question about Chevrolet Astro

Open Question

Fuel safety shut off switch 1995 chevy astro - Astro Chevrolet Cars & Trucks

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 87 Answers

SOURCE: 1999 chevy astro fuel pump reset switch

No such switch .

Posted on Dec 19, 2008

  • 6927 Answers

SOURCE: My 1995 chevy astro 4.3l will not start. It turns

It sounds like the fusible link,or links have burned into.They are located on the starter itself.They look like a wire,and are bolted on with the positive cable on the starter.To check them,just pull on them ,and they will pull apart like taffy.These are easy to replace,be sure to disconnect the neative cable first.You can purchase these fusible links at a auto parts store.NAPA carys them,i know.They are not expensive either.Do not use regular common everyday wire.You will burn the van down to the ground if there is a short.When you install these,and connect the battery back up look at the fusible link,or links to see that they are not burning back up.Besides a short,these fusible links go out do to hard starts(holding the key to start at low battery voltage.After you replace these links,check or have the battery checked,and the alternator,to see if it is charging enough.If I can help,let me know,this should be the only reason for this to have happened.

Posted on Sep 24, 2009

  • 489 Answers

SOURCE: where is the fuel pressure regulater on a 1998 chevy astro van ?

it is on the fuel rail on the engine its next to the fuel line conection from tank to fuel rail for injectors

Posted on Nov 13, 2009

  • 70 Answers

SOURCE: how do you change a fuel pump on 2003 chevy astro

on the engine compartment on the fuel rail there is a pressure port that is usually covered by colored plastic cover open it then turn the ignition switch listen for the sound of your fuel pump turning on momentarilly. if you cannot hear it while ignition is on insert small screw driver on the port to open the valve make sure you wrap rugs to control the flow of fuel if there is any. the fuel should around 40-50 psi so expect heavy fuel coming out at port if your pump is working. to change it you have to drop your fuel tank and replace your pump. this is usually left for professional due to fire hazard. any spark due to static electricity can set your fuel to flame up.

Posted on Nov 23, 2009

  • 65 Answers

SOURCE: how toreplace fuel injector chevy astro 1999

Removal & Installation

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Relieve the fuel system pressure. Refer to the fuel system relief procedure in this section.
  3. Remove engine cover.
  4. Disconnect negative battery cable.
  5. Remove upper manifold assembly.
  6. Disconnect fuel meter body electrical connection and the fuel feed and return hoses from the engine fuel pipes.
  7. Remove poppet nozzle out of the casting socket by squeezing the nozzle locking tabs together.
  8. Remove fuel meter body by releasing the locktabs.
    NOTE Each injector is calibrated. When replacing the fuel injectors, be sure to replace it with the correct injector.
  9. Remove lower hold-down plate and nuts.
  10. While pulling the poppet nozzle tube downward, push with a small prytool down between the injector terminals and remove the injectors.

    0996b43f8022cb96.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Exploded view of the fuel meter assembly, including the injectors

To install:
  1. Lubricate the new injector O-ring seats with engine oil.
  2. Install o-rings on the injector.
  3. Install fuel injector into the fuel meter body injector socket.
  4. Install lower hold-down plate and nuts. Torque the nuts to 27 inch lbs. (3 Nm).
  5. Install fuel meter body assembly into the intake manifold. Torque the fuel meter bracket retainer bolts to 88 inch. lbs. (10 Nm).
    CAUTION To reduce the risk of fire or injury ensure that the poppet nozzles are properly seated and locked in their casting sockets.
  6. Install fuel meter body into the bracket and lock all the tabs in place.
  7. Install poppet nozzles into the casting sockets.
  8. Engage electrical connections.
  9. Install new o-ring seals on the fuel return and feed hoses.
  10. Connect fuel feed and return hoses and tighten the fuel pipe nuts to 22 ft. lbs. (30 Nm).
  11. Connect negative battery cable.
  12. Turn the ignition ON for 2 seconds and then turn it OFF for 10 seconds. Again turn the ignition ON and check for leaks.
  13. Install the engine cover.

Posted on Jan 20, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

How can you check if fuel pump is bad on a 2002 chevy astro

Check your TPS Sensor. My 1995 Chevy Astro Van did the same thing and I thought it was the fuel pump but I was wrong.

Feb 15, 2014 | 2000 Chevrolet Astro

1 Answer

Where is the chevy astro fuel pump relay for a 1995 astro van

under the hood in the relay/fuse box, should be labeled

Sep 28, 2011 | 1995 Chevrolet Camaro

1 Answer

1995 chevy astro no spark from coil changed coil and ecm

You may want to try looking at your ignition switch. The ignition switch controls all of the power for the rest of your vehicle, and if the ignition switch is bad it will cause problems like you are having. I hope this helps.

Aug 31, 2011 | 1995 Chevrolet Astro

1 Answer

Have no power to the fuel pump on 1995 chevy astro van.4.3

ther isd a fuel pump fuseand fuel pump relay. also and I am not sure where it is located, but all vehicles with electric fuel pumps have a switch that is suposed to cut off the fuel pump if the vehicle get into an accident. this switch on many cars is located on the pasanger side inside car in the kick panel or around the heater box. not sure of location on the astro van. these switches sometimes pop off for no reason or hitting some rough roads etc. Gm also has several service bulitens out for defective harnesses and the problem might be the connector to the fuel pump. some ideas. good luck

Jun 11, 2011 | Chevrolet Astro Cars & Trucks

2 Answers

95 chevy astro van, where is the a/c clutch relay?

there is no relay power from control panel through pressure switchs to compressor

May 09, 2010 | 1995 Chevrolet Astro

1 Answer

I Have a 1995 Chevy Astro with 4.3 engine, that chakes and rattle

the fuel pressure should be 60-66psi so i would start by changing the fuel pressure regulater to get pressure were it should be. to much pressure will bleed past the injector and cause the car to run as you described

Nov 28, 2009 | 1995 Chevrolet Astro

1 Answer

Acc positions on ignition switch will not work on 95 Chevy Astro

ignition switch not lock cylinder may need to be addjusted it's on top side of steering column under dash

Jul 10, 2009 | 1995 Chevrolet Astro

1 Answer

1993 Chevy Astro Mini Van not starting

If You can start the vehicle off ether only then you have a fuel issue. the pump is working and the fuel pressure regulator is too. so either the injectors are not getting an electrical signal to open and close of possibly, Your oil sending unit is defective and has shut down your fuel system (a safety).

May 30, 2009 | 1993 Chevrolet Astro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides