Question about 2000 Chevrolet Impala

3 Answers

No turn over on engine an lights

I have recently put a fuel pump on my 2000 chevy impala it will only start when it wants too it is getting power to everything and battery is holding a charge bu will not turn over no clicking nothing. But when itdoes decide to start it runs beautiful except turn signals wont work and lights dim while acceleration

Posted by on

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Chevrolet Master
  • 260 Answers

I have an 01 impala this happened to. Its really common in gm cars. check this out it will help ya and save you money. its something you can do on your own. if you have questions they have great customer service. Hope everything works out for ya Do It Yourself GM Security bypass

Posted on Apr 19, 2015

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 2,899 Answers

Car won't start?
Try this:

Make sure the positive cable, makes a good connection at the battery and at the starter. Make sure the negative cable makes a good ground connection at the battery and (preferably) at the engine.

  • Check the battery the simple way, like this:
Turn on the headlights, then try to start the car.If the headlights do not dim or go out, then the battery is likely ok.
  • Check the starter and solenoid:
If the wiring looks ok, then look at the starter solenoid for a good connection, and proper voltage at the starter(10 volts minimum while cranking).
If the starter spins and no crank, the problem is most likely the Solenoid's bendix gear is stuck.
Have someone hit (not too hard) the starter while you try to start the car. This usually works by dislodging a stuck bendix gear.
  • Make a simple test of the alternator:
If you can, somehow get the engine running, measure the voltage at the battery. It should be at least 13.6 volts to properly charge the battery.

Posted on Apr 19, 2015

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 5,618 Answers

How about the starter.

Posted on Apr 28, 2013

Testimonial: "I have yet to have it tested I wanted to make sure that is what it could be I can jump the starter by touching the cylanoid with a flat head and it fires perfect"

  • glenn foley Apr 28, 2013

    i am kinda clueless need help desperatly

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Chevy Trailblazer 2003 ran the battery down now wont idle

try changing the air filter ,i had a problem ,at ilde in drive my trailblazer would stall, changed the air filter now it's not stalling and got my power back ,there is a secondary air pump that i have to change ,
not sure were it is ? still not running perfect but it's running better .and my service light is on too.
i got it put on scope ,it's the pump .
not sure if this helps ,but i'm start to run in to problems too,i have a 2004 trailblazer.
i like to do fix things myself ,i hope i can.it's the cost if you know what i mean.

Posted on Dec 18, 2008

GM Elec
  • 1000 Answers

SOURCE: My 2001 Chevy Impala won't start,and engine won't

First things first. Do you have a volt meter to check the battery voltage? What engine do you have?
Let me know.
Regards,

Posted on Feb 21, 2009

robmonroe
  • 67 Answers

SOURCE: 2001 chevy blazer not starting

I had this same problem with my 1997 Blazer, which required a fuel pump replacement as Nitrobike said. The sign to look for is when you get in the Blazer, turn your key forward to the accessory position, but not the start position. You should hear the fuel pump charging. It sounds like a hissing or whirring noise for about 2-3 seconds while it pumps fuel into the lines to prime the engine.

Fuel pump replacement isn't cheap, about $700-$1000.

Posted on Jun 12, 2008

Centaur89
  • 7 Answers

SOURCE: fuel pump 2000 chevy blazer

Check your connections. did you run the fuel pump wiring under the drivers side door sash like GM did?.. if so check for nicks in the wire or bending or cracks.. this happens.. happened to me. check your fuel pressure. 40 dollar part at an auto store. If its below 59 PSI it wont work. And blazers are very intolerable to low fuel pressure. Also try taking the negative post off your battery for a little while and then putting it back on and if you can get it started again drive around (if its safe and running decent) for at least 30 minutes to get your car computer system acclimated to a new functioning part. Did you check the fuel filter?. rule of thumb when a pump goes change the filter its always the last thing people expect because we all jump to catastrophic engine failure at the first no start moment. lol.
Make sure that all your ducks are in get my drift.. Air oxygen fuel thats the mixture you need to check all those vital parts. before pulling your head off.

Posted on Aug 08, 2008

  • 10 Answers

SOURCE: 2000 chevy cavalier wont turn over, lights and radio work

The starter motor on a car takes a lot of energy, you may be able to use the radio but not have enough power for the starter. You also might not be able to start it because the motor's starter or it's relay is bad. So here's what to do:

Check the connections on the battery, try loosening the connections and moving them around a bit, then tighten them down good.

Next go try to start it up again. If it still doesn't respond, turn your headlights on and see if they are still bright. If they are, then I would look into the starter or the starter relay.

The relay is in a box somewhere under your hood, possibly with some motor related fuses. Take the cover off and look at the under side of it. The cover should have a sticker displaying which relays do what. Now look for the air conditioner relay. Check to see if the air conditioner and starter relays have the same number printed or stamped on them. ONLY if the numbers mach, put the air conditioner relay in place of the starter relay, and try to start it again.

If you still get nothing, then it is either a bad starter or wire somewhere. On this car it may be a bit difficult to find and reach, but try to get to the starter on the bottom of the car. You can find pictures online of what it looks like if you are not sure. Play with the wires and knock on the starter with something hard like a rock or hammer. It doesn't take too much to do it, even a firm punch can do it, just don't break it. If this works then the starter is bad and needs serviced or replaced.

If there is still no response after this, there is nothing more you can do unless you are capable of taking things apart and checking the wiring. Good luck!

Posted on Aug 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I put my 04 Chevy impala on a machine to see why it won't start and it said my fuel pump isn't getting any power but my fuel pump relay are good.Could you tell me why my pump isn't getting power.


Is your security light lit on the instrument cluster ? The PCM - engine computer turns it on ! Watch this video on the subject , there testing a Chevy Suburban but it's the same for yours ! What machine did you put your vehicle on ? GM Fuel Pump Relay Testing This is how we do at the dealer !

Aug 26, 2015 | Cars & Trucks

1 Answer

I have 2011 chevy impala when the battery hooked up I turn the key on and the dash has all the lights as soon as I turn the key forward or to the start position it does nothing there is no power to the...


Sounds like a netural saftey switch or a ign switch is located behind where you put the key in.. you have to take off the covers on the steering column to get at it.

Mar 15, 2015 | 2011 Chevrolet Chevrolet Impala

2 Answers

2000 chevy impala


you should have volts with key on at the pump but it only will show 12 volts for a few seconds as the relay will only stay energized when cranking so if you have 12 volts and fuel pump still does not run check the ground if the pump is good and you have a ground and you have 12 volts pump should work make sure the connector on the sending unit is not corroded or burnt

Sep 01, 2014 | 2000 Chevrolet Impala

1 Answer

I just put a fuel pump in my 2000 chevy silverado 2 weeks ago and now it wont run and all the fuel pump will do is click when you turn the key on but it only clicks once?


spray gasoline or carb cleaner into intake. If engine starts, it's a fuel problem. You have a bad (new) fuel pump or relay. Either no power to pump or pump is bad (unlikely but possible).

Mar 05, 2013 | 2000 Chevrolet Silverado

1 Answer

2000 Chevy.Check engine light always on.Very little reserve power


add a can of sea foam found at auto parts stores and clean the air cleaner sensors inside with carb. cleaner spray. Change the air filter if needed

Mar 25, 2010 | 2000 Chevrolet Impala

1 Answer

2000 chevy express 1500 van having starting issues


Start with fuel system. Listen for fuel pump humm at fuel tank No humm check wiring to pump for power. Then check for spark at plugs and wires. Remove wire from coil and hold near engine and see arch when you crank. No arch. Replace ignition Modular inside distributor cap or cap or rotor

Feb 04, 2010 | 2000 Chevrolet Express Cargo

2 Answers

How do i put power steering fluid in my 2000 chevy impala


With engine off power stering pump located on engine. remove cap. cap will have a dip stick attached add "GM" power stering fluid a little at a time. wipe dip stick clean reinsert and remove check by using the high oil line the the marking on the dip stick. do not over fill

Jan 22, 2010 | 2000 Chevrolet Impala

2 Answers

Where ia the powering pump fpr a 2000 chevy impala


if you have a hydraulic power steering pump it is located on the side next to the firewall and serpentine belt. useing a flash light may help.if your steering is electric there is no fluid.the electric motor is under the dash on the drivers side. hope this helps.

Nov 13, 2009 | 2000 Chevrolet Impala

2 Answers

My 2000 Chevy Impala fuel gauge reads empty.


sending unit on fuel pump is bad, the sending unit shorts out gauge will go to empty or full, never read right, turn on switch ,it goes to full or empty, ,check the pump,hope this helps,thanks robert b.

Jun 27, 2009 | 2000 Chevrolet Impala

Not finding what you are looking for?
2000 Chevrolet Impala Logo

176 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...