Question about 2002 Audi allroad

2 Answers

Service air ride suspension

Front end drops down when i turn the car off and the rear stays up

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Filmmaker:

    Uploaded 5 video answers.

  • Audi Expert
  • 95 Answers

You could easily spend thousands on the air suspension on a 10+ year old car. To get ahead of the game and not worry about those problems again, do a Audi Allroad Air Suspension Conversion for a fraction of the cost of staying with the air suspension.

Posted on May 07, 2015

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Audi Expert
  • 358 Answers

Sounds like the valve body for suspension system or a front air hose leak.

Posted on May 31, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What happens if the air suspension switch is turned off


If nothing is leaking the air suspension will stay in its current position. The switch is primarily used when your vehicle is service on a non drive ion rack. Failure to turn off the air ride before raising the vehicle will cause the air ride to vent. When the vehicle is lowered the rear of the vehicle will be in the fully lowered position.

May 08, 2011 | 2000 Mercury Grand Marquis

1 Answer

My 1995 continental has severe ride problems bounces on every bump in the road front end sits low and rear seems normal


Sounds like the front "air ride suspension" is out.
That works off rubber bags built into the springs. If one or both has developed a leak/hile, it lets the front end (or rear or both) drop to ride on the bottom of the suspension.
Get the wallet out. It's expensive.
Sorry :-(

Jan 09, 2010 | 1995 Lincoln Continental

1 Answer

When speaker is disconnected cars back suspension does not work


thats messed up ,,,the air ride control module is located on the rear deck lid near the speaker,my guess is you got a pinched wires causing the rear speaker to mess up the air ride,because they dont normal have anything to do with each other,,thats my guess,,

Oct 14, 2009 | 1997 Lincoln Town Car

1 Answer

Air-spring suspension 1995 Mark Vlll Lincoln Continental.When car is turned off fornt air-springs stay inflated but sometimes rear air-springs slowly lose air but inflate after ignition switch is turned to...


Save your self the hassle and expence of troubleshooting and replacement parts, install a suspension retrofit kit which changes the rear bags to coil springs and the front to struts. A car this old you might as well start over for less than $500.00......

Sep 20, 2009 | 1995 Lincoln Mark VIII

2 Answers

Front end drops down nom wont raise up . air ride


dose anyone know where the sensor on 03 bmw x5 front suspension are located.

Aug 10, 2009 | 1986 Lincoln Continental

2 Answers

Discovery rear air suspension sitting down overnight


My car did this. I could actually park and feel my car raise up or down. Looking at my car it was sitting completely crooked as if I had hydraulics. lol I have a 2001 Discovery II. When I had it fixed at the dealer it was the rear airbag which is part of the air ride suspansion. I hope this helps.

Jul 13, 2009 | 2001 Land Rover Discovery Series II

2 Answers

VERY LOW REAR END


rear suspension ride leveler mslfunction. Check Air compressor function.

May 27, 2009 | 1992 Lincoln Town Car

5 Answers

Lincoln navigator air suspension is all the way down


that should not happen. Did you turn the switch off in the back for the suspension? Did you do something else at the same time, like check the spare tire for air pressure?

I have info on 2003 navigator 4 wheel air suspension. Maybe similar

SECTION 204-05: Vehicle Dynamic Suspension — 4-Wheel 2003 Expedition/Navigator Workshop Manual
DESCRIPTION AND OPERATION Vehicle Dynamic Suspension The four wheel air suspension system is comprised of the following components:
  • service switch
  • control module
  • two front height sensors
  • one rear height sensor
  • compressor and drier assembly (includes vent solenoid)
  • air lines
  • front and rear air spring and shock absorber assemblies
  • four air spring solenoids
WARNING: The service switch for the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch located in the jack storage area in the rear of the passenger compartment. Failure to do so may result in unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.

WARNING: Do not remove an air spring under any circumstances when there is pressure in the air spring. Do not remove any components supporting an air spring without either exhausting the air or providing support for the air spring to prevent vehicle damage or personal injury.

Air Suspension Pneumatic Diagram 801e0c4.gif
Item Part Number Description 1 5319 Air compressor and drier 2 5B322 Air line T-fitting 3 5B321 Air line union 4 — Air line Y-fitting 5 18945/5311 Air spring and solenoid
------------------------------
Principles of Operation
The 4-wheel air suspension (4WAS) module commands changes in vehicle height that are necessary for both the load leveling and the vertical height adjustment features.
The 4WAS load leveling feature automatically makes adjustments in vehicle height so that the vehicle is always at trim height, and that constant front-to-rear vehicle attitudes are maintained over the load range of the vehicle. Adjustments in height that are necessary to correct height differences between the vehicle left and right sides for the 4WAS system are restricted to what can be reliably achieved with three height sensors.
The height adjustment feature has three vehicle heights within a two-inch span:
Kneel height — improves the ease of entering and exiting by lowering the vehicle one inch below the trim height in the front and rear when the vehicle ignition is in the OFF or LOCK positions and the vehicle is stationary.
Trim height — normal vehicle ride position; vehicle moves to trim position when the ignition is ON, when the transmission is initially shifted to DRIVE or REVERSE mode, when all doors are closed or when speed of more than 24 km/h (15 mph) is detected.
Off-road height — improves ground clearance by raising the vehicle one inch above trim height in the front and rear when the vehicle is at 4x4 low modes and the vehicle speed is less than 40 km/h (25 mph).
The 4WAS module uses the universal bus protocol, (UBP), module communications network for sending and receiving various signals with the exception of speed, information from the three height sensors, and the air suspension service switch. For additional information about UBP, refer to Section 418-00 .
The 4WAS system holds vehicle height when any door or rear hatch is opened. The system stores front and rear vehicle height the moment any door is detected open. The system then maintains this height regardless of the addition or removal of a load. The system returns to its commanded height when all doors are closed or vehicle speed exceeds 24 km/h (15 mph).

