SOURCE: 2000 ford windstar
fuse #10 in the fuse box inside the van under the dash this fuse will be blown HOWEVER the reason the fuse is blown is your real problem
the most likely cause is the reduntant bps on the master cylinder just unplug it and the fuse should stop blowing.
you can replace it if you want.
be very carefull of leaking brakefluid on harness below this sensor if brakefluid has leaked into harness and is not attended too it can cause major problems.
SOURCE: 2000 GMC Sierra Power seat stopped working
check the wires behind the seat control on the side if the seat, sometimes the wires will get pinched and short to ground
SOURCE: my 2000 ford crown victor air conditioning s.top
The Ford code P1460 (Wide Open Throttle A/C Cutout Circuit Malfunction). I would first try thr relay.
SOURCE: 2000 GMC Jimmy Power seat stopped working
Left side of the dash, to the right of the IP fuse block. Its a 25 amp circuit breaker, an aluminum cased breaker. CHECK FOR POWER ON THE SEAT SWITCH "A" TERMINAL AND GROUND ON THE "D" TERMINAL. IF YOU HAVE POWER AND GROUND THE SWITCH IS BAD.
Testimonial: "thanks"
SOURCE: 2000 ford windstar power door locks do not work
The actuactors for your locks have a little motor in them. In this motor there is a resistor that will give out over time. Usually the locks gradually stop working over time. You can remove the actuator and take it apart and fix by removing the resistor in the motor and putting a peice of copper in its place. Takes about 30 minutes per door if you know what you are doing. Do a google search for ford windstar door lock fix and you will find several blogs with detailed descriptions of the repair.
56 views
Usually answered in minutes!
×