Question about Cars & Trucks

Open Question

Countax c300h Warning light flashes 25

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuse blows as soon as you incert it into yhe ignition circuit on my C300H countax


You have a short somewhere and you need to trace the wiring. For your diagnosis, use "circuit breaker" fuse which will auto-trip/reset if there is a short or high amp draw. I even replaced some of my fuse with circuit breaker.
http://www.autozone.com/electrical-and-lighting/circuit-breaker?filterByKeyWord=breaker&fromString=search&newYmme=true

Mar 11, 2015 | Cars & Trucks

1 Answer

2002 Sienna Van ABS light flashing and stop when the vehicle at 25 mph.


Whenever this warning or any other stays on in the dash it is indicating that the systems control module has detected a fault, it then disables the system as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Sep 20, 2012 | 2002 Toyota Sienna

2 Answers

I need a wire diagram for a countax c400h


I am sorry but Fixya has no wiring diagrams for any product.

Mar 13, 2012 | Cars & Trucks

1 Answer

The tpms is on


Hi, if you see this TPMS icon illuminated, it means your vehicle has a low tire. STOP, and check the inflation pressure in your tires. This warning light will come on if tire pressure in any of your tires falls more than 25% below the recommended inflation pressure (refer to your owners manual, or the tire inflation decal in the glovebox, driver door pillar or gas tank filler cap lid for tire inflation pressure recommendations).
The TPMS warning light should come on for about one second when the ignition key is first turned on for a bulb check. It should then go out if all of the tires are properly inflated. If it does not go out, or it comes on while driving, you have a low tire.
If the TPMS warning light is flashing, it indicates a fault has been detected in the TPMS system that will require further diagnosis. Common faults include a bad tire pressure sensor, a defective keyless entry receiver module, a fault in the TPMS or body control module (BCM), or wiring problems in the keyless entry/TPMS/BCM circuit.

Jun 25, 2011 | Kia Sedona Cars & Trucks

2 Answers

97 ford escort check engine light flashing uses alot of gas replaced plugs


what engine if a zetec engine then change the O2 sensor

May 06, 2011 | 1999 Ford Escort

2 Answers

Dasboard lights flash and warning beep operates (Seat Leon 2001)


flashing dashboard lights when the ignition is turned off

Dec 01, 2009 | 2001 Volkswagen Golf

2 Answers

5 sets of 5 beeps (chimes?) while first driving


I have same problem. I used to have the SRS (air bag) light flash. But the light does not show anymore (burned out?) and now I get the 25 chimes.

Jul 15, 2009 | 1999 Lincoln Town Car

1 Answer

Air Bag Indicator Light blinks on 1995 Lincoln Town Car


The blinking light is giving you a code and according to what you have listed that would be a code 25. However there is no code 25 for this system are you sure that it is not a 52 instead? If so then this code is for a loss of power to the module. Did you have battery go dead recently? If this is the case then you can clear it yourself. You will have to locate a gray 2 wire connector behind the glove box first. Here are the instructions to clear the code 52.
  1. Cycle the ignition switch to OFF and then to RUN.
  1. Observe air bag indicator prove-out (six ± two seconds) followed by diagnostic trouble code (52-85) flashing completely one time.
  1. Locate the Diagnostic "Trouble Code Clear" Connector located underneath the glove compartment (06010) containing Circuits 631 (T/R) and 57 (BK).
  1. Use a jumper wire to short Circuit 631 (T/R) to Circuit 57 (BK) or to another good ground. This short must be made after the diagnostic trouble code flashes completely one time, but before the warning light stays on continuously.
  1. Hold short until air bag diagnostic monitor tone sounds (approximately five seconds).
  1. Release short on Circuit 631 (T/R) to Circuit 57 (BK). This short must be released within 25 seconds after the diagnostic monitor tone sounds.

Jan 25, 2009 | 1995 Lincoln Town Car

2 Answers

Mini one warning lights


This is the flat tire light. either your tires are low on pressure or the flat tire light button is stuck down. if your tires are low refill to same pressure I usually use 35 psi. then start the car stay parked. depress the flat tire button located either under the ebrake or just to the right of the ebrake. hold for 10 sec. then drive car for 5-10 min do not drive hard. drive on normal roads 25 -35 mph then drive on the highway. If the button is stuck find some kind of electrical cleaner and just keep trying to clean it till it no longer sticks down.

Dec 08, 2008 | 2004 Mini Cooper

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...