-------------------------------
Air Suspension Service Switch
The air suspension service switch signal is needed to wake up the 4WAS module. Without the module receiving this signal, the 4WAS system is inoperative at speeds below 24 km/h (15 mph) and will not react when the vehicle is raised or lowered. At speeds above 24 km/h (15 mph), the system will be active as if the air suspension service switch is in the ON position.
Vehicles without message center When the air suspension service switch is in the OFF position and the ignition switch is in the RUN position, a "CHECK SUSP" will appear in the RH corner of the instrument cluster.
Vehicles with message center When the air suspension service switch is in the OFF position and the ignition switch is in the RUN position, the message center will display "SUSPENSION SWITCHED OFF"
-------------------------------------------
Inspection and Verification
  1. Verify the customer concern.
  1. NOTE: If the door ajar indicator is illuminated when all doors, liftgate, and liftgate glass are closed, the air suspension will not work correctly. Repair door ajar indicator; refer to Section 413-01 .
    Visually inspect for obvious signs of mechanical and electrical damage.


Visual Inspection Chart Mechanical Electrical
  • Restricted suspension movement
  • Excessive vehicle load
  • Cut, severed, crimped air line(s)
  • Unmounted height sensor(s)
  • Damaged front air spring(s)
  • Damaged rear air spring(s)
  • Battery junction box (BJB) fuses 20 (30A), fuse 27 (5A), and fuse 111 (50A)
  • Loose, corroded, or disconnected connectors
  • Air suspension service switch is in the OFF position
  • Damaged solenoid valve(s)

-------------------------
I fthis does not help, the dealer can hook up his diagnostic equipment and download fault codes. Good luck. Please give best rating if this helps.

Apr 20, 2009 | 2004 Lincoln Navigator

2 Answers

Where are the leveling sensors located on a 2003 Navigator?


There is one at each wheel. here is some info

Vehicle Dynamic Suspension The four wheel air suspension system is comprised of the following components:
  • service switch
  • control module
  • two front height sensors
  • one rear height sensor
  • compressor and drier assembly (includes vent solenoid)
  • air lines
  • front and rear air spring and shock absorber assemblies
  • four air spring solenoids
s3j~us~en~file=ani_caut.gif~gen~ref.gif WARNING: The service switch for the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch located in the jack storage area in the rear of the passenger compartment. Failure to do so may result in unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.
s3j~us~en~file=ani_caut.gif~gen~ref.gif WARNING: Do not remove an air spring under any circumstances when there is pressure in the air spring. Do not remove any components supporting an air spring without either exhausting the air or providing support for the air spring to prevent vehicle damage or personal injury.
Air Suspension Pneumatic Diagram 17d59a6.gif
Item Part Number Description 1 5319 Air compressor and drier 2 5B322 Air line T-fitting 3 5B321 Air line union 4 — Air line Y-fitting 5 18945/5311 Air spring and solenoid

Suspension Height Sensor Removal and Installation
NOTE: Front shown, rear similar
  1. s3j~us~en~file=ani_caut.gif~gen~ref.gif WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch located in the LH quarter trim panel. Failure to do so may result in unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.
    Raise and support the vehicle. For additional information, refer to Section 100-02 .
  1. Disconnect the sensor arm. 721ed10.gif
3. Remove the bolts and the sensor. b198e3c.gif
4.
  1. Disconnect the electrical connector.
---------------------------------------------------------------------------------------------

Ride Height Adjustments
Special Tool(s) s3j~us~en~file=st2332a.gif~gen~ref.gif Worldwide Diagnostic System (WDS)
418-F224

New Generation STAR (NGS) Tester
418-F052 or equivalent scan tool
Inflation and Deflation of the Air Suspension System
  1. NOTE: Make sure that the air suspension switch is in the ON position
    NOTE: Make sure that a battery voltage of at least 11 volts is maintained while carrying out this procedure.
    Turn the ignition switch to the ON position.
  1. Connect scan tool to the data link connector (DLC).
  1. Select Air Suspension Control Module under Active Command Mode:
    • VENT FRNT to deflate the front down.
    • LIFT FRNT to inflate the front up.
    • VENT REAR to deflate the rear down.
    • LIFT REAR to inflate the rear up.
Calibration
Ride Height Resetting
  1. NOTE: Make sure that the air suspension switch is in the ON position
    NOTE: Make sure that a battery voltage of at least 11 volts is maintained while carrying out this procedure.
    Turn the ignition to the ON position.
    • Exit the vehicle, close all doors and allow the system to vent the vehicle down to kneel height (approximately 45 seconds).
  1. With the ignition remaining in the ON position, shift the vehicle into DRIVE and then back to PARK.
    • Exit the vehicle, close all doors and allow the vehicle to pump to trim (approximately 45 seconds).
  1. Measure the ride height. For additional information, refer to Section 204-00 .
  1. Open the LF door.
  1. Connect scan tool to the data link connector (DLC).
  1. While outside of the vehicle, select the proper vehicle year, model and engine type.
  1. Select 4WAS module.
  1. Using the active command mode, vent or lift the vehicle to achieve the correct ride height.
  1. Select the "Save Calibration Values (Store Ride Height)" scan tool command to calibrate the 4WAS module.
-------------------------------------------------------------------------------

Jan 09, 2009 | 2003 Lincoln Navigator

Not finding what you are looking for?
2002 Audi allroad Logo

243 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75005 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14195 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...