Question about Cars & Trucks

1 Answer

Honda hrv Not moving while in Reverse mode. It accelerates but no movement. Thanks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 42,122 Answers

Check fault codes and look for a failed reverse solenoid Have a pressure test done on the box for low pressure or failed band/ clutch packs

Posted on Apr 28, 2013

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75822 Answers

SOURCE: Hi, the cambelt change mileage for honda hrv

the chart shows 90,000 miles

Posted on Mar 19, 2010

Testimonial: "Very quick answer to my problem, helps a lot as I can now plan to change it in the near future reather than worry I had exceeded its working life"

  • 1 Answer

SOURCE: HONDA HRV,1.6/03. WHERE IS THE OIL FILTER

You cannot change the filter unless you have access to a lift or pit. It is located on the back of the engine, recessed above the front axle. I took mine to a friends garage and even with the car raised, it still took a filter wrench on an extension bar to get to it. It is impossible to reach it if all you have is a jack or ramps in the driveway.

Posted on Jul 11, 2010

  • 4 Answers

SOURCE: my car wont move forward or reverse

Chances are is that the torque converter needs to be replaced. However, the transmssion on this vehicle are only serviceable by transmision shops. No regular mechanic will open up the transmission. When the torque converter fails (clutch and plates shutters to small pieces) the debri flows in the transmision thereby potentially destroying the gears and/or clogging the filter and pump. Go straight to a reputable transmission shop and let them correctly diagnose the transmission.

Posted on Jul 26, 2010

  • 14585 Answers

SOURCE: How do you fix a

The 700 is a generic transmission malfuction code. Anything that goes wrong wih the solenoid package will set this code. The other I haven't seen, typo maybe? If it is 703 then it is a brake switch circuit b malfuntion. The 700 will need more diagnostics to find whats exactly wrong with it, or you can replace the entire solenoid package in the transmission. 703 replace the brake switch on the brake pedal. Most solenoid packages come out fairly easy, just messy. Drop the pan,lots of oil, remove the filter,usually just snaps in, some bolt in, About a dozen bolts and remove the solenoid package.

Posted on Apr 19, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi i have a honda hrv 2001 4x4 am losing power when accelerating a need to drop down gears to gain power ?


It sounds like you may have a engine that is losing compression, or there could also be a vacuum leak. Also faulty spark plugs and/or wires can cause a loss of engine power. And the last, but often the easiest to fix, is change the air filter. Check the air filter first.

Oct 11, 2016 | Honda HRV Cars & Trucks

1 Answer

How do i open the interior fusebox in my honda hrv 2000 model. Thankyou.


Kathryn, Not familiar with Honda hrv, did you mean CRV. There will be a small trim door to remove, lower dash by drivers left knee to access interior fuse panel.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Fuse Box layout on 2000 CRV Honda Tech
Interior Fuse Box Location 1997 2001 Honda CR 2000 Honda CR EX 2 0L 4 Cyl
Thread What are these Definitions

Jun 18, 2016 | Honda HRV Cars & Trucks

2 Answers

Honda hrv problems


I have a 1999 Honda HRV I have just replaced the SRS unit and now the RPM when in idle goes up and down causing fuel consumption problems how do I fix this problem have taken to mechanic he mentioned it was due to the gearbox????

Jan 13, 2014 | Cars & Trucks

1 Answer

When starting out from a stop, the car (cvt) shudders for a second or two while the car is accelerating. Is there any friction modifiers that can be added to the trans fluid other than Honda's $15/quart...


it sounds like you have worn engine or transmission mounts. if it was friction from the transmission it would happen anytime you accelerate, not just from a stop. place rubber or wood stops in front and behind the front wheels, pull the e-brake. now have someone hold the brake pedal and start the car. have them put the car in gear and rev the engine, making sure the car doesnt move. while revving the engine, look at the position of the engine and how much it shifts around from its initial position. excessive movement of the engine indicates a worn or loose mount. this will also affect acceleration from a stop. what you are experiencing is the weight of the car catching up with movement of the engine. once they come together, the shuddering stops.

Jan 09, 2011 | 2003 Honda Civic

1 Answer

How do I open the honda hrv boot?


how do i open the boot on hrv cant for the life of me find a button and it wont open with the key

Dec 10, 2010 | 2004 Honda CR-V

1 Answer

My tahoe is vibraiting every time i hit the gas pedal and keep doing it until i took my feed out the gas what do you think


With acceleration vibrations, you should check all your Motor Mounts. Check for rips, tears or worn rubber.
To check the "play" of these mounts:
1. With a partner behind the wheel, vehicle on, in park and them accelerating; and you watching the motor, check to see if the engine is moving (canting) forward, or left or right.
2. Jack-up and properly support the entire vehicle.
Have your partner now place the vehicle in Drive, no brake and accelerate. Check the engine for movement.
3. Have your partner now place the vehicle in Reverse, no brake and accelerate. Check the engine for movement.

Any substantial movement should have the motor mount(s) replaced.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.Com!

Mar 02, 2010 | 1998 Chevrolet Tahoe

1 Answer

When putting it in reverse, the engine actually moves. It moves again when putting it into drive.


The engine in a transverse configuration must have some fore and aft movement,this is normal.If the movement is excessive check the engine and transaxle mounts.

Aug 08, 2009 | 1996 Honda Odyssey

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...