Question about 1991 Toyota Pickup

1 Answer

I have a wire that looks like a ground wire I need to know were it goes???

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.


    An expert that hasĀ over 10 points.

  • Contributor
  • 1 Answer

HAAAA i had same issue but found its home on the wiring harness,rite near battery and power steering pump....
I own a 1991 yota pickup

Posted on Aug 02, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Have no brake lights I changed the stop switch what else should i look for fuses in cab looks good

Without knowing the kind of vehicle you have, just start with basics first. Take a test light, hook to good ground (check light works by other fuse power to light) and check each wire at the brake light switch. Should have power on one of the wires. If you don't then you need to check between fuse and that wire. If you have power at the switch, step on brake and check for power coming out onto the other wire. ( that checks to make sure switch works). If power goes thru then you need to trace that wire toward your brake lights for open or for bad ground. Check for power at the light may have bad ground keeping lights from lighting. This should get you started. This is as much info I can give without knowing more on vehicle.

May 18, 2015 | Cars & Trucks

2 Answers

Where is the Ground wire that comes off the rear tail lights harness? its a 2001 Durango

Look for how to "change bulbs" probably in the User's manual.
No manual? try:
Once you have access to the change bulb area, usually on the back side of the taillight assembly, you should see what looks like a printed circuit "film". There should be a single wire (not part of the light connection wires). That single wire or a broken off connection to it is the ground. Follow the wire to a connection point on the body metal attached by a sheet metal screw, or equivalent. The ground wire is usually not more than 12". If the wire is missing, a substitute is needed. You may need to look at the other side to see how it is connected.

Apr 01, 2015 | 2001 Dodge Durango

1 Answer

2001 dodge intrepid replaced brake light switch and my brake lights still will not shut off.... Please help

I would start looking for a grounded wire somewhere. it could be where the harness goes thru the firewall. You might want to get a color code from a dealer or online so you know what color wires are in the brake light circuit. I don't know what your level of ability is, but you'll need a tester you can get from Autozone or any parts place. You will need the tester to check each wire. You will be removing eac fuse until the light in the tester goes out. That will tell you what wire is grounded.

Mar 01, 2015 | 2001 Dodge Intrepid

1 Answer

How to replace dome bulb 2002 eclipse spyder

Use a test light or voltmeter. The hot wire goes to the bulb tip. The other wires are grounds from the door switches and from the chassis. The chassis ground goes to the switch on the mirror. The other side of the switch goes to the bulb shell along with the wire from the door switches.


Nov 01, 2017 | Mitsubishi Eclipse Spyder Cars & Trucks

1 Answer

Cigarette lighter in center console doesn't work and I can figure out why. Checked all the fuses. Any ideas? Thanks!

pull out socket and check for power and ground wire that goes to center should be the power wire and wire that goes to out side should be ground
if u have power and ground then replace socket
if u dont have power check fuses again look for broken wire
if u dont have ground look for bad wire

Jan 30, 2011 | 2004 Infiniti QX4

1 Answer

The driver side mirror was broken off of my 1997 gmc jimmy. No wiring seemed to be broken so my husband reattached the mirror. Now tha chime goes off all the time unless you pull out the fuse. I need help...

Chime needs only a ground to work
So if that can help try to move the harness and look if chime work normally.
If it does then one wire touching the ground on and off (wire touching metal)

Hope it helps.

Feb 19, 2018 | 1997 GMC Jimmy

2 Answers

Sparking under vehicle when trying to start. It has a new battery and new cylanoid.

That sounds like a loose cable from the ignition solenoid down at the starter, or the cable between the starter and the starter solenoid is exposed and touching metal ground on the vehicle. Check the condition of the cable to the starter and also be sure that it is tight, and not touching any metal ground surfaces on the vehicle, and if there is nothing wrong with either then the starter is most likely is faulty.


Sep 26, 2010 | 1983 Ford F150

1 Answer

I need to wire an electric brake controller in my truck

you can either wire it straight or gm makes a connector that plugs into the drivers side floor . theres a box down there that has a cover over it and the gm connector plugs straight to it. but be careful because i have seen several times were gm wired it wrong the stop light plug is in the wrong spot.take a test light to ground touch each connector while pressing and releasing brake pedal the one that lights the light, is your stop light look on there connector and check to see if that plug is going to the red wire if not move the red wire to that spot. as for wiring it you have to do it this way. black wire goes to constent hot, white wire goes to constent ground , blue wire goes back to your trailer plug for your electric brake, and red wire as you know by now goes to the stop light.

Dec 27, 2009 | 2004 Chevrolet Silverado

2 Answers

I took the starter off and iknow i have a ground wire to put on behind the starter on the tranmission, and i know that the red wire goes on thee another cable that is black and i want to know if that wire...

The red wire is NOT a ground wire It's the live one It goes on the starter solenoid terminal The large Black one is the ground wire which will either go on the end of the motor or on a mounting bolt DON'T ground the red one You'll have a fire not to mention computer fryups etc

Oct 23, 2009 | 2003 Chrysler PT Cruiser

1 Answer

Ground wire? where does it go?

you can attach ground wires anywhere on the body as long as they are connected to a bare spot of metal. Usually, the braided one goes from anywhere on the engine block to anywhere on the body.
Basically, the battery ground wire goes to either the body or engine block. Then you need a path for the ground to the other component so there is a complete circuit.

Feb 28, 2009 | 1999 Chevrolet Silverado 1500

Not finding what you are looking for?
1991 Toyota Pickup Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides