Question about 2007 BMW M6 Coupe

Open Question

M6 DSC and DBC Malfunction

DSC malfunction and DBC malfunction, startoff assistance inactive just started showing up but no fault codes can be found

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 28 Answers

SOURCE: idle control malfunction code PO 505

dirty idle control valve maybe? take it off & clean with parts cleaner or crc or wd-40. try that & see how you get on.

Posted on Aug 22, 2008

Ad
simpsonite20
  • 100 Answers

SOURCE: on my 2002 bmw 745li keeps dispalying DSC

It means your Dynamic Skid Control is failing. This is what helps you control the vehicle in collision like circumstances.

Posted on Jun 17, 2009

  • 219 Answers

SOURCE: I replaced my head gasket on my 2000 528i BMW. Now

Good evening Daniel,
Congrats on replacing the head gasket successfully! In regards to your secondary air system. I would first start with the electrical air pump supply located on the passengers side of the engine compartment. You can locate the supply hose (about 1 1/2 inch diameter) at the front of the exhaust manifold. The hose connects to the secondary air valve. Make sure the hose is connected. Also make sure if there is a vacuum supply line to the secondary air valve, that it is not broken/or disconnected. If the hoses are ok and secure, then remove the larger supply hose from the valve when the engine has not been started for 4-5 hrs and make sure you have air flow from the air pump. The pump should be audible and operate for approximately 30seconds to a minute. If you are still having issues after these checks, I can list other possible causes.

Posted on May 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2003 S-type jaguar that goes into a limp mode and stops running then the engine system fault shows ,the parkbrake fault and DSC not available also shows. Diagnostic showed codes PO121,P1582??


code p 0121 is associated with the throttle position sensor and accelerator position sensor
causes are from cable adjustment --throttle position and accelerator position sensors
code p0533 refers to ac refrigerant pressure sensor--high input== causes --ac pressure too high (cooling fault -condenser fan not running at radiator-- too much gas --pressure sensor
p 0105 refers to map sensor / barometric pressure sensor --circuit malfunction===causes wiring--- map sensor --baro sensor ECM
code p0566 refers to cruise control master switch== causes --control switch , ---ECM
code p1582 refers to electronic throttle monitor data available which will be associated with the p 0121 code and faults

Jan 08, 2017 | Jaguar Cars & Trucks

1 Answer

How to resert engine mulfunction light on the dashboard of mercedesbenz c180 2013


need to have the code read most auto stores offer service for free the code will assist in what the vehicles computer found a fault with -with repair or correction of problem can have scanner clear codes or with repair it will reset

Jun 13, 2016 | 2013 Mercedes-Benz C-Class

1 Answer

What is the malfuction light


you need the PO code to determin where the fault is ,the malfunction indecater light is your check engine light.

Aug 11, 2014 | 2010 Jeep Patriot

1 Answer

What do codes P1175 & P1237 actually mean? Why are there so many options to choose from? How can I actually repair it?


The ECM has numerous sensors that are read continuously and these results are checked against pre-set parameters in the CPU memories. Every possible cause of a fault code is an associated sensor that is being affected by the fault so there are several possible reasons that cause the fault . That is to say wiring is a possible cause ---the unit itself is another possible cause---low /high voltage is another and so on. Take it to a service centre as with most makes of vehicles there is a common fault problem that experienced technicians are aware of and can pin point quickly. As with advice from readers the causes are general areas of advice to look at so if it appears confusing then take it to an experienced shop.

May 17, 2014 | 2001 Volvo V70 XC

1 Answer

The truck stalled out when driving. Sounds like it wants to start, but won't fire. Codes found - P0410, P0128, P0141, P0102. Please help. Daughter's truck and she leaves for college in a few days.


code p0410 refers to secondary injection system--malfunction===causes wiring--air valve--air solenoid--- ECM
code p0141 refers to heated oxygen sensor-2 bank1-heater control -circuit malfunction===causes --wiring--oxygen sensor--ECM
code p0128 refers to coolant thermostat --coolant temp below thermostat regulating temperature==causes mechanical fault (thermostat stuck open)
code p0102 refers to mass air flow (MAF) sensor/ volume air flow (VAF) sensor low input===causes wiring short to ground--MAF/VAF sensor ECM

Aug 22, 2013 | 2001 GMC Jimmy

1 Answer

Fault code p0703


P0700 Transmission Control System Malfunction
P0730 Incorrect Gear Ratio
P0620 Generator Control Circuit Malfunction
P1130 Not found
P0340 Camshaft Position Sensor Circuit Malfunction

Mar 06, 2013 | 2002 Jeep Grand Cherokee

1 Answer

Toyota echo won't start code 440 441 446


Error Code: P0440
Fault Location:
Evaporative Emission (EVAP) System - Malfunction
Possible Cause:
Malfunction Indicator Lamp (MIL) active.
Soution:
Check Evaporative Emission (EVAP) System Sealing.
Check Evaporative Emission (EVAP) Canister Purge Regulator Valve .
Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve .

Error Code: P0441
Fault Location:
Evaporative Emission (EVAP) System - Incorrect Flow Detected
Possible Solutions:
Check Evaporative Emission (EVAP) Canister Purge Regulator Valve .
Perform Output Test.
Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve .
Check Evaporative Emission (EVAP) Canister.
Perform Basic Setting.
Check Pipes between Tank Breathing and Throttle Body.

Error Code: P0446
Fault Location:
Evaporative Emission (EVAP) System, Vent Control - Circuit Malfunction
Possible Cause:
Wiring harness.
Evaporative emission (EVAP) canister purge valve.
Engine control module (ECM).

Feb 25, 2013 | 2002 Toyota ECHO

1 Answer

Trouble code p2454


To Hi
I got this problem in Skoda Diesel Particle Filter, I have check the wiring all is perfect , then I have change it but the same problem .
will anybody tell me how can I solve this problem please ,
PS. after deleting the fault it came back

Regards

______________________________

Saturday,06,July,2013,17:18:03:25282
VCDS -- Windows Based VAG/VAS Emulator
VCDS Version: 12.10.6.2
Data version: 20130531

Dealer/Shop Name: EEPROMKFZEEPROM WORKSHOP .

.
Workshop Code: 123 12345 023456

VIN: TMBHT61Z5A2101325 License Plate: PROBLEM

----------------------------------------------------------
----------------------------------------------------------

Chassis Type: 1K0
Scan: 01 03 08 09 10 15 16 17 19 25 42 44 46 52 56 62 69 72 77

VIN: TMBHT61Z5A2101325

01-Engine -- Status: Malfunction 0010
03-ABS Brakes -- Status: Malfunction 0010
04-Steering Angle -- Status: OK 0000
08-Auto HVAC -- Status: Malfunction 0010
09-Cent. Elect. -- Status: Malfunction 0010
10-Park/Steer Assist -- Status: Malfunction 0010
15-Airbags -- Status: OK 0000
16-Steering wheel -- Status: OK 0000
17-Instruments -- Status: Malfunction 1010
19-CAN Gateway -- Status: Malfunction 0010
25-Immobilizer -- Status: Sporadic communication error 1000
42-Door Elect, Driver -- Status: Malfunction 0010
44-Steering Assist -- Status: Malfunction 0010
46-Central Conv. -- Status: OK 0000
52-Door Elect, Pass. -- Status: Malfunction 0010
56-Radio -- Status: Malfunction 0010
62-Door, Rear Left -- Status: OK 0000
69-Trailer -- Status: OK 0000
72-Door, Rear Right -- Status: OK 0000
77-Telephone -- Status: Malfunction 0010

----------------------------------------------------------
Address 01: Engine (J623-CAYC) Labels: 03L-906-023-CAY.clb
Part No SW: 03L 906 023 AG HW: 03L 906 023 AG
Component: 1,6l R4 CR td H23 5697
Revision: -------- Serial number:
Coding: 00114016032400080000
Shop #: WSC 73430 031 00999
ASAM Dataset: EV_ECM16TDI02103L906023AG 001003
ROD: EV_ECM16TDI02103L906023A.rod
VCID: 6BDFA3EE82E73246487

1 Fault Found:

7397 - Diesel Particle Filter; Differential Pressure Sensor
P2454 00 [175] - Short to GND
MIL ON - Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 2
Fault Frequency: 2
Mileage: 166872 km
Date: 2038.14.06
Time: 00:13:34

Readiness: 0000 0000

End ----------------------------------------------------------

Jan 22, 2013 | 2008 Ford F-350

1 Answer

1998 ford ranger 4x4 4.0l 6cylinder automatic does


My friend this sounds like a catalytic converter problem. A number one symptom in the case of a "burned up" catalyst is loss of power or as you put it bogged down. Try disconnecting at the flange if not too much trouble or simply remove the O2 sensor downstream and see if pressure changes (old trick)

Jul 09, 2011 | 1998 Ford Ranger SuperCab

1 Answer

Jaguar s-type pulled code p1380 now you press gas and the car dosen't want to go


P0066 = air assisted fuel injection (AAI) control circuit malfunction.
P1380 = VVT Solenoid circuit malfunction bank 1
P1385 = VVT Solenoid circuit malfunction bank 2
P0353 = IGNITION SIGNAL COIL C FAULT.
P1380 Variable cam timing solenoid A malfunction. Bank 1 cam solenoid located underneath intake manifold. The bank 1 solenoid is under the passenger side valve cover on the V8. On the V6 it's under the valve cover as well but the intake needs to be removed.
Thanks. you can rate this solution and show your appreciation.

May 21, 2010 | 2004 Jaguar S Type

Not finding what you are looking for?
2007 BMW M6 Coupe Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...