Question about 2000 Jaguar S-Type

1 Answer

Where is the audio dampening thing located so i can check it?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Jaguar Expert
  • 322 Answers

Not sure what you mean - explain more so I can possibly help.
There is a function in the audio menu which increases the volume of the radio with increasing road speed, or there is a mute button on the dash (phone) or on the steering wheel controls (if fitted)

Posted on May 09, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


well it is true that timing effects engine temperature, but im not sure what would just happen !! to make for your timing to change unless you moved the distributor , then it would make sence , anyways if you have a timing light , clamp pick up on #1 cylinder (most forward of all cylinders) plug wire , locate front vibration dampener , pointer most time is on passenger side , see is any marks can be seen on dampener , might require some degreasing to see them (409 works great) locate pickup harness leading to distributor , it has five small wires in it , follow down till you see a black plug (yellow wire) , looks funny sort of does a loop in it , start engine , pull plug from loop , point light at dampener see what timing is , what it should be is on emmision sticker on front core support , return plug to loop lookig thing when done

Feb 10, 2015 | 2002 Ford Mustang

1 Answer

Where is the cam shaft sensor on a 1993 buick lesebre custom

Hi, on the 1993 Buick Lesabre the crankshaft sensor is located under the dampener pulley. Remove the serpentine belt. Remove right front wheel. Remove plastic access cover thats behind that wheel. With an impact wrench remove dampener pulley bolt. With an Dampener pulley puller remove pulley. There is a plastic cover that snaps in place over the sensor, remove it, and you will have access to the sensor.

May 11, 2011 | 1993 Buick LeSabre

1 Answer

In my 99 beelte the rear hatch will not open. (not with the button on the door or with the key) When I bought the car about 3 weeks ago I was only given the "Valet Key". is there a "valet...

Welcome to

the fuel door and trunk release should be in one panel on door.

Too there is a relay that may have gone bad.

Check relay and all fuses

Check fuse with test light


550604 tech #

Jun. 5, 2006




Customer States Rear Decklid. Hard to Close

Customer states rear deck lid not closing properly.

Technical Background

Due to the stiffness of the original lock dampening rubber, the rear deck lid may be

Difficult hard to close.

Production Solution

A new lock dampening rubber was incorporated into production during calendar week

(CW) 4405. beginning ith VIN: IC_6M407025.



Install improved lock dampening rubber Part No. lCO 827 589 B:

Open rear deck lid.

A Remove rear decked trim panel (see Repair Manual, Body Interior, Group 70- Interior

Remove Lock housing cover.


To remove lock housing cover, gently pry between the locking pawl and cover guides

while pulling down on cover. Underside of cover shown for case of location identification.

A Remove the lock dampening rubber by pulling downward out of lock housing.


Install new rear lock dampening rubber Part No. lCO 827 589 B.


Ensure proper engagement of lock dampening rubber retaining tab into the lock housing

and is seated on the guide slots.

A Install lock housing cover.

A Install rear deck lid trim panel (see Repair Manual, Body Interior, Group 70- Interior

Thank you for using

Regards, Lee Davidian

Nov 18, 2010 | 1999 Volkswagen Beetle

1 Answer

How do i adjust the timing on a 1995 Chevy Blazer 4.3 vortec 4x4

Get a timing light, and start the engine. Point the light at the crankshaft dampener. There should be marks on the dampener and a gauge thing attached to the block. You advance or ****** the distributor until the lines are lined up. I would also suggest getting a Haynes manual from auto zone I hope this helps please rate this thank you

Mar 02, 2010 | 1995 Chevrolet Blazer

1 Answer

Shuts off when the truck is idoling.

Check the coolant level in the radiator, then check the reserve resivoir. make sure the engine is cool...sometime when it gets low, you can hear it cycling more clearly...Or you have water in the heater box under your dash near the dampener....Check for leaks at all heater hose connection locations...

May 19, 2009 | 2004 GMC Envoy

1 Answer

Car just keep spinning

crankshaft sensor is located just above the crankshafy front dampener./ pulley

Apr 27, 2009 | 1997 Chevrolet Monte Carlo

2 Answers

Crankshaft position sensor on a 1996 isuzu hombre

should be between the crank dampener and the block, i mean they are all relatively the same on all cars should be the only wires running close to the crank dampener

Dec 11, 2008 | 1996 Isuzu Hombre

1 Answer

Vibration Dampener Removal

Before your suspects the engine dampener, pls try to see the propeller shaft. maybe it knocks on your under chassis frame. If ever propeller shaft is not the cause that's the time that you have to check the dampener.

You can remove the dampener when you're under your car. Damperners placed in-between the Flywheel and Propeller Shaft flanged. A 3 or 4 bolts must be removed.

check the dampener for wears, if the rubber dampeners shows no wears, It was only misaligned.

hope this could help.

Nov 23, 2008 | 1991 Buick Riviera

Not finding what you are looking for?
2000 Jaguar S-Type Logo

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers


Level 3 Expert

76164 Answers


Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides