Question about Cars & Trucks

Open Question

2004 yamaha golf cart

Charged batteries to 100%turn key on push pedal down to go forward then reverse nothing can you help.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 166 Answers

SOURCE: Electric Golf cart only shutters and inches forward

so many possibilities...

does it roll fairly freely? (checking to see if the brakes or rearend seized up)

Are there any "bad" sounds like things grinding? (Connection between Motor and rearend, axle splines...)

If all that is solid, it is likely in the controller.... (it takes a solid charge right... No bad batteries in there or loose connection? might want to check all the battery connections to make sure none are burnt...)

1997.. does it have the electonic speed control by that year? the other possibilty is that the accelerator is not working corectly. they used a resistor system on old ones that has contactors that would get worn out.... Newer ones control a potentiometer(sp) that controlled the speed.

Only a few real components to check, but if you are not mechanically and electically inclined, could be tough to isolate.

peace,

Posted on Mar 07, 2010

  • 34 Answers

SOURCE: 1999 ezgo golf cart.need to know the whole wireing

When you removed the batteries, a certain procedure MUST be followed. Key switch off, switch to tow position and shift lever in reverse. You must wait until the beeper unit sound dies out then remove the wire from the most NEGATIVE cable. Place in Neutral before installing new batteries. There is a specific sequence to putting the batteries in an EZ-GO cart. Failure to follow this procedure will kill the controller. The Key switch must be off and the maintenance/tow switch MUST be in the tow position when connecting the batteries. Any of the above will cause the controller to fail, due to improper discharge of the PRE-Charge capacitors.

Posted on Apr 22, 2010

  • 34 Answers

SOURCE: EZGO golf cart won't go forward

Your batteries have died. The reason it will barely move in reverse is that current is being supplied to the motor is a direction that it spends very little time using. There is a slight change in the armature over time, and reverse tends to work better over time. Check the voltage when under load. (run jumper wires from the + and - of the battery bank. If it is a 36 volt cart and the voltage drops to below 36 volts, you do not have enoug current to run the cart. Plug in the charger and watch the ampmeter. If it goes up to about 20 amps, then it is charging. It should take a good charge after 10 hours. If the cart charges and only runs a short distance, the batteries need replacing.

Posted on Apr 24, 2010

mrtom010
  • 54 Answers

SOURCE: golf cart starting

There is a custom Golf Cart that looks like a Jeep and is considered an electric club car. If you get a chance there is a show called Barter Kings and one of the shows actually shows one. They are not cheap.

Posted on Jul 22, 2012

emissionwiz
  • 75171 Answers

SOURCE: Golf cart will not start

You may have this posted in the wrong product category. Please select another category appropriate to the problem and re-post the problem so the correct expert will see and respond to the question..
This is for car and truck problems.

Posted on Sep 28, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my G16 gas golf cart whines when the accelerator is pressed down but will eventually start after pressing it 4 or 5 times and it seems to help somewhat if I press it at the top which is odd???


yamaha g16 gas golf cart

time for a service and cant be ignored

something not right between pedal and drive wheels
if pedal has to be pressed like that

26215006-wof0kwh1xpwidkmx23mdilgp-4-0.jpg

Jun 08, 2016 | Cars & Trucks

1 Answer

Should the solenoid have increasing voltage across the main terminals, 9.0vdc to 30vdc. Master switch in tow, key switch off.


My answer is I don't know regarding golf carts but generally a designer would arrange for a solenoid to be actuated by as constant a voltage as possible, especially if it is to be engaged for long periods. That is the only method to ensure consistent operation without danger of overheating. This is assuming the available voltage energises the soleniod.
I would expect the voltage across the main terminals would also be expected to be fairly constant so a predictable consistent performance can be provided over a long life.

You really need to consult a repair manual/wiring diagram. As a complete uninitiated golf cart layman I would expect the main solenoid switch to be switching the battery voltage which would then supply the speed and direction control board. I could be worng though!

May 02, 2016 | Cars & Trucks

1 Answer

YAMAHA OLF CART GASOLINE OPERATED CHARGED BATTERY WHENi TURN KEY ON AND TRY TO GO IT WONT MOVE AND A SLIGHT WHINE


Check the starter solenoid, but sounds like the starter is bad. If it is draining the battery when you try to start it, then it is the starter. Check for a bad ground first though. The starte requires a great deal of amperage and a weak ground could be the problem.

Feb 15, 2014 | Cars & Trucks

1 Answer

Golf cart goes forward but will not go into reverse


check the linkages may be loose going forward and reverse.

Dec 23, 2013 | 1993 Acura Vigor

1 Answer

Golf cart starting


There is a custom Golf Cart that looks like a Jeep and is considered an electric club car. If you get a chance there is a show called Barter Kings and one of the shows actually shows one. They are not cheap.

Jul 22, 2012 | Cars & Trucks

2 Answers

EZGO golf cart won't go forward


Your batteries have died. The reason it will barely move in reverse is that current is being supplied to the motor is a direction that it spends very little time using. There is a slight change in the armature over time, and reverse tends to work better over time. Check the voltage when under load. (run jumper wires from the + and - of the battery bank. If it is a 36 volt cart and the voltage drops to below 36 volts, you do not have enoug current to run the cart. Plug in the charger and watch the ampmeter. If it goes up to about 20 amps, then it is charging. It should take a good charge after 10 hours. If the cart charges and only runs a short distance, the batteries need replacing.

Apr 09, 2010 | 1993 Acura Vigor

1 Answer

Electric Golf cart only shutters and inches forward


so many possibilities...

does it roll fairly freely? (checking to see if the brakes or rearend seized up)

Are there any "bad" sounds like things grinding? (Connection between Motor and rearend, axle splines...)

If all that is solid, it is likely in the controller.... (it takes a solid charge right... No bad batteries in there or loose connection? might want to check all the battery connections to make sure none are burnt...)

1997.. does it have the electonic speed control by that year? the other possibilty is that the accelerator is not working corectly. they used a resistor system on old ones that has contactors that would get worn out.... Newer ones control a potentiometer(sp) that controlled the speed.

Only a few real components to check, but if you are not mechanically and electically inclined, could be tough to isolate.

peace,

Mar 07, 2010 | 2006 Scion xB

1 Answer

1999 ezgo golf cart.need to know the whole wireing system for this cart. I put new batterys in and ihave a short somewhere cause know it want do nothing.the reverse beeper want come on nor will the cart...


When you removed the batteries, a certain procedure MUST be followed. Key switch off, switch to tow position and shift lever in reverse. You must wait until the beeper unit sound dies out then remove the wire from the most NEGATIVE cable. Place in Neutral before installing new batteries. There is a specific sequence to putting the batteries in an EZ-GO cart. Failure to follow this procedure will kill the controller. The Key switch must be off and the maintenance/tow switch MUST be in the tow position when connecting the batteries. Any of the above will cause the controller to fail, due to improper discharge of the PRE-Charge capacitors.

Dec 24, 2009 | 2006 AMC CJ7

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...