Question about 2004 Chevrolet Colorado

1 Answer

Fauiler to start.

Truck starts sometime and sometimes wont.after setting for awhile then starts.could be a factor defect.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Replace fuel pump

Posted on Aug 15, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 11 Answers

SOURCE: Sometimes wont start. I know

try the pressure regulator, located under the plenium, on the spider injection

Posted on Aug 14, 2008

Brian032472
  • 150 Answers

SOURCE: 2000 silverado sometimes start, other times not so much

To determine if recognizing park is the issue simply place vehicle in neutral and attempt to start with your foot firmly on the brake. Starter may have a missing tooth or starter solenoid may have an issue. I would also check ground wire to frame and connections at the starter for fraying or loose connection

Posted on Nov 02, 2008

  • 6 Answers

SOURCE: 4wd wont work

You need to get it scanned for codes, if you have a B2725 then you have a 4WD switch problem, otherwise the fault is probably in the transfer case control module.

Posted on Apr 03, 2009

  • 2 Answers

SOURCE: chevrolet colorodo 2004

My 2004 Colorado did this exact thing I thought it was the battery. But it was until some one told me it happened to their GMC also. He said its a the passlock. It is a passive theft-deterrent system.Passlock enables fuel if the ignition lock cylinder is turned with a valid key. He then told me i turned the key to fast and it didn't read it. If a correct key is not used or the ignition lock cylinder is tampered with, the fuel system is disabled and the vehicle will not start.If the engine stalls and the security light flashes, wait about 10 min until the light stops flashing before trying to restart the engin. And remember to release the key from start as soon as it starts.

Posted on Apr 20, 2009

juncro
  • 467 Answers

SOURCE: 96 s10 shuts off dash lights blink and truck dies for seveal minu

check the alternator

Posted on Jul 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2003 pontiac aztec wont start sometimes, if I let it set for awhile it does start


The first thing you need to do is check fuel pressure when it will not start and also check for computer control system fault codes.

May 11, 2017 | Pontiac Cars & Trucks

1 Answer

Gmc jimmy wont start sometimes but lights and buzzer works sometimes if you wiggle the gear shift it will start


should be a p/n safety switch in the steering colom could be loose or shifter is not engaging it

Aug 27, 2012 | GMC Jimmy Cars & Trucks

1 Answer

1999 audi a6 wont crank sometimes


Either there is a bad or dirty battery connection which is allowing the lights but no crank or you could have dirty or loose starter wires or starter relay may be bad or ignition is a possibility. All these can be tested with an ohmmeter for power. I would start with connections

Jun 04, 2012 | Audi A6 Cars & Trucks

1 Answer

1998 Mazda B4000 truck wont start sometimes


When you say it won't start, do you have any power at all, does the radio play? Does it click or make a noise of any kind? Is it a cold non start or a warmed up non start? There are a lot of factors to consider in a non start. I still have an occasional cold non start, with full power to my lights, radio, etc. Don't want to make myself sound dumb, but for me it was gear shift (controller). Not really the safety neutral switch, but put it in neutral or move the gear lever and my car would start right away. Chances are while waiting to let it start up you have hit the handle a few times and maybe knocked into position to let it start. If this isn't your problem more info is needed.

Dec 05, 2011 | 1998 Mazda B-Series

1 Answer

Car sometimes wont start. Nothing. No clicking grinding or any power. Then after awhile it will start just fine I've checked battery connections all clean and tight.


If lights come on and no click at all with the starter, then it might be shifter postition lockout, defective ignition connector behind the key assembly or a bad connection at the starter. Many mechanics know to bang on the starter with a metal rod and someone turning the key to the start position. Some battery positive cables (should be red) are multi connector type so check the positive for corrosion at all the connectors.

Jun 29, 2010 | 1993 Honda Accord

1 Answer

1985 cj7 6cyl starts up just fine and then it wont


Sound like either fuel or ignition. Have you replaced any fuel filters? I would check the condition of the distributor cap and wires as well. Moisture could be a factor.

Oct 08, 2009 | 1985 Jeep CJ7

1 Answer

My 1999 maxima sometimes wont start


possiable defective electric fuel pump.

Sep 16, 2009 | Nissan Maxima Cars & Trucks

Not finding what you are looking for?
2004 Chevrolet Colorado Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